Supply, installation, commissioning of CCTV network cameras with all concomitant accessories including required power cable and network cable layout, cable re- routing at Electric loco shed Santragachi old shed, premises of the office of AMM/ELS/SRC and Augmented new shed of ELS Santragachi, as per Annexure 'A' and Annexure 'B' attached.

Bulk order will be placed on the vendor h a v i n g proven performance for Same (WITH SAME/EQUIVALENT/DRAWING/ SPECIFICATION) item. Para No. 2.6 of GCC attached may be referred to, for full details. Bidders are advised to read it carefully before bidding.

The successful bidder should provide 1 year free warranty service after installation. This clause is inherently included in the installation, fitting and adjustment charges. No payment will be done separately for this purpose.

Warranty of all items will start after the date of installation. Original invoices of all fitted items are to be submitted to the consignee and standard warranty clause of all the items shall apply.

Wire Clamp, Wiring Equipments, Sockets, screws, casings, insulation tape, RJ-45 Connectors, Power Cables, HDMI Cables, wall brackets, fixing accessories, Switch Board, Switches, wireless mouse for monitoring and any other components required for smooth execution of the subject work is already included in the Installation and Wiring Charges. Bidders are advised to visit the locations for getting the correct requirement of sub accessories before bidding in the tender. No extra payment will be entertained in future.

The firm will have to install the Cameras, NVRs, Monitor and other components at specific area as instructed by the nominated representatives of Sr.DEE/TRS/SRC in each location.

The camera dome/bullet will be as per the specific requirement at each location. A tentative location plan for installation of the cameras has been attached as Annexure B. However the locations shown in the diagrams may change as per decision of the consignee.

After Installation of the components the firm is required to configure the same so that the system is connected to internet and can be accessed remotely and are advised to provide necessary guidelines like admin id, password, downloading of recordings, accessing the same through Mobile apps/Computer etc to the respective railway representatives.

Bidders should provide remarks against each material mentioned in the Table. If any deviation from the required materials and/or terms/conditions as asked, bidder should mention in the bidding process. All the deviations will be scrutinized during technical suitability checks.

The bidder should submit the rate for CAMC for 3 years along with the bid for the entire work which may be considered in future if required.

THE BIDDER AGREES TO SUPPLY THE TENDERED STORES AT THE RATES QUOTED BY HIM IN ACCORDANCE WITH THE IRS CONDITIONS OF CONTRACT AND /OR SPECIAL CONDITIONS AND /OR OTHER CONDITIONS SPECIFIED/ ATTACHED WITH THE TENDER. PLEASE CONFIRM IF YOU ARE AN MSME FIRM FOR TENDERED ITEM ATTACHED RELAVENT DOCUMENT FOR THE SAME. TENDERER MUST QUOTE FOR TENDER QUANTITY. OFFER RECEIVED FOR PART QUANTITY WILL SUMMARILY BE IGNORED. WARRANTY CLAUSE/GUARANTTEE CLAUSE AS PER IRS TERMS AND CONDITIONS.

i) Tenderers are hereby instructed to supply the tendered quantity to the respective consignee(s) as indicated in tender document. ii) If a Tenderers mentions anywhere in its offer contrary to as above and/or mentions not to supply to some of the consignees, such offer will not be considered for ordering for such consignees where the Tenderer has not agreed to directly deliver the stores and shall be rejected for such consignees.

The evaluation of total unit rate (TUR) for the purpose of inter-se position will be on Total Unit Rate for deliveries up to destination.

Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.

Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.