CA NO.CWE BLY/ GE (E) /122 OF 2026-27SPECIAL REPAIR TO ROAD SHOULDERS AT SHAHJAHANPUR CANTT UNDER GE (EAST) BAREILLY

Demolition of bricks (laid flat or on edge) on brick tiles in floors, channels, kerbs, aprons, etc. (each layer) complete all as specified and directed.

M&L for brick work with subclass 'B' old size bricks, straight or curved on plan exc 6m mean radius built in CM 1:6 as in culvert/ road berm complete all as specified and directed.

M&L for 15mm thick rendering in cement mortar 1:4 to on brick masonary wall surfaces or concrete surfacesusing water proofing compound @3% by weight of cement content complete all as specified and directed.

M&L for preparation of finishing walls and applying two coats of synthetic enamel paint over a coat of primer and putty complete all as specified and directed.

M&L for 100 mm thick cement concrete type D 2, 1:4:8 (using 40 mm graded stone aggregate) in sub base of flooring complete all as specified and directed.

M&L for moorum/ red bajri filling in floors or pavings, laid in layers n exc. 15 cm thick, spread, levelled and rammed including watering complete all as specified and directed.

Providing and laying 80mm thick factory made chamfered edge cement concrete paver block of M-40 grade with approved colour, design & pattern as in footparth, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand complete all as specified and directed.

Providing and laying at or near ground level factory made kerb stone of M-25 grade cement concrete in position to the required line, level and curvature, jointed with cement mortar 1:3 (1 cement: 3 coarse sand), incl making joints with or without grooves (thick of joints except at sharp curve shall not to more than 5 mm), incl making drainage opening wherever required complete all as specified and as directed.

M&L repair to potholes any depth, not exc 1 sq m each including sweeping free from dust and mud, or water, scoring sunken surfaces in roads, paths, etc. cutting around edges to at least 25 mm in depth and making good by filling in screened & graded road metal, watering and well ramming (including supply of road metal) but making good by applying tack coat with bituminous primer @ 5 kg per 10 sq m, putting in premix as specified for thin bituminous carpet 2 cm thick, well rammed and sealed with premixed sand seal coat (6.8 kg of binder with 0.06 cum of sand) and again well rammed (including supply of premixed binder and sand) depth of pot hole n.exc. 30mm complete all as specified and directed.

M&L for preparing existing black top surfaces of road by brushing with wire brushes for removing caked mud etc. sweeping with brooms and finally fanning the cleaned surface with gunny bags to remove all loose dirt etc. complete all as specified and directed.