CONSTRUCTION OF TWO CAR PARKING SHEDS AT TROOPS LINE SQAE A AND LPR AND SPECIAL REPAIR TO RECOVERY SAND BUTT BLDG NO P 48 AT LONG PROOF RANGE AND SQAE A KHAMARIA UNDER GE P NO 1 JABALPUR

Excavation in post holes (or similar holes) each not exc. 0.50 Cum, getting out, returning, filling and ramming earth or broken rubble mixed with earth around in layers not exc. 25 cm watering and removing surplus soil to a distance not exc. 50 m and making good surface as in soft / loose soil complete all as specified and directed.

M & L for Moorum/raid bajri filling in floor or paving laid in layers not exceeding 15 cm thick, spread, leveled and remmed incl watering complete all as specified and directed.

M&L for Cement concrete type D-2 1:4:8 (using 40mm graded aggregate) as in foundation filling and mass concrete complete all as specified and directed.

S&F for steel work in tubular trusses incl special shaped washer etc complete using ERW or induction butt welded tubes conforming to IS 1161-1979 grade St-240 complete all as specified and directed.

M&L for two coats of synthetic enemel paint on new steel surfaces over one coat of red oxide primer over 10 cm width of girth incl preparation of surfaces complete all as specified and directed.

M&L for pre-painted galvalume aluminium zinc coating GI basied corrugated steel sheet 0.5mm thick of an colour having tensile strength of 550 Mpa as in roof covering/cladding to wall fixed with self tapping screws complete all as specified and directed.

Surface excavation n.exc 30 cm deep and averaging 15 cm deep and getting out in soft/loose soil complete all as specified and directed

Removing excavated material for soft/loose soil exc. 250 m but nexc 500 m and depositing where directed complete all as specified and directed.

M&L for providing and laying 60mm thick factory made chamfered edge cement concrete paver bloxk of M-35 grade ith approved colour, design & pattern as in tootparth, parks, lawns, drive ways or light traffic parking etc of required strength thichkness & shape/size made by table vibratory method usingPU mould, laid in required colour & pattern over and incl 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of interlocking paver blocks as per required size and pattern finishing and sweeping extra sand complete all as specified and directed.

M&L for PCC 1:2:4 type B1 using 20mm graded crushed stone aggregate as in coping, kneesa, plinth bends, apex stone and similar works complete all as specified and directed.