Repair / Renovation of Sub Centre Thanger Dhok in Block Pallanwala

Amount

Dismantling old plaster or skirting, raking out joints and cleaning the surface for plaster including disposal of rubbish to the dumping ground within 50 metres lead.

Repairs to plaster of thickness 12mm to 20 mm in patches of area 2.5 sq. metres and under including cutting the patch in proper shape raking out joints and preparing and plastering the surface of the walls complete including disposal of rubbish to the dumping ground within 50 metres lead : With cement mortar 1:4 (1 cement: 4 fine sand) (including all leads, carriages and lifts complete Job.)

Dismantling doors, windows and clerestory windows (steel or wood) shutter including chowkhats, architrave, holdfasts etc. complete and stacking within 50 metres lead: of area of 3 sq. metres and below

Demolishing cement concrete maFJually/by mechanical means including disposal of material within 50 metres lead: 1:3:6 or richer mix

Providing wood work in frames of doors, windows, clerestory windows and other frames, wrought framed and fixed in position with hold fast lugs or with dash fasteners of required dia and length (hold fast lugs or with dash fasteners shall be paid for separately): Sal wood

Providing and fixing panelled or panelled and glazed shutters for doors, windows and clerestory windows including lSI marked M.S. pressed Butt hinges bright finished of required size with necessary screws excluding panelling which will be paid for separately,al! complete as per direction of engineer- in charge. First Class deodar wood

Providing and fixing 35mm thick factory made laminated veneer· lumber door shutter conforming to IS-14616 and TAOS 15: 2001 (part-B) including lSI marked M.S. pressed butt hinges bright finished of required size with necessary screws as per directions of Engineer-in-charge and panelling with panels of: 12 mm thick plain grade-1, medium density flat pressed three layer particle board FPT-1 or graded wood particle board FPT-1 IS : 3087 marked bonded with BWP type synthetic resin adhesive as per IS : 848

Providing and fixing panelling or panelling and glazing in panelled or panelled and glazed shutters for doors, windows and clerestory windows (Area of opening for panel inserts excluding portion inside grooves or rebates to be measured). Panelling for panelled or panelled and glazed shutters 25 mm to 40 mm thick. First Class deodar wood

Providing and fixing 35 mm thick wire gauze shutters using galvanised M.S. wire gauze of average width for aperture 1.4 mm in both directoin with wire of dia. 0.63 mm for doors, windows and clerestory windows with hinges and necessary screws : lSI marked M.S. pressed bright finished butt hinges with necessary screws of required size First class deodar wood.

Providing and fixing lSI marked oxidised M.S. sliding door bolts with nuts and screws etc. complete : 300x16 mm

Providing and fixing aluminium tower bolts lSI marked anodised (anodic coating not less than grade AC 10 as per IS : 1868) transparent or dyed to required colour or shade with necessary screws etc. complete :

Providing and fixing aluminium handles lSI marked anodised (anodic coating not less than grade AC 10 as per IS : 1868) transparent or dyed to required colour and shade with necessary screws etc. complete

Providing and laying vitrified floor tiles in different sizes (thickness to be specified by the manufacturer) with water absorption less than 0.08% and conforming to IS: 15622 of approved make in all colours and shades, laid on 20mm thick cement mortar 1:4 (1 cement :4 coarse sand) including grouting the joints with white cement and matching pigments etc. complete. size of tile 60x60 cm (including all leads, carriages and lifts complete Job.)

Providing and fixing Ist quality ceramic glazed tiles conforming to IS :13753 of minimum thickness 5mm of approved make like NITCO, ORIENT, SOMANY, KAJARIA or equivalent make in all colour, shades except begundy, bottle green, black of any size as approved by Engineer in charge in skirting , riser of steps and dados over 12 mm thick bed of cement Mortar 1:3 (1 cement :3 coarse sand) and jointing with grey cement slurry @ 3.3 kg per sqm including pointing in white cement mixed with pigment of matching shade complete (including all leads, carriages and lifts complete Job.)

Removing white or colour wash by scrapping and sand papering and preparing the surface smooth including necessary repairs to scratches etc. complete.

Providing and applying white cement based putty of average thickness 2 mm, of approved brand and manufacture, over the plastered wall surface to prepare the surface even and smooth complete.

Distempering with dry distemper of approved brand and manufacture (two or more coats) and of required shade on new work, over and including priming coat of whiting to give an even shade

Finishing walls with water proofing cement paint of required shade Old work (one or more coats) applied @2.20 kg/10sqm over priming coat of primer applied @ 0.80 litres/10 sqm complete including cost of priming coat.

Applying priming coat: with ready mixed pink or grey primer of approved brand and manufacture on wood work (hard and soft wood)

Finishing wall with Delux multi surface paint system for interiors and exteriors using primer as per manufacturers' specifications Painting wood work with deluxe multi surface paint of required shade. Two or more coats applied @ 0. 901itre/10sqm over an under coat of primer applied @ 0. 751itre/10sqm of approved brand and manufacture

Painting top of roofs with bitumen of approved quality at 17 kg 12.17 per 1 Osqm impregnated with a cost of coarse sand at 60 cudm per 10 sqm including cleaning the slab surface with brushes and finally with a piece of cloth lightly soaked in kerosene oil complete. IMih residuallype petroleum bitumen of penetration 80'100

Regrading terracing of mud phaska covered with tiles or bricks, in cement by dismantling tiles or bricks, removing mud plaster preparing the surface of mud phaska to proper slope, relaying plaster gobri leaping and tiles or bricks, grouted in cement mortar 1:3 ( 1 cement : 3 fine sand ) including replacing unserviceable tiles or bricks with new ones and disposal of unserviceable material to the dumping ground (the cost of the new tiles or brick excluded) within 50 metres lead. (including all leads, carriages and lifts complete Job.)

