15th Finance Commission UnTied Grant I st Installment 2024-2025

Amount

Earthwork excavation for foundation in all soils and sub soils in hard stiff clay, stiff black cotton, hard red earth, shales, murram, gravel, stoney earth and earth mixed with small size boulders and to full depth as may be directed,except in hard rock,requiring blasting including shoring and shuttering and bailing out of water wherever necessary,refilling the sides of foundation with excavated earth or sand in layer of not more than 15cm thick.well rammed and consolidated and depositing on bank with initial lead and lift of 10m & initial lift of 2m and depositing the surplusr earth within the compound in places shown by the departmental officers with iniital lead and lifts,clearing and levelling the site etc., complete as per SS20B and as directed by departmental Engineers(TNBP No.20B).

Supplying and filling in foundation and basement with Crushed Stone Sand (M- Sand) in layers of not more than 15cm thick well rammed watered and compacted etc., complete complying with standard specification.

Supplying and filling the basement with Good Earth filling in layers of not more than 15cm thick well rammed watered and compacted - etc., complete complying with standard specification.

Plain Cement Concrete 1:4:8 mix (One Cement, Four Fine Aggregate and Eight Coarse Aggregate) Using 40mm ISS HBG metal for foundation and basement including dewatering if found necessary and laid in layer of not more than 15cm thick and consolidated including all cost conveyance of materials and labour charges etc. complete as per standard specifications and as directed by departmental Engineers(TNBP No.28).

Supplying and erecting centering for sides and soffits including supports and strutting uptp 3.29m height for plane surfaces in all floors with all cross bracings using mild steel sheets of size 90cmx60cm and 10 gauge stiffened, welded with mild steel angles of size 25mmx25x3mm for boarding laid over silver oak (country wood) joist of size 10cmx6.5cm dia spaced about 90cm centre to centre and supported by casuarina props of 10cm to 13cm dia spaced at 75cm centre tocentre etc.complete complying with standard specification and as directed by the departmental engineers. TNBP No.30 For Grade Beam

For Lintel,Beam&Slab

For Coloumn,Sunshade

Plain Cement Concrete 1:3:6 (one cement, three crushed Stone Sand (M- Sand) and six coarse aggregates) using 20mm size ISS HBG metal including cost and conveyance of all materials to site and including for the mixing, laying and labour charges etc., complete as per standard specification

Providing and laying in position Standardised Concrete Mix M-20 Grade in accordance with IS 456 - 2000 using 20mm and down graded hard broken granite stone jelly for all RCC items of works with minimum cement contenet of 325Kg/ cum and maximum water cement ratio of 0.55 including admixture (Plasticiser / super plasticiser) in recommended proportions as per IS 9103 to accelerate, related setting of concrete, improve workability without imparing strength and durability with about (5.0cum), 7730Kg of 20mm machine crushed stone jelly and with about (3.3 cum), 5156kg of 10 - 12mm machine crushed stone jelly and with about (4.79cum) 7670 kg of Crushed Stone Sand (M- Sand), but excluding cost of reinforcement grill and fabricating charges centering and shuttering but including laying, vibrating with mechanical vibrators, finishing, curing, etc and providing fixtures like fan clamps in the RCC floor / roof slabs wherever necessary without claiming extra cost etc., complete complying with standard specification and as directed by the departmental officers.

R.C.C.Jolly by a new of following size in M20 Concrete using 20mm gauge hard broken granite stone jelly and river sand excluding cost of reinforcement but includingcharges,fabrication charges curing neat finishing and labour charges for fixing the jolly in position with standard spefication

Supplying, fabricating and placing in position mild steel or ribbed tor steel for all reinforced cement concrete works as per design given including cost of steel and binding wire with all conveyance and lead charges in all floors etc.complete complying with standard specifications and as directed by the deparmental engineers. TNBP No:30

Brick Work in CM 1:5 (One part of cement & five parts of sand) mix using Third Class Country Brick Kiln Burnt bricks 8 ¾ " x 4 ¼ " x 2 ¾" including cost and conveyance of materials to work site and including all labour charges for mixing, laying, curing the concrete etc., complete as per standard specifications and as directed by departmental Engineers – TNBP No:31 a)Foundation and Basement

b)For Ground Floor

Plastering with cement mortar 1:3 (One part of Cement and Three part of Plastering Sand (P- Sand)), 10mm thick in all floors including cost and conveyance of all materilas to site and labour charges etc,complete as per standard specifications

