Suri - Md. Bazar road

Providing, laying, spreading and compacting stone aggregates of specific sizes to water bound macadam specification including spreading in uniform thickness, hand packing, rolling with 3 wheeled steel/ vibratory roller 8-10 tonnes in stages to proper grade and camber, applying and brooming requisite type of screening/ binding Materials to fill up the interstices of coarse aggregate, watering and compacting to the required density (Reference to MoRT&H's specification 404). BY Manual Means. Grading-2 (Table 400-9) Using Screening Crushable type such as Moorum or Gravel.

Repairing Pot-holes with Bituminous Macadam (Grading - II, for compacted thickness of upt75mm) Filling Pot Holes with Bituminous Macadam using Mobile Hot Mix plant (6-10 TPH) with approved crushed aggregates of specified grading premixed with bituminous binder @3.4% by wt. of the total mix, transported to site and laid in the pot hole prepared before hand by cutting the edges to get a firm vertical face and by removing all the failed and loose materials ncluding dust and applying tack coat evenly on the sides and on the surface as per specification, rolling the filled depression with 8-10 tonne smooth wheeled roller to achieve the desired compaction, including the cost and carriage of stone aggregates and bitumen, hire charges of machinery and equipment, cost of fuel and lubricants and wages of all operational staff, quality control except the cost of tack coat complete as per direction of Engineer-in-charge. Payment to bemade on the basis of the loose net volume of he stone aggregates used in the work. Grading-II Material cost to be added as per Chapter A, Sl. No. 5.3 after dividing quantities of each of the materials by a factor of 1.42. For cost of tack coat refer Item No. 2 ofChapter-5 (b) Using Mobile HMP (Light duty)

Prime Coat Providing and applying primer coat with cationic bitumen emulsion SS1grade conforming to IS:8887 on prepared porous granular surface including clearing of road surface and spraying primer using mechanical means (Reference to MORT&H's specification clause 502). On WMM/WBM surface @ 0.70-1.0kg /sqm.

Tack Coat: Providing and applying tack coat with Cationic bitumen emulsion (RS1) complying with IS:8887 using emulsion pressure distributoron the prepared bituminous/granular/cement concrete pavement surface cleaned with mechanical broom and high pressure airjet (Reference to MORT&H's specification clause 503). i) On bituminous surface @ 0.20kg-0.3kg /sqm. [For potholes area only]

Open-Graded Premix Surfacing: Filling Pot-holes and Patch Repairs with open-Graded Premix surfacing, 20mm. Removal of all failed material, in the pavement courses and if necessary belowthe pavement, until the root causes of the failure is removed, the trimming of completed excavation to provide firm vertical faces; specified for the pavement layer; application of tack coat conforming to cl.503 of MORT&H's specification on to the sides and base of excavation prior to placing hot bituminous material as per clause 510 and the compaction, trimming and finishing of the surfaces of all patches to form a smooth continuous surface, level with the surrounding road as per the requirement of clause 3004.2 of MORT&H's specification. (Rate including tack coat)

Seal coat : Providing and laying seal coat sealing the voids in a bituminous surface laid to the specified levels, grade and cross fall using. Type A and B seal coats (Reference to MORT&H's specification clause 511) Case - II : Type B Providing and laying of premix sand seal coat with HMP using approved crushed stone chipping and viscosity grade paving bitumen of suitable approved grade.

Add GST 18% over the Sub-Total upto item No. 6