Providing Gola 75x75 mm in cement concrete 1:2:4 (1 cement : 2 coarse sand: 4 stone aggregate 10 mm and down gauge), including finishing with cement mortar 1:3 (1 cement: 3 fine sand) as per standard design : In 75x75 mm deep chase (including all leads, carriages and lifts complete Job.)

Making khurras 45x45 cm with average minimum thickness of 5 em cement concrete 1:2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate of 20 mm nominal size) over P.V.C. sheet 1 m x1 m x 400 micron, finished with 12 mm cement plaster 1:3 (1 cement : 3 coarse sand) and a coat of neat cement, rounding the edges and making and finishing the outlet complete. (including all leads, carriages and lifts complete Job.)

Providing and fixing white vitreous china pedestal type water closet ( European type) with seat and lid , 10 litre low level white vitreous china flushing cistern and CP flush with fittings, C. I./M.S. brackets 40mm bend diameter flush bend, overflow arrangement with specials of standard make and mosquito proof coupling of approved municipal design complete including painting of fittings and brackets, cutting and making good the walls and floors wherever required: W.C. pan with lSI marked white solid plastic seat and lid. with white vitreous china flushing cistern & C. P. flush bend.

Providing c;1nd fixing wash basin with C. I./M.S. brackets, 15mm C.P. brass pillar taps, 32 mm C.P. brass waste of standard pattern, including painting of fittings and brackets, cutting and making good the walls wherever required: White Vitreous China Wash basin size 630x450 mm with a pair of 15 mm C.P. brass pillar taps

Providing and fixing 600x450 mm bevelled edge mirror of superior glass (of approved quality) complete with 6 mm thick hard board ground fixed to wooden cleats with C.P. brass screws and washers complete.

Providing and fixing C.P. brass long nose bib cock of approved quality conforming to IS standards and weighing not less than 810 gms. 15 mm nominal bore

Providing and fixing G.l. pipes complete with G.l. fittings and clamps, including cutting and making good the walls etc.:

15 mm dia. nominal bore Medium

20 mm dia. nominal bore Medium

Providing and fixing brass stop cock of approved quality. 20 mm nominal bore

Providing and placing on terrace (at all floor levels) polyethylene water storage tank lSI : 12701 marked indicating the BIS License No. with cover and suitable locking arrangement and making necessary holes for inlet, outlet and overflow pipes but without fittings and the base support for tank [Sintex, Electroplast, Star, Lotus or equivalent having valid lSI license].

Earth work in excavation by manual means in trenches for foundations, drains, pipes, cables etc. (Not exceeding 1.5 Mtr in width) and for shafts, wells, cesspits and the like not exceeding 10 Sqm on plan, depth upto 1.5 Mtr. including disposal of excavated earth upto 1 Mtr. from cutting edge disposed earth is to be levlelled and neatly dressed in all kinds of soil

Providing and laying in position cement concrete of specified grade excluding cost of centring and shuttering upto plinth level in 1:5:10 mix. ( 1 cement : 5 Coarse sand: 10 graded crushed stone aggregate 40mm nominal size) (including all leads, carriages and lifts complete Job.)

Providing and laying in position cement concrete of specified grade excluding the cost of centring and shuttering- All work upto plinth level. 1:3:6 (1 cement: 3 coarse sand: 6 graded stone aggregate 20mm nominal size) Crushed (including all leads, carriages and lifts complete Job.)

Brick work with common burnt clay F.P.S.(non-modualar) bricks of class designation 75 in foundation and plinth in Cement mortar 1 :4 ( 1 cement : 4 coarse sand) (including all leads, carriages and lifts complete Job.)

Providing and laying damp-proof course 50mm thick with cement concrete 1:2:4 (1 cement : 2 coarse sand 4 graded stone aggregate 20mm nominal size Crushed (including all leads, carriages and lifts complete Job.)

Brick work with common burnt clay F.P.S.(non-modualar) bricks of class designation 75 in foundation and plinth in Cement mortar 1 :6 ( 1 cement : 6 coarse sand) (including all leads, carriages and lifts complete Job.)

Extra for brick work in superstructure above plinth level upto floor V level. (By manual means)

Providing and laying in position reinforced cement concrete of grade 1:1.5:3 (1 cement :1.5 coarse sand :3 graded stone aggregate 20 mm nominal size ) excluding the cost of centering, shuttering, finishing and reinforcement -all work upto plinth level. (including all leads, carriages and lifts complete Job.)

Reinforcement for RCC work including straightening, cutting bending, placing in position and binding all complete T.M.T. Bars

Centering and shuttering including strutting, propping etc. and removal of form work for

Foundations, footings, bases of columns

Edges of slabs and breaks in floors and walls. Under 20cms wide

Suspended floors, roofs, landings, balconies and access platform

Providing and fixing 1 mm thick M.S. steel door with frame of 40x40x6mm angle iron and 3mm M.S. gusset plates at the junctions and corners, all necessary fittings complete, including applying a priming coat of approved steel primer. Using flats 30x6mm for diagonal braces and central cross piece

Making soak pit 2.5 m diameter 3.0 metre deep with 45x45 em dry brick honey comb shaft with bricks of class designation 75 and S.W. drain pipe 100 mm diameter, 1.8 m long complete as per standard design. With F.P.S. bricks (including all leads, carriages and lifts complete Job.)

Supplying and stacking of good earth at site including royalty and carriage complete (earth measured in stacks will be reduced by 20% for payment)

Providing logo with Synthetic enamel paint of approved colour and writing as approved by the Health Department (Complete Job.)

M/s Chaman Lal

M/S SURESH KUMAR SALOTRA CONTRACTOR