Proposed Construction of Food Distribution Center at West Jones road ,142 division office campus in Division-142, Unit-30, Zone-10

Earth work excavation for foundation by Mechanica...2.40m Footing Depth. (including Refilling charges)

Providing and laying in position, standardised con...the Department for the excess usage of materials).

Cement Concrete 1:3:6 (One Cement, Three crushed s...artmental officers. - Mixing by mechanical means

Brick work in following Cement Mortar using best q...Executive Engineer in charge. In Cement Morter 1:3

Plastering the surface of walls with Cement Mortar...d as directed by the departmental officers. (Wall)

White washing two coats with freshly burnt white s...lying with standard specification and as directed.

Painting the wall two coats with approved weather ...tion and as directed by the departmental officers.

Supplying and fixing Mild Steel grills for windows...ions and as directed by the departmental officers.

Manufacturing supplying and fixing of Fully ...tal officers. - Single leaf of size 1.00m x 2.10m.

Providing and Fixing of polyurethane foam for Slop...specification. - 50mm (+38mm) thick PUF roof panel

Providing and Fixing of polyurethane foam as Inter...on. - 50mm thick PUF Internal Partition wall panel

Supplying, laying and jointing PVC pipes (having w...ove ground level. For laying PVC pipes of dia 25mm

Supplying, laying and jointing PVC pipes (having w...ove ground level. For laying PVC pipes of dia 20mm

Supplying and fixing in position 15mm dia b...Executive Engineer before use on the works) SD Tap

Supplying and fixing position CI Nahani Trap / Flo...p of size 100 x 75mm with stainless steel gratings

Brass Isolation Valve suitable for the coppe...7396 / 1987 Sepecification. - 28mm Isolation Valve

Brass Isolation Valve suitable for the coppe...7396 / 1987 Sepecification. - 42mm Isolation Valve

Brass Isolation Valve suitable for the coppe...7396 / 1987 Sepecification. - 22mm Isolation Valve

Cost of supply of 20w 4 feet LED fitting with LED tube complete set (Patty and LED tube)

A.C Exhaust Fan 375mm (15") sweep (Heavy duty)

Painting new iron works such as steel doors...ed by the Executive Engineer before use on works.)

Supply and fixing of 1200mm (48") sweep AC ...with side plates and cross arm of size 450mm (18")

Supply and fixing of 5A / 15A 3 pin combined flush...cket with 15A flush type switch on suitable TW Box

Automatic Electrical Water Heater with copper cont... 35 Litres capacity 230V / 1000W (Higher End)

Supplying and erecting in position of following li...tall the System in position and intact - 50 Litres

Pre-Painted Galvanized Iron Two Track Sliding Wind...ted 80mm long screws into the caps through frames.

Dismantling - Floor finish & dadooing walls i...Tiles / Glazed Tiles / Clay Tiles / Cuddapah Slabs

Dismantling - Brick / Stone in Clay Walls, add for... 3m or part there of over the initial height of 3m

Paving the floor with best quality vitrified Til...pproved by Executive Engineer before use on works)

Wiring with 2 x 1.5 sq.mm. PVC insulated SC unshe...light point / fan point (for electronic regulator)

Supply and run of 2 of 1.5 sq.mm. PVC insulated S... copper wire with painting of suitable colour

Painting Old Plastered Wall Surface with Two finis...ed by the Executive Engineer before use on works.)

Supplying and erecting in position LIGHT DUTY STEEL TRUSSES as per the drawing. The materials and design of the trusses should confirm to the relevant Indian Standard specification. The trusses shall be procured only from reputed manufactures of trusses with prior approval of the Buildings Engineer and a certificate to the effect from the reputed manufacturers shall also be furnished with design. The rate quoted shall include the cost of trusses. Base plate with holding down bolts and nuts to RCC or Masonry works, roof purlins, rafters, purlin sleeves, the members fixing accessories etc., painting one coat of red-oxide paint and erecting in position etc., complete as directed during execution. The contractor shall also arrange to provide grouting for holding down bolts embeding the end purlins, to the gable wall wherever necessary etc., The roof sheeting shall project 0.762m from the eves purlins. For structures like CYCLE STAND, PARKING

Providing and fixing Stainless Steel Dishwasher Inlet Table Capacity: 600 Kg/hr (1200x700x960mm) (Including all charges etc.)

Providing and Fixing Stainless Steel Round Standing Dining Table (Including all charges etc.)

Providing and Fixing Canteen Stainless Steel Dining Table (96" x 34" ) (Including all charges etc.)

Providing and Fixing Food Distribution Table (6 x4 ) (Including all charges etc.)

Providing and Fixing Stainless Steel Rack(Including all charges etc.)

Providing and Fixing Stainless Steel Sitting Bench (dia 1 6 ) (Including all charges etc.)

Supplying and Fixing Name Board (Including all charges etc.)

Please Enable Macros to View BoQ information