Loading…
Loading…
| # | Company | Amount | Status |
|---|---|---|---|
| 1 | ₹56.3 Laccepted-aoc | accepted-aoc |
Tender Value
₹56.3 L
EMD Value
₹56,310
Closing Date
24 Feb 2026, 10:40 pmClosed
Rural Development and Panchayat Raj Department
Vinutha
Installation of High mast Light at Belur constituency Backward and other villages and Construction of 12 Bus stand at Belur constituency villages and Construction of 10 Auto stand at Belur constituency villages.
RDPR/2025-26/BD/WORK_INDENT24786
RDPR/2025-26/BD/WORK_INDENT24786
Reserved
Buildings
Two Tender Document System(Two Cover)
RDPR Division Office Hassan
6 documents required · 5 mandatory · 1 optional
TENDERER SHALL OBTAIN THE WORK DONE CERTIFICATE OF ANY NATURE OF WORK 25 PERCENT OF THE AMOUNT PUT TO TENDER OF RS 14.08 LAKHS EXCLUDING GST FROM LAST FIVE YEARS FROM 2020-21 TO 2024-25 IN THE PRESCRIBED FORMAT SECTION 3.1.3 KW3 FROM THE COMPETENT AUTHORITY NOT BELOW THE RANK OF EXECUTIVE ENGINEER OR DISTRICT LEVEL OFFICER ALONG WITH THE INDENT NUMBER or AGREEMENT or WORKORDER COPY AND SCAN THE ORIGINAL CERTIFICATED AND ATTACH THE SCANNED FILE TO THE TENDER.THE ORIGINAL CERTIFICATE SHALL BE PRODUCED AT THE TIME OF OPENING OF TENDERS.
THE TENDERER SHOULD SUBMIT THE REGISTRATION CERTIFICATE ALONG WITH THE APPLICATION. (SHOULD BE ENROLLED AND RENEWED IN KPWD AS CLASS 3 & ABOVE CONTRACTOR ONLY)
VALID CATEGORY-2A CASTE CERTIFICATE
VALID GST CERTIFICATE,ADHAR CARD AND PAN CARD
The tenderer must have achieved in at least ONE financial years in the last five financial years 2020-21 to 2024-25 an average Annual financial turnover of Rs.56.31 Lakhs. Certificate should be in the prescribed form as in section 3: 1.2 of K/W-3 (TURNOVER CERTIFICATE CERTIFIED BY CHARTERED ACCOUNTANTE With UDIN NUMBER ALONG WITH PROFIT AND LOSS STATEMENT WITH IT RETURNS)
₹1,410
₹56,310
24 Feb 2026
17 Feb 2026
25 Feb 2026
23 Feb 2026
Installation of High mast Light at Belur constituency Backward and other villages and Construction of 12 Bus stand at Belur constituency villages and Construction of 10 Auto stand at Belur constituency villages.
Earth work excavation by manual means for drains,canals, waste weir, draft, approach channels, key trenches, foundation of bridges and such simillar works in all kinds of soils , as per drawing and te...
Providing and laying in position plain cement concrete for levelling course for all works in foundation. The graniteortraporbasalt crushed graded coarse aggregates and fine aggregates as per relevant ...
Providing and laying in position Reinforced cement concrete for all Foundation works. The graniteortraporbasalt crushed graded coarse aggregates and fine aggregates as per relevant IS Codes machine mi...
Supplying, fitting and placing TMT FE 550 or 550D Steel Reinforcement including cost of all materials, machinery, labour, cleaning, straightening, cutting, bending, hooking, lapingorwelding joints, ty...
Fabricating, supplying and erection of . ms long hot dip Galvanized Conical hot dip Pole with BSEN 10025 grade S 355 JO steel plate for shaft, IS 2062 for base plate with door opening arrangements, in...
Supplying, and fixing of Hot dip Galvanized M.S.Bracket suitable for out door luminaries and mounted on Octagonal pole using necessary bolts, nuts etc., complete.Double Arm Bracket with 2000 mm Standa...
Supplying and fixing angle iron frame work fabricated out of M.S.angle iron. and M.S. Flat.with bolts, washers etc., and painted with 2 coats of red oxide and then two coats of approved paint. 40 x 40...
Fabricating supplying and mounting MS box made out 16 SWG suitable for floor orwall mounting, fully weather proof with provision for better heat dissipation, provided with hinged front cover, equipped...
Fixing halogenormetal halide orSVLorILorLED floodlight fitting over existing pole or wall ceiling including clA, bolts, nuts and wiring using suitable capacity wires.
