PAHARHATI CIVIL WORK

Cleaning compound premises of shrubs,plants,jungles etc by cutting and removing as directed(specific permission of Engineer-in-Charge prior to execution will be necessary) (payment to be made on area cleared)

Earth work in excavation of foundation trenches or drains, in all sorts of soil (including mixed soil but excluding laterite or sandstone) including removing, spreading or stacking the spoils within a lead of 75 m. as directed. The item includes necessary trimming the sides of trenches, levelling, dressing and ramming the bottom, bailing out water as required complete. (a) Depth of excavation not exceeding 1,500 mm

(b) Depth of excavation for additional depth beyond 1,500 mm. and upto 3,000 mm. but not requiring shoring

Earth work in filling in foundation trenches or plinth with good earth in layers not exceeding 150 mm including watering and ramming etc layer by layer complete (Payment to be made on the basis of measurement of finished quantity of work) i)With earth obtained from exavation of foundation.

Brick work with 1st class bricks in cement mortar (1:6) (a) In foundation and plinth

125 mm Thick brick work with 1st class bricks in cement mortar (1:4) in Gr. floor

Plaster ( to wall, floor, ceiling etc.) with sans and cement mortar including rounding off or chamfering corners as directed and racking out joints including throating, nosing and drip course, scaffolding/ staging where necessary. (i)with 1:6 cement mortar 15 mm thick plaster in ground floor

20mm. thick ( Gr. Floor)

Neat cement punning about 1.5 mm. in wall dado window sills drain etc.

Dismantling all types of masonry excepting cement concrete plain or reinforced. Stacking serviceable materials at site and removing rubbish as directed within a lead of 75 m. (a) In ground floor including roof.

Dismantling all types of plain cement concrete works, stacking serviceable materials at site and removing rubbish as directed within a lead of 75 m. In groung floor including roof.

Dismantling R.C. floor, roof, beams etc. including cutting rods and removing rubbish as directed within a lead of 75 m. including stacking of steel bars. In ground floor including roof.

Single Brick Flat Soling of picked jhama bricks including ramming and dressing bed to proper level and filling joints with local sand.

Ordinary Cement concrete (mix 1:2:4) with graded stone chips (20 mm nominal size) excluding shuttering and reinforcement,if any, in ground floor as per relevant IS codes a) Pakur Variety

Filling in foundation or plinth by fine sand in layers not exceeding 150 mm as directed and consolidating the same by thorough saturation with water, ramming complete including the cost of supply of sand. (payment to be made on measurement of finished quantity)

Ordinary Cement concrete (mix 1:1.5:3) with graded stone chips (20 mm nominal size) excluding shuttering and reinforcement if any, in ground floor as per relevant IS codes (i) Pakur Variety

Hire and labour charges for shuttering with centering and necessary staging upto 4 m using approved stout props and thick hard wood planks of approved thickness with required bracing for concrete slabs, beams and columns, lintels curved or straight including fitting, fixing and striking out after completion of works (upto roof of ground floor) (a) 25 mm to 30 mm thick wooden shuttering as per decision & direction of Engineer-In-Charge

(b)25 mm to 30mm shuttering without staging in foundation

(c) Steel shuttering or 9 to 12 mm thick approved quality ply board shuttering in any concrete work

Reinforcement for reinforced concrete work in all sorts of structures including distribution bars, stirrups, binders etc initial straightening and removal of loose rust (if necessary), cutting to requisite length, hooking and bending to correct shape, placing in proper position and binding with 16 gauge black annealed wire at every intersection, complete as per drawing and direction. I. SAIL/ TATA/RINL

Supplying and laying polythin sheet (150gm/sqm)over damp proof course or below flooring and roof terracing or in foundation or in foundation trench

SUPPLYING STACKING & SPREADING OF APPROVAL quality crushed stone at site of 26.5mm size completely free form weathered and dead materials (frompakur variety stone aggregates as specified )as per direction of engg incharge including watering levelling ,dressing,complete in all respect

60 mm thick interlocking designer concrete paver block M35 grade for light-traffic zone,commercial & office complex,tourist resort as per IS: 15658-2006 (over 20-40 mm medium sand bed on 250mm thk WBM/ WMM base course & 250 mm thk bound gnaular /granular sub-base course including cost of sand for sand bed but excluding cost of base ,sub-base course & subgrade preparation.) i) Coloured Decorative

Supplying& laying 20 mm designer chequered tiles of any shade and of approved quality as per IS: 1237: 1980 laid in patterns as directed in pavement, footpath including necessary underlay 25 mm thick average cement mortar (1:3) complete in all respect with all labour and materials [using cement slurry @ 4.4 kg/Sq.m at back side of tiles. Cement of mortar & slurry will be supplied by the Department. Border concrete if necessary to be paid separately].