Plastering with CM 1:5 (One part of cement & five parts of sand) mix for 12mm thick including cost and conveyance of all materials to work site and including all labour charges for mixing, laying, curing,finishing etc., complete as per standard specifications and as directed by departmental Engineers – TNBP No:56&57

Weathering course concrete with broken brick jelly of 20 mm gauge in pure slacked lime ( no sand to be added) over roof slab the proportion of brick jelly to lime being 32:12.5 by volume and laid over In a single layer and consolidated require designed and finished thickness by beating the concrete with wooden beaters of approved pattern , keeping the surface constantly with springing lime jiggery water asper standard specification and as directed by the departmental officers Complete as per standard specification.

Finishing the top of roof with one course of machine pressed tiles of size 200 mm x 200 mm x 20 mm of approved quality in Cement Mortar 1:3 (One part of Cement and Three part of Plastering Sand (P- Sand)), 12 mm thick mixed with water proofing compound conforming to ISS at 2% by weight of cement used and the joints pointed neatly to full depth of tiles with the same cement mortar mixed with red oxide and water proofing compound including curing etc., complete

Laying with first quality design ceramic tiles of all colours new ceramic tiles 305 x 305x 6mm tk for flooring and set in Cement Mortar 1:3 (one part of cement & three parts of sand)20mm thick and pointed with white cement including adding with suitable colouring pigments of match with the colour of tiles used and curing etc., complete.including cost and conveyance of all materials etc.and all labour charges etc.complete as per Standard specification and as directed by the departmental officers. TNBP No.special

Dadooing walls with Glazed tiles of sizes 300mm X 200mm X 6mm size of approved make and quality and colour Set in cement mortar 1:2 (One part of Cement and two part of Plastering Sand (P- Sand)) over 10 mm base layer plastering and pointing with white cement neatly as directed.

Painting two coats for Interior surface with approved Interior Plastic Emulsion paint approved quality and colour over a priming coat, including thorough scrapping, clean removal of dirt, etc complete and including necessary plaster of paris, putty, wherever required etc, complete as per standard specification.

Wiring with 2x1.5 sqmm (22/0.3) PVC insulated SC unsheathed Cu.Conductor of 1100V grade in suitable PVC rigid pipe concealed in wall and ceiling with PVC accessoires in flush with wall with 3mm thick hylum sheet cover with TW switch box and 5A F.T. switch and making good of the concealed portion with suitable colour for PVC concealed light (6 Points Per Coil) (For Rooms like Bath , Toilet,& Pump room etc..)(SD-26)

Supply and fixing of WT bulk head fitting with guard (Philips / Bajaj / Crompton / K. Lite) suitable for11W CFL lamp with CFL.(PWD standard data No.SD.83).

Supplyandrunof2of4sq.mm. PVC insulated SCunsheathedFRLScopperconductorof1100Von7/20GIbearer wire for service connection mains

Supply and run of 2 of 1.5sqmm (22/0.3) PVC insulated SC unsheathed Cu. Conductor of 1100V grade in 25mm G.I.Pipe (B Class) suitable bend at both ends with necessary angle iron upright and End support for service connection mains.(PWD Electrical Standard data 2015-2016 No.SD. 69).

Supplyandfixingof16ATPNmetalcladswitchonsuitableangleironframeworkwithMScableentryboxeswithearth connection only

Providing and fixing of PVC Rain water down fall pipe 110 mm dia 4kg/cm2 with necessary Shoes bends and other specials with Teak wood plugs including cost of all materials charges and all labour charges etc. complete and as directed by the departmental officer etc. complete.

