Estimate for Remodelling of Bhagwanpura Distributary system with concrete Lining with 10 percent Enhanced Capacity offtaking at RD 90200/R of 2nd Patiala Feeder (