8898/E8

Amount

Excavating in trenches n. exc. 1.5 m. wide and n. exc. 1.5 m. in depth; for foundation, etc. or for shafts, wells, cesspits, manholes, pire holes, etc. n. exc. 10 sqm on plan and not exc. 1.5 m. in depth and getting out in soft/loose soil complete all as specified and as directed.

Returning filling including spreading levelling, watering and well ramming in layers not exceeding 25 cm in soft/loose soil complete all as specified and as directed.

Removing excavated soil not exc 50 mtr and depositing where directed at a level not exc 1.5 mtr above the starting point in soil complete all as specified and as directed.

Excavating in trenches n. exc. 1.5 m. wide and n. exc. 1.5 m. in depth; for foundation, etc. or for shafts, wells, cesspits, manholes, pire holes, etc. n. exc. 10 sqm on plan and exc. 1.5 m. but n. exc. 3.0 m. in depth and getting out in soft/loose soil complete all as specified and as directed.

Demolition of Reinforcement cement concrete of any description and in any position not otherwise specifically provided.

Dismantling structural steel work including door gates etc but excluding framed truss etc. complete all as specified and directed.

S&F electronically operated tyre killer 4.0 mtr length on road including necessary arrangments complete all as specified and directed with following points. (i) PCB Electronic Circut to automatically switch off motor in case of fault. (ii) Blocking height at 60 d : 120 mm minimum. (ii) Spike to Spike distance : 100 mm maximum. (iii) Steel Stucture to be capable to withstand 25/50 ton vehicle load. (iv) Opening - Closing >2-3 sec. (v) Duty Cycle 100%.

M&L PCC 1:4:8 type D2 type (using 40 mm graded crushed stone aggregate) as in foundation filling and mass concrete etc complete all as specified and directed.

M&L RCC (design mix) M-25 (using 20 mm graded crushed stone aggregate) as in foundation, plinth beams, base of column, footing and mass concrete etc. complete all as specified and directed.

M&L RCC (design mix) M-25 (using 20 mm graded crushed stone aggregate) as in columns, pillars, piers posts and struts etc. complete all as specified and directed.

M&L RCC (design mix) M–25 (using 20 mm graded crushed stone aggregate as in beams, cantilevers, bressummers, lintel over 1.5 m span complete all as specified and directed.

M&L RCC (design mix) M-25 (using 20 mm graded crushed stone aggregate) as in arches complete all as specified and directed.

Use and waste form work to side of concrete foundation, footings, bases of columns, raft and beams and similar work, vertical or to batter as in rough finished surfaces of concrete all as specified and directed.

Use and waste of form work to sides of pillars, posts, struts, piers, columns etc. square, rectangular or polygonal section as in fair finished surfaces complete all as specified and directed.

Use and waste of form work to sides and soffits of floor or roof beams, lintels, over 1.5 m span, cantilevers, shelves including supports, overhangs etc. complete all as specified and directed as in flat and fair finished surfaces complete all as specified and directed.

M&L MS TMT bars 10 mm dia and over, cut to length, bent to shape required including cranking, bending, hooking ends and binding with and including mild steel wire (annealed) not less than 0.90 mm dia as reinforcement complete all as specified and directed.

M&L M.S. TMT bars 5 mm dia and over, cut to length, bent to shape required including cranking, bending, hooking ends and binding with and including mild steel wire (annealed) not less than 0.90 mm dia as in stirrups spaces, binders and nibs etc. complete all as specified and directed.

M&L Granite (of any type) work (table rubbed and polished) for wall linning, 18 - 20 mm thick machine cut laid over cement screed bed 12 mm thick of 1:3 CM and jointed with grey cement slurry and pointed with white cement (1:2) with admixture of pigment to match the shade of the granite stone including cutting and polishing complete all as specified and directed.

M&L brick work with sub class 'B' bricks straight or curved in plan exc 6 mtr mean radius built in CM (1:6) using old size bricks complete all as specified and as directed.

M&L for sand filling under floor including watering and consolidation complete all as specified and directed.

M&L for 15 mm thick rendering on brick or concrete surfaces of wall in CM 1:4 and finished even and smooth without using extra cement complete all as directed.

M&L rendering 15 mm thick in cement mortor 1:3 on fair faces of brick or concrete surface complete all as specified and directed.

M & L preparation of newly plastered surfaces of walls and applying two coats of cement base paint complete all as specified and directed.

S&F rolled mild steel section Fe 410 -W (Gde- E- 250) quality "B" framed work as in doors or gates with frame/chowkat with hand made holdfast made from angle of other section with gusset plates, rails braces, etc. complete drilled for fixing of steel sheeting or other covering, doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings with sliding door bolts etc. (excluding steel covering which shall be measured and paid separately under respective items in this Schedule) and hanging fastening and fixing complete all as specified and directed

M&L preparation of new or previously untreated steel and iron surfaces of any description over 10 cm width or girth and applying two coats of synthetic enamel paint over a coat of zinc chrome primer complete all as specified and directed.

M&L fine sand, filling in trench for cable cushioning and gently punned down by manually with hands complete all as specified and directed.

Material and labour Brick protection cover to LT underground cable with Sub Class 'B' over burnt laid dry and flat abutting each other with gaps between adjacent bricks not exceeding 10 mm complete specified and directed

Supply and laying tubes 40 mm dia steel water tube light grade galvanised with all fittings laid in trenches for cable protection complete all as specified and as directed.

M&L for LED flood light luminaire 150Watt, IP protection 66, made up of pressure die cast aluminium housing with toughened glass and high power LEDs and secondary lenses, system efficiency not less than 110 LPW, 10 KV SPD including bracket and all necessary fittings complete all as specified and directed.(Make : Crompton /Philips/Havells/ Bajaj.)

M&L for Decorative post top lantern for 360 degree , 60Watt IP 65 protection, indirect light suitable for pipe 50mm dia including connection from connector to switch complete all as specified and as directed. (Make : Crompton /Philips/Havells/ Bajaj.)

Supply and fix tripple pole and earth enclosure with a three pin and earth plug with socket complete with one tripple pole MCB 415V, 32 Amps capacity complete all as specified and directed. (Make L & T /GE/SCHNEIDER / LEGRAND).

Supply and fix MCB SP 240V, 6-32 Amps capacity complete all as specified and directed. (Make L & T /GE/SCHNEIDER / LEGRAND).

Supply and fix MCB SPN 240V, 6-32 Amps capacity complete all as specified and directed. (Make L & T /GE/SCHNEIDER / LEGRAND).

Supply and fix sheet metal enclosure powder coated, MCB DB SPN 4 way 100 A insulated phase bus bar, double door for neutral links all as specified and directed .(Make L & T /GE/SCHNEIDER / LEGRAND).

Supply and laying in trenches or fixing or passing through pipes or fixed to wall/pole 1100 volts grade PVC/ XLPE insulated armoured heavy duty electric cables (conforming to IS 7098 (Part- I)with aluminium conductor of cross sectional area 6 Sqmm 2 core complete all as specified and as directed.

Supply and laying in trenches or fixing or passing through pipes or fixed to wall/pole 1100 volts grade PVC/ XLPE insulated armoured heavy duty electric cables (conforming to IS 7098 (Part- I)with aluminium conductor of cross sectional area 16 Sqmm 4 core complete all as specified and as directed.

SUDHA ENTERPRISES

CHOWDHURY SMALL INDUSTRIES

M/S SK PAUL

SOVA ENTERPRISE

M A ENTERPRISES