PROVN OF BALANCE TECH ACCN OF FSD AT AKHNOOR

Amount

Total Amount of Sch 'A' Part - I (Building Works)

Total Amount of Sch 'A' Part - II (Grubbing of Trees)

Total Amount of Sch 'A' Part - III (Road/ Path/ Culvert Work)

Total Amount of Sch 'A' Part - IV (Site Clearance and Development)

Total Amount of Sch 'A' Part - V (Protective Work)

Total Amount of Sch 'A' Part - VI (Hard Standing)

Total Amount of Sch 'A' Part - VII (Area Drainage)

Total Amount of Sch 'A' Part - VIII (Sewage Disposal)

Total Amount of Sch 'A' Part -IX (Compound Wall, Fencing And Gate)

Total Amount of Sch 'A' Part - X (External Water Supply)

Total Amount of Sch 'A' Part - XI (Flame Proof Wiring for Fol Store)

Total Amount of Sch 'A' Part - XII (External Electric Supply)

Total Amount of Sch 'A' Part - XIII (Internal Water Supply)

Total Amount of Sch 'A' Part - XIV (Internal Electrification)

Sch 'A' Part - XV (Misc Items work) Note : This Schedule is not Pre-Priced by MES and the Pre-Priced rate indicated as "Rs. 0.00" under col. 6 signifies this fact only.

LLDPE septic tank designed to carry sewage and sullage water, excavation in any type of soil, PCC 1:4:8 below foundation, Vent shaft, connection etc complete for 10 users

Soakage wells (1.8 M dia X 3.0 M size ) ,excavation in any type of soil, foundation in PCC 1:3:6, walls of honey combed masonry with top ring of M25 concrete including ntercepting chamber and screen chamber made of Brick masonry in CM, RCC cover slab in M25/ SFRC cover, interconnecting pipes of RCC/DWC complete filled with brick bats of size

Dismantling/taking down barbed wire from the existing angle iron fencing posts and neatly coiling on rough drums for re-use or removing from the site complete all as directed by Engineer-in-Charge.

Material and labour for cutting in position existing GI pipe of size 80mm and connection to 40/25 bore pipe for taking branch connection including supply and insertion of required fittings including earth work of required size including all packing material & other fittings and fixtures for making the joint leak proof complete all as specified and directed.

Supply and fixing LED tube light fitting,1X36W flame proof type FLP-WP made of aluminium alloy LM6, with electronic ballast, bipin holders, connector block etc. and all accessories prewired and including connecting up with twin core twisted flexible copper conductor cable with suitable size, complete all as specifieed and directed.

Supply and fixing flame proof, weather proof distribution board 6 way accumulated flame proof of MCB SPN 0-10 Amps, 10 KA (01 Nos) and MCB SP-0-6 Amps, 10KA (04 Nos) complete all as specified and directed.

Supply and fixing LED street light bracket made out of GI pipe 1.5 Mtr long 40mm dia light grade bent to shape as directed including clamps made out of 40mm x 6mm flat iron for fixing bracket suitable for PCC/ steel poles including nuts and bolts of required size including painting with one coat of aluminium paint over a coat of red oxide/ primer all as directed.

Supply and fix LED street light 45 W IP 65. Make :- HPL ct pt No HPLLEDSL4560P or equivalent in Syska/ Crompton.

S & F Loop in and Loop out box pole mounted out door type hot press moulded SMC junction box of dimension not less than 300x300x150mm with locking arrangement suitable for 240V, 50 Hz including MCB SP of 6 Amp Cap, fixing with 4 Nos Aluminium bus bar of 30 Amps rating for three phase with neutral, painted with powder coating in Siemens grey colour including clamp for fixing with steel pole all as specified and directed by Engineer-in-Charge.

Feeder piller box out door type ‘factory ’ made and out from 16 SWG MS Sheet supported with legs of 45cm long made of iron angle 25x25x4mm thick of size 75cm x60cm X45cm with 04 Nos aluminium bus bar of 250 Amps mounted on porcelain insulator duly drilled hole for cable connection including front and rear side opening with locking arrangement and provn for incoming and outgoing cables with glands including painting with two coat of smoke grey synthetic enamel paint over a coat of red oxide primer, complete all as specified and directed by Engineer-in-Charge. Note :- Feeder pillar box shall be mounted on brickwork in CM 1:4 not less than 60 cm above ground level with suitable foundation, rendering 15 mm in CM 1:6 and two coats of cement base paint and the rates shall be inclusive in the quoted rate.

Dismanteling of U/S MS Channel, clamp nuts etc any type and any size

S&F Astronomical timer switch and timelite distribution, IP 54 Protection having MCB 40 Amp SPN, Contactor SP of suitable capacity, time switch prewired with suitable size of copper cable, fixed on pole with clamps, nuts, bolts all as specified and directed Cat part No-IHXSS0106A of make Havells or equivalent in indo Asian/Sinetrac/BCH

VTPN verticle loadline double door distribution box (DB) fitted with Bus neutral link, blanking plates of 4 way with suitable for incomming MCCB 'I/C' frame Make:- Indoasian part No - 811888 or equaivalent in Havells, Legrand, L & T etc.

MCB SP 6 to 32 Amps 10 KA, "C" series, AC,240Volts,50 Hz, ISI marked com[plete all as specified and directed. Make - Indoasian part No. 811122 to 811129 or its equiavalent in Havells, Legrant, L & T etc.

MCB SP 6 to 32 Amps 10 KA, "C" series, AC,240Volts,50 Hz, ISI marked com[plete all as specified and directed. Make - Indoasian part No. 811151 or its equiavalent in Havells, Legrant, L & T etc.

LED battaen Regal suitable for T8 LED tube crystal glass with very high efficiency suitable foer installation in existiong T8 fitting with G 13 lamp 20 Watt 4 ft white all as specified and directed. Make:- Havells part No. for batten - REGALBATTENT8UPTO1X22W DSBSWH, CAT PART No for LED Tube T8 : CRYSTAL1213T8DSTL18WLED865SGLASS or equibalent in CE, Philips, Bajaj, etc. Note:- Rate quited include the cost batten anf tube rod T8 and shall match with the batten in.

20 Watt LED energy saving light fittingenvironment friendly long life LED street light made up of pressure die cast aluminiumb housing with acrylic cover as diffuser with IP 66 protection and impact resistance of IK 07 with GI bracket made of light grade GI pipe 40 mm dia of 1.2 mtr long bend to shape with 02 Nos of FL clamp 32 X 4mm with suitable size nuts, bolts, washers etc. and making the connection from ceiling rose to fitting with suitable size twin core copper conductor cable complete all as specified and directed. (Make:- Havells, cat part no ENDURACITYLITEPLATSL20WLED 757SASYBOPC or Bajaj/Philips/Cromption Graves or its equivalent).

Supply and fixing flame proof,exhaust fan of size 450mm, 230V, AC, complete all as specified and directed.

Dedction to be made from BOQ for Sch. 'A' Part- XVI (credit Schedule for dismantling/demolition) worth Rs 20675.00 and for Sch.A Part XVII (Credit schdule for Trees ) worth Rs 687216.00 during AOC Note:- Tenderes shall not quote for this schedule

M/S KAPIL KUMAR KHATTAR

mohan lal gupta sons

M/S BHATIA BUILDERS AND CONTRACTORS

M/s Sekinder Paul Sharma

SHARMA CONSTRUCTION COMPANY

R R CONSTRUCTION