Repairing of tippler and fabrication its base frame and break wheel drum new making by casting and machining of Tippler no. 02 of 7, 8 incline of Dhori (K) Colliery

Amount

Damaged and broken joist cutting by gas set both end 64 point X 04”=

Joist cutting by gas set 08’ long X 04 Nos. =

3/4”size bolt cutting by gas set.

Joist cutting by gas set 12” X 04 Nos. =

Hole making in joist

joist setting and welding point to point 04”X 64 point

New tippler plate rivet cutting 01” size and rivet dismantling then plate dismantling both end by gas set.02 Nos. X 02 Nos.=

Shaft new making as per size 325mm long X 55mm dia.

Broken shaft welded portion cutting in round and dismantling by hyd. press

Shaft fitting in plate and welding in round

Plate fitting in new Tippler by 3/4” X 04” bolt nut 24 Nos. new fitting tightening and welding.

Tippler lower base frame dismantling from another Tippler frame by rivet cutting in side plate 05 Nos. each X 04 Nos. plate.

Lower base frame setting in new frame after alignment checking and completely welding as per size (18” long + 12” wide) X 04 side outer and inner in 03 layer Total welding (120” X 02 X 03)

03 Nos. each side plate setting with nut bolts 3/4”x 04”- 20 Nos. fitting and full tightening.

Side plate cutting as per size (12”+ 12”+ 18) X 12 Nos. =

Hole making in plate 3/4” size 05 Nos. each, Total holes 05 X 12 =

Tippler frame extending by angle frame making as per reqd. size and shape 16.5”X 09”X 02 Nos. and setting and welding and fitting with nut bolts.

Side plate completely welding as per size(12”+ 12”+18”) X 3 X 2 X 4 side=

Rail bending by gas heating and hyd. Press as per reqd. shape and size.

Rail welding with lower base frame after alignment setting

Angle welding with lower furse plate 06’ longX02Nos.Xboth side (72”X 02X02)

Plate cutting as per size (04” wide X 74” long) X 02 Nos.=

Plate setting on angle and welding with lower base for chuck Rail both end 06’ X 02= 72”X 02 X 02

Drawer Patti welding with lower side frame 30” X 02 side X 02 Nos. =

Drawer Patti cutting 30” long X 02 Nos.

Stopper plate welding both side as reqd. With drawer patti cutting 04 mouth and welding with plate

Tippler pulley block repairing by oval bore turning and steel bush new making as reqd. Size and fitting and locking and again in side bore machining and greasing hole new making and 5/8” size thread new making

Pattern making

Mold making

Raw material for CI casting of break wheel drum

Brake wheel machining

Bush bore making by machining 80mm X 150mm long

Key and key way making 25mm wide Xn08mm deep X 150mm long

Break lining replacement and new rivet rivetting

Break handle new making and fitting for break drum

Copper rivet 08 mm replacement

Total impact of GST for the purpose of CTC

M/S VIVEK ENTERPRISES

MAA BHAGWATI ENTERPRISES