Replacement of Rolling Shutter (Welding Section) of Mechanical and Hospital Division Anantnag.

Supplying and fixing rolling shutters of approved make, makde of required size M.S. laths, interlocked together through their entire length and jointed together at the end by end locks, mounted oin specially designed pipe shaft with brackets, side guides and arrangements for inside and outside locking with push and pull operation complete, including the cost of providing and fixing necessary 27.5 cm long wire springs mu=anufactured from high tensile steel wire of adequate strength confirming to IS:4454 part-1 and M.S. top cover of required thickness for rolling shutters 80x1.20 mm MS. Laths with 1.20 mm thick top cover

Providing and fixing ball bearing for rolling shutters

Extra for providing mechanical device chain crank operation for operating rolling shuters. Exceeding 16.80 sqm in area

Painting steel work with deluxe multi surface paint of required shade to give an even shade. Two or more coats applied @ 0.90litre/10sqm over an under coat of primer applied @ 0.80litre/10sqm of approved brand and manufacture

Dimantling and shifting (to Div. Stores) of old damaged roller shutter of welding section by manual/mechanical means.