Supply of LED floodlight luminaire with pressure die cast aluminium housing body for optimal thermal dissipation. Lamp compartment comprising of anti glare clear diffuser with Injection moulded polyca...
upply and fixing of 4pole power contactor with NO or NC contacts on existing woodorpanel board using necessary bolts, nuts, washers and wiring etc., complete with AC-3 Rating and as per IS-13947. 40AP...
Supplying and fixing Microprocessor Based Astronomical timerSwitch with using necessary bolts, nuts and washers.
Supplying andfixing miniature circuit breakers on existing MCB distribution boards using necessary fixing materials and 'C' Type curve, indicator ONorOFF, energy cross-3 with Short circuit breaking ca...
Wiring for lightingorpower circuit using one of FRLS PVC insulated 1100V grade, multistrand copper wire with low conductor resistance single core in open or concealed system of wiring with specified I...
Supplying and drawing Flexible Multicore Cable manufactured with electrolytic grade flexible copper with low conductor confirming to IS 8130-1984 and (Virgin) PVC insulation sheathed suitable for work...
Supplying and drawing Flexible Multicore Cable manufactured with electrolytic grade flexible copper with low conductor confirming to IS 8130-1984 and (Virgin) PVC insulation sheathed suitable for work...
Supplying andfixing of Porcelain fuse channel with cut out on existing woodenorpanel using necessary nuts, bolts and washers. 32Amps
Supplying, fixing and wiring Electronic Trivector Meter (ETV) 5 to 20A single phase Class-1 Accuracy with Temper Proof Energy Meter.
Earth work in surface excavation for stripping, seating of bund, Road way, by manual means for lowering andleveling the ground for all works other than foundation anddepth in all kinds of soil not exc...
Providing Size Stone masonry with hard stone in foundation andplinth with Cement mortar 1:6 -1 cement : 6 coarse sand
Filling available excavated earth -excluding rock in trenches, plinth, sides of foundations and other similar works etc. in layers not exceeding 20cm in depth, consolidating each deposited layer by ra...
Plinth Beam- Providing and laying in position Reinforced cement concrete for all Sub structures of building, Irrigation works, Sub structure works of bridges, Drain works andother parallel works from ...
Providing and constructing load bearing wall with Solid Concrete blocks of size 400x150x200mm having block density more than 1800kgorm3 and minimum compressive strength of 4.00 Normm2 conforming to IS...
Providing and fixing Steel work in built up tubular round, square or rectangular hollow tubes etc. trusses etc., including cutting, hoisting, fixing in position and applying a priming coat of approved...
Providing and fixing precoated galvanised iron profile sheets size, shape and pitch of corrugation as approved by Engineer-in-charge 0.50 mm (+ 0.05 %) total coated thickness with zinc coating 120 gra...
Providing and fixing precoated galvanised steel sheet roofing accessories 0.50 mm (+0.05 %) total coated thickness, Zinc coating 120 gorm2 as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy pri...
Providing 20 mm cement plaster on the rough side of single or half brick wall of mix 1:6 (1 cement: 6 fine sand) including rounding off corners wherever required smooth rendering, providing and removi...
Providing and laying flamed finish Granite stone flooring in required design and patterns, in linear as well as curvilinear portions of the building all complete as per the architectural drawings with...
Applying one coat of water thinnable cement primer of approved brand and manufacture on wall surface :Water thinnable cement primer to give an even shade after thoroughly brooming the surface to remov...
Finishing walls with water proofing cement paint of required shade :New work (Two coats applied at 4.84 kgor10 m²) to give an even shade after thoroughly brooming the surface to remove all dirt, dust...
Providing and fixing stainless steel ( Grade 304) railing made of Hollow tubes, channels, plates etc., including welding, grinding, buffing, polishing and making curvature (wherever required) and fitt...
Providing and fixing board displaying information, such as 'Name of work, Tender cost, Name of Contractor, Work completion and liability period etc', having rectangular shape of 1.20m x 0.90m size mad...
Providing, laying, spreading and compacting graded stone aggregate to wet mix macadam specification including premixing the Material with water at OMC in mechanical mix plant carriage of mixed Materia...
Providing and laying 60mm thick factory made cement concrete paver block of approved shape and colour of M30 grade made of C and D waste by block making machine with vibratory compaction laid in requi...
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
24786.docx
Tender Document • 0.16 MB
Notification 24.pdf
Others - TENDER NOTIFICATION • 1.23 MB
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .