Renovation in Office Building of National Bank for Agriculture and Rural Development NABARD, Block No. 32 in SDA Complex, Kasumpti, Shimla 9 and 43 Nos Staff Quarters at New Shimla and Vikasnagar, Shimla including Internal Water Supply and Sanitary

Clearing jungle including uprooting of rank vegetation, grass, brush wood, trees and saplings of girth upto 30 cm measured at a height of 1 m above ground level and removal of rubbish upto adistance of 50 m out side the periphery of the area cleared including carriage of material inall leads and lifts.

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering including carriage of material inall leads and lifts.1:3:6 (1 Cement : 3 coarse sand) : 6 graded stone aggregate 20 mm nominal size) All work up to plinth level

Stone soling properely hand packed filling interstics with spalls and consolidating with power road roller to the requested gradient and camber including spreading watering and rolling of binding materials moorum or earth etc. complete as per HP.PWD specification. 100mm spread thickness (finished work including materials and labour), complete in all respect of as per entire satisfaction of the Engineer in charge including carriage of material inall leads and lifts.

Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in superstructure above plinth level up to floor V level in all shapes and sizes including carriage of material in all leads and lifts. Cement mortar 1: (1 cement : 6 coarse sand)

Half brick masonry with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in superstructure above plinth level up to all floor level including carriage of material in all leads and lifts. Cement mortar 1:4 (1 cement : 4 coarse sand)

Providing wood work in frames of doors, windows, clerestory windows and other frames, wrought framed and fixed inpositionwithhold fast lugsor withdash fastenersof requireddia& length including hold fast lugsor dash fastener including carriage of material in all leads and lifts. Second class teak wood

Providing and fixing panelled or panelled and glazed shutters for doors, windows and clerestory windows, including ISI marked M.S. pressed butt hinges bright finished of required size with necessary screws, all complete as per direction of Engineer-in-charge. including Butt hinges and necessary screws including carriage of material in all leads and lifts. Second class teak wood 40 mm thick shutters

Providing and fixing ISI marked flush door shutters conforming to IS:2202 (Part I) non-decorative type, core of block board construction with frame of 1st class hard wood and well matched commercial 3 ply veneering with vertical grains or cross bands and face veneers on both faces of shutters including carriage of material in all leads and lifts. 40 mm thick including ISI marked StainlessSteel butt hinges with necessary screws

Providing and fixing wire gauge shutters using galvanized M.S. wire gauge of average width of aperture 1.4 mm in both directions with wire of dia 0.63 mm, for doors, windows and clerestory windows with hinges and necessary screws including carriage of material in all leads and lifts. 40 mm thick shutters with ISI marked M.S. pressed butt hinges bright finished of required size Second class teak wood

Filling the gap in between aluminium frame & adjacent RCC/ Brick/ Stone work by providing weather silicon sealant over backer rod of approved quality as per architectural drawings and direction of Engineer-in charge complete including carriage of material in all leads and lifts. Upto 5mm depth and 5 mm width