M.S. works in brackets made from flats, angles, tees etc. to sizes specialy bent, twisted, forged; making holes drilled and fitted to rafter of trusses with necessary bolts, nuts, washer or screws etc. (length of straight not less than 230 mm)

Supplying galvanised straining bolts (with eye at one end with double nuts and washers) fitted and fixed complete. 12 mm. dia. 250mm long

Supplying galvanised staples fitted and fixed complete. 44 mm. to 50 mm. size

Supplying, fitting galvanised 3 ply 12 gauge / 4 points line of barbed wire in fencing (holes already made in the body of the post) or fixed by staples tightening and fixing the wires in taut condition with straining bolts including the cost of cutting and of lapping joints in the wire as necessary but excluding the cost of galvanised staples,straining bolt and binding wire where necessary.

M.S.or.WI Ornamental grill of approved design joints continuously welded with m.s w.i flats and bars of windows railling etc.fitted nad fixed with necessary screws and lugs in ground floor.(i) grill weighing above 10kg/sq.m and upto 16kg/sq.mtr

Scraping of moss, blisters etc.thoroughly from exterior surface of walls necessitating the use of scraper, wire brush etc.(Payment against this item will be made only when this has been done on the specific direction of the Engineer-in-charge)

Stripping off worn out plaster and raking out joints of walls,ceillings etc.upto any height and in any floor including removing rubbish within a lead of 75m as directed.

Rendering the Surface of walls and ceiling with White Cement base Water Proof wall putty of approved make & brand.(1.5 mm thick).

Priming one coat on steel or other metal surface with synthetic oil bound primer of approved quality, including smoothening surface by sand papering etc

Painting with best quality synthetic enamel paint of approved make and brand including smoothening surface by sand papering etc. including using of approved putty etc. on the surface if necessary. On steel or other metal surface with super gloss (hi-gloss) 2 coats (with any shade except white)

Applying acrylic emulsion paint of approved make and brand on walls and ceiling including sand papering in intermediate coats including putty (two coats) Luxury quality

Protective and decorative acrylic exterior emulsion paint of approved quality as per manufacturer`s specification and as per direction of EIC to be applied over acrylic primer as required. the rate includes cost of material, labour, scaffolding and all incidental charges but excluding the cost of primer (G.Fl 2 coats) normal acrylic emulsionprimer 100% acrylic exterior emulsion paint of approved quality as per manufacturer’s specification. i)In ground floor

Supplying, fitting and fixing 1st quality ceramic tiles in walls and floors to match with the existing work and 4 nos of key stones(10mm.) fixed with araldite at the back of each tile & finishing the joints with white cement mixed with colouring oxide if required to match the colour of tiles including roughening of concrete surface, if necessary or by synthetic adhesive & grout materials etc . with sand cement mortar (1:4) 20 20mm thick 2 mm thick cement slurry at back side of tiles using cement @ 2.91 kg/sqm & joint filling using white cement slurry @ .20 kg/sqm area of each tile upto 0.09 sqm coloured decorative (wall)

Supplying best Indian sheet glass panes set in putty and fitted and fixed with nails and putty complete. (In all floors for internal wall & upto 6 m height for external wall) (i) 3 mm thick (weighing 7.4 kg/Sq.m)

Supplying best Indian sheet glass panes set in putty and fitted and fixed with nails and putty complete. (In all floors for internal wall & upto 6 m height for external wall) (ii)4 mm thick

Supplying, fitting and fixing UPVC pipes A-type and fittings conforming to IS : 13592-1992 with all necessary clamps, nails, including making holes in wall, floor etc. cutting trenches in any soil, thorough masonry concrete structure etc. UPVC pipes. A)UPVC pipes-110mm.dia

B)plain tee-110mm. Dia

C)plain y-110. dia

D)bend 87.5 degree-110mm. Dia

E)shoe-110mm. Dia

Please Enable Macros to View BoQ information