Road Studs RPM with shank

Reflective Raised Pavement Markers (Cat Eye/Road Stud) RPM with shank Supply and fixing of raised pavement marker with Made of Plastic body of RPM/ Road Stud shall be moulded from ASA (Acrylic Styrene Acrylonitrite) or HIPS (High-impact Polystyrene) or Acrylonitrite Butadiene Styrene (ABS) or shall Any other suitable material approved by the Engineer. The Marker shal support t a a load of 13,635 5 kg kg tested tested in in accordance with ASTM D4280. The of number of lenses single or dual Reflective panels shall consist of number of lenses containing single or prismatic cubes capable of providing total internal reflection of the light entering the lens face. Lenses shall be moulded of methyl methecrylate conforming to ASTM D788 of equivalent The slon or retro-reflecting surface onforming to ASTM D788 of equivalent. The slop or retro-reflecting surtace shall preferably be 35+1-5 degree to base and the area of each retro -reflecting surface shall not be less than 13.00 sq.cm. sq.cm. the the marker marker height shall not be less than 10 mm and shall not exceed 20 mm & Width shall not exceed 130 130 mm. |The base of the marker shall be flat within 1.3 mm all road studs shall be legibly marked with the name, trade or other means of identification of the manufacture. epoxy installations, excess adhesive around the edge of the marker, excess adhesive on the pavement and adhesive on the exposed surfaces of the markers shall be immediately removed. The contractor shall submit a two year warranty for satisfactory field performance including stipulated retro-reflectance of the reflecting panel, to the Engineer. In addition, a two year warranty for satisfactory infield performance of the finished road marker shall also be given by the contractor who carries out the marker shall also be given the contractor who out the work of fixing of reflective road markers. In case the markers are displaced, damaged get worn out or lose their reflectivity compared to stipulated to standards, the contractor would be required to replace all such markers cost rate within 15 days of the intimation from the Engineer, at his own cost. The rate shall include all materials, materials, labour, labour, T&P, transportation, installation incidentals all complete as as per per direction of the Engineer-in-Ch Engineer-in-Charge.