R/R damages on Shaktighat to Bandh road in Km 0/00 to 12/00

Construction of penetration macadam 50 (fifty) milimetres thick over prepared base by providing a layer of compacted crushed coarse aggregate 40 (forty) milimetres size hand broken @ 0.06 cum (zero point zero six cubic metres) per square metre and 12 mm (twelve milimetres) size stone chips @ 0.018 cum (zero pint zero one eight) per square metre using chips spreader with alternate applications of bituminous binder and key aggregates and rolling with a three wheel 80-100 (eighty to one hundred) kN static roller to achieve the desired degree of compaction as per Technical Specification Clause 506 (five zero six) including carriage of all labour, equipments and materials to various location through all modes of transportation in all leads lifts and all incidental charges.

Providing and applying tack coat with Bitumen emulsion (RS-1) using emulsion distributor at the rate of 0.275 kg per sqm on the prepared dry and hungry bituminous surface cleaned with Hydraulic broom as per MORD Technical Specification Clause 503 including carriage of materials, labour and equipments to various location of site of work through all modes of transportation in all leads,lifts and all incidentals.

Providing and laying 30mm (thirty millimetre) compacted thickness bituminous concrete with 100-120 (one hundred to one hundred twenty) TPH hot mix batch type plant with electronic control grading-II using crushed aggregate 13.2 mm (thirteen decimal two millimetre) nominal size of specified grading premixed with bituminous binder VG-10 (Viscosity grade-Ten) at the rate of not less than 5.5% (five point five percent of mix weight or as per design mix with nono technology (Zycotherm) at the rate 0.1% (zero decimal one percent) weight of bitumen, using cement as filler with quantity not less than 2% (two percent) by weight of total aggregate or as per design mix transported to site, laid with sensor paver finisher hydraulic with sensor conrol to the required grade, level and alignment, over a previsiouly prepared surface and rolling complete with smooth three wheel roller 8-10 (eight to ten ) tonne capacity for initial break down rollng and vibratory roller 8-10 (eight to ten) tonne capacity or pneumatic tyre roller of 12-15 (twelve to fifteen) tonne with tyre pressure of atleast 0.56 MPa (Zero decimal five six) for intermediate rolling and finish rolling with 6-8 (six to eighty) tonne sommth wheeled tandom roller to achive the desire compaction as per MoRTH technical specification section 500 complete in all respect or as directed by the Engineer-in-Charge including carriage of material within all leads, lifts and other incidentals.