CA NO CWE/PM/SP-10/2020-21

Amount

Taking down carefully the existing point wiring of any size/capacity and type by disconnecting from the terminals complete including fittings and fixtures such as switches, sockets, ceiling rose, regulators and light fittings etc by unscrewing and removing from site complete, all as specified and directed by Engineer-in-Charge. Note :- Cost of unserviceable materials will be charged from the contractor against schedule of credit.

M&L for point wiring with 1.5 Sqmm (Nominal Area) PVC insulated unsheathed multi stranded copper conductor, FRLS 1100 Volts grade, with non metalic rigid PVC medium grade duty conduit but not less than 20mm dia with accessories concealed in wall/ceiling including such as junction boxes, bends, tees etc of suitable size including sunk cast iron or pressed steel terminal box for mounting switches, sockets fan regulators etc with 3 mm thick plastic laminated sheet top cover make : Hylem/Anchor including continuous earth wire PVC insulated 1.50 Sqmm multi stranded copper conductor, FRLS 1100 volts grade, connecting to common earth and earth dolly complete, all as specified and directed by Engineer-in-Charge for the following :- (a) One light/bell/fan point controlled by switch one way. Note :- Cost for cutting, chasing and making good disturbed surfaces all as to match with existing surface are deemed to be included in quoted rate.

(b) All as per item No 2.00 here-in-before but in stove enamelled steel conduit for flame proof lighting.

S&F switch piano, flush button, single pole, one way, 5 Amps, 240 Volts complete, all as specified and directed by Engineer-in-Charge.

S&F ceiling rose surface type bakelite 65mm x 50mm with three terminals with ISI mark complete, all as specified and directed by Engineer-in-Charge.

S&F in replacement LED light fitting, 1 x 34/36 W, 230 V, 2 x 2 recessed mounted environmental friendly, new generation, aesthetically designed, ultra modern recess mounting luminaire with high brightness SMD LEDs as light source, suitable for Armstrong/Grid ceiling general purpose, square shaped, luminaire with high transmitivity diffuser suitable for office application with profiled & flat diffuser fitted on ceiling connecting up with twin core twisted flexible copper conductor cable with suitable size complete, all as specified and directed by Engineer-in-Charge. Make : Cat Part No PLUTONEO2X2PLR34WLED840S of Havells/Wipro/Philips. Note : Contractor shall provide clip type LED light fitting, in case clip is not available with fitting this shall be provded separately without claiming extra cost and in case of any damage occurs in POP/False ceiling/Gypsum board, contractor shall repair and make good disturbed surface without claiming extra cost from department and if required cutting/drilling/clamps/screws etc shall also included in quoted rate.

S&F in replacement of LED wall light fitting, 1x20 watt, 230 Volts, surface and wall mounted LED batten, elegant dia cast aluminium batten for designer homes bright LED source with uniform light out put, 2400 lm, surge protection of 2 KV with wide voltage protection 160-360 Volt in provided for efficeint heat dissipation with polycarbonate diffuser & integrated electronic driver & connecting up with twin core twisted flexible copper conductor cable with suitable size complete, all as specified and directed by Engineer-in-Charge. Make : Cat Part No LUMILINEPLUSBS20WLED865SPCSS of Havells/Wipro/Philips.

S&F in replacement of LED bulb 12 watt thread type 2700K complete, all as specified and directed by Engineer-in-Charge. Make : Wipro/Philips/CG.

S&F in replacement of LED CMRI certified flame proof fixture FLP-WP made of aluminium alloy LM8, 1 x20 W, 240 V, IP-65, Group IIA, IIB, holders, connector block etc complete with all accessories internally pre-wired and including connecting cable with suitable size complete, all as specified and directed by Engineer-in-Charge. Make : Cat Part No EXTN1LT8-16/20 FIAMMA II of Crompton or equivalent in Bajaj/Sudheer/C&S/Sham Switch Gears.

S&F in replacement of switch flame proof rotary type with termination box in LM6, 16 Amps, single pole, 250 volts complete, all as specified and directed by Engineer-in-Charge. Make : Bajaj/Sudhir/CG/FCG.

M/s KUNDU CONSTRUCTION

M/S MG GROUP

M/s Dhapola Elevator and Engineering

Leo Air and Power Solution pvt Ltd.

TUSHAR ASSOCIATES

V.K. Enterprises