Low Cost Common Facility Centre (2 Nos.) in project village of Nawada District under DST (SEED) Funded project

Amount

Sub Heading 1

Surface dressing of ground include removle of Vegetation and inequalities not exceeding 15cm depth and disposal of rubbish, lead upto 50m and lift upto1.5m. Total Area = (6.08 m x 4.6m) x 2 = 55.92 m2.

Boring with hydraulic pilling rig with power unit,providing and installating cast- in situ single under reamed pilesof specified diameter and length below pile cap in M-25cement concrete, to carry a safe working load not less than specified,excluding the cost of steel reinforcement but including the cost of boring with bentonite solution and the length of the pile to be embedded in pile cap etc.All complete. (length of pile for payment shall bemeasured upto the bottom of pile cap). Dia of pile-0.3m, Depth=2.43m Total=(6+2) x 2.43= 19.44m x 2 = 38.88

Providing and laying in position specified grade of reinforced concrete, excluding the cost of centring,shuttering, finishing,and reinforcement –al l work upto plinth level 1:1.5:3 (1 cement: 1.5 coarse sand(zone-III)derived from natural source :3 graded stone aggregate 20mm nominal size derived from natural source) Base =0.4cum Tie beam=1.5 cum Total=1.9cum x 2

Reinforced cement concrete M20 work in wall columns etc up to floor five level excluding reinforcement ,shuttering ,all complete job Gr.floor column=1.5cum Band =1.0cum Lintel =0.065cum Total =2.56cum x 2

Reinforcement( TMT C-500) for RCC works including straitening,cutting, bending,binding,placing in position 3.9m³x98kg/cum=~390.02kg-=400kg x 2

Providing &fixing , centering&shuttering for all RCC works with props etc and its removal. Total =62.86>63sqm x 2

Supplying and filling sand under floor,including watering ramming, consolidatingand dressing complete. Total = 21.5cum x2

Dry brick edge flooring in required pattern with of bricks of class designation 7.5 on a bed of 12mm mud mortar including filling joints with Ganga sand with common burnt clay non modular brick Total Area=55.76sqm x 2

Brick work with common burnt clay F.P.S modular brick of class designation 7.5 in foundation and plinth in:Cement mortar 1:4(1 cement : 4 sand ) =14.9cum x2

Half brick masonry with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in superstructure above plinth level up to floor V level. Cement mortar 1:3 (1 cement :3 coarse sand) Total = 9.43 sqm x2

Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+ 0.05 %) total coated thickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns The sheet shall be fixed using self drilling /self tapping screws of size (5.5x 55 mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required. Total area=(3.48m x 5.67m) x2=39.46=~39.5sqm x2

Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete. Hot finished welded type tubes Total weight =270kg x2

12mm cement plaster of mix: 1:6 (1 cement: 6fine sand) Total area=136.75sqm x2

Providing wood work in frames of doors, windows, clerestory windows and other frames, wrought framed and fixed in position with hold fast lugs or with dash fasteners of required dia & length (hold fast lugs or dash fastener shall be paid for separately) Sal wood Total= D+D1+D2=~0.12cum x2

Providing and fixing angle iron frames for doors, windows and ventilators of mild steel Angle sections of size 35x35x5 mm, joints mitred and welded by angle iron 35x35x5 mm or 35x 5 mm flat pieces to the existing T-iron frame or to the wall with dash fastener, including fixing of necessary butt hinges and screws and applying a priming coat of approved steel primer, all complete as per the direction of Engineer-In-charge. Total= W+V=266=kg x 2

Providing and fixing panelled or panelled and glazed shutters for doors, windows and clerestory windows, fixing with butt hinges of required size with necessary screws, excluding panelling which will be paid for separately, all complete as per direction of Engineer-in-charge. (Note:- Butt hinges and necessary screws shall be paid separately) 30 mm thick shutters Total Area= D+D1+D2=6.18=~6.2sqm x2

Providing and fixing water closet squatting pan(India type W.C pan)with 100mm sand cast iron P or S trap, 10 litre low level white P.V.C flushing Cistern, including flush pipe with manually controlled device( handle lever) confirming to IS:7231, with al l fittings and fixture complete, including cutting and making good the walls and floors wherever required White vitroues china Orrisa pattern W.C pan of size 580x440mm with integral type foot rest

Supplying and fixing in position a readymade R.C.C hollow pipe, dia-0.76m, length-1.52 with a manhole outlet and inlet, as septic tank with a small soakpit with all connection fittings, complete job

Providing and fixing precoated galvanised steel sheet roofing accessories 0.50 mm (+0.05 %) total coated thickness, Zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns using self drilling/ self tapping screws complete Ridges plain (500 - 600mm)Total Length=5.65m x2

Colour washing such as green, blue, buff to give an even shade New work (two or more coats) with a base coat of white washing with lime Total Area =261sqm x 2

Cement concrete flooring 1:2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate) finished with a floating coat of neat cement, including cement slurry, but excluding the cost of nosing of steps etc. complete. 40 mm thick with 20 mm nominal size stone aggregate Total Area =28sqm x2

Goods and Service Tax @ 18%

SUBODH KUMAR (BID ID -3131483)

Bharat Ratan Pandey (BID ID -3132659)