Supply and delivery and fixing of 1000 Liter Capacity HDPE Water tank including loading,unloading, transportation and labourcharges for fixing charges etc.,(Rate as Per PWD SOR 17-18 Item No;207 page 64)

Supplying and fixing in position best quality PVC pipes of 40mmdia having 10 kg / sq.cm. pressure etc., complete complying with standard specifications. ,(Rate as Per PWD SOR 17-18 Annexure VI Item No;199- e page 58)

Supplying and fixing in position best quality PVC pipes of 32mmdia having 10 kg / sq.cm. pressure etc., complete complying with standard specifications. ,(Rate as Per PWD SOR 17-18 Annexure VI Item No;199- b page 58)

Supplying and fixing in position best quality PVC pipes of 25mmdia having 10 kg / sq.cm. pressure etc., complete complying with standard specifications. ,(Rate as Per PWD SOR 17-18 Annexure VI Item No;199- b page 58)

Supply and delivery of 15 mm Dia PVC heavy type screw down tap Including all charges as Directed by the Departmental Officers Etc,Complete,(Rate as Per PWD SOR 17-18 Annexure -VI- 204Page No:87)

Conduction Geophysical Survey with Scientific Instruments including transportation charges

Drilling of 150 mm bore well in Hard rock formation using rig including Erection of casing pipes,transportation and fuel charges of Rig to site and all labour charges etc complete.(As per Local market Rate)

Supply and delivery of 150mmDia blue plain PVC casing pipe(CM) as per standard specification( As per TWAD Board SOR-2017-2018 Basic rates)

Supply and delivery of clear water vertical wet type submersible pump conforming to IS 8034/2002 and as amended thereafter and BEE 3 Star Rated capable of discharging noted LPM against head of water column due to all causes. The pump shall be with stainless steel shaft and dynamically balanced bronze or Cast SS impeller, brass screws and CI FG 200 grade pump bowl/diffuser with ISI mark. The pump shall be directly coupled to a continuos rated two pole suitable wet type vertical squirrel cage induction motor suitable for operation in AC single phase 230 V+/- 10 %,50 HZ +/-5 % 2HP SINGLE PHASE SUBMERSIBLE PUMPSET AS 20X150 Lpm TWAD SOR PAGE NO : 102

Supply and delivery of direct online starter confirming to IS13947, IEC60947-1 and as amended thereafter with suitable KW rating for operation in AC/single Phase/50HZ(± 5%) and 230 V(±10%) including Ammeter, Voltmeter, Thermal Overload relay, 16 Amps 2 pole Magnetic Contactor with under Voltage protection, Indication lamp, starting capacitor, running capacitor and On/Off Push button switches, 5 way connector, wiring with 1 sq. mm/1.5 sq. mm copper PVC insulated cable, powder coated vermin proof box including the capacitor (the cost of capacitor is to be taken separately).SINGLE PHASE PANEL BOARD WITH TWO LEVEL GUARD AND AUTO START 2 HP TWAD 24-25 PAGE NO119

Supply and delivery of pipes and pipes specials including all charges etc., 2.50 sq.mm PVC insulted copper flat cable(Cost Excluding GST -Rate as per TWAD Boad SOR 2017-2018.)

32 mm Dia B-Class G.I.Pipes(Medium) for submersible motors in borewell(Cost Excluding GST -Rate as per TWAD Boad SOR 2017-2018.)

32 mm dia G.I.Coupling

32 mm dia G.I.Bend

32 mm dia G.I.Union

32 mm dia G.M Gate valve & Non Return Valves

150 mm dia Bore cap

150 mm dia Bore Clamp set OF 65 MM Width

Errection for labours charges for (Up To 5HP )submersible motor and pump set etc. cost Excluding for materials and pump set but including cost of all Labour charges Etc,, complete-

Providing and laying, spreading and compacting graded stone aggregate to Wet mix macadam (WMM) specification including premixing the material with water at OMC in mechanical mix plant carriage to mixed material by tipper to site laying in uniform layers with paver in sub base / base course on well prepared surface and compacting with vibratory roller to achive the desired density complete as per clasue 406 of MORTH specifications.

Supplying and laying Rubberised interlocking Paver block M40 grade Providing and laying of 83mm thick high strength type conforming IS 15658-2006 of rubberized interlocking paver lock in size of minimum compressive strength of 40N/mm2 in uniform shape of approved make to be laid in flurring bone pattern with sand cushion below the uniform shap of approved non skitting surface in the top and the rate including levelling the base preparation of pavers as sub base, sand cushion 100mm thick laying out of pavement cut the pieces to fix the edge vibring the pavers,sweeping tranporting loading unloading of laying paver block as per standard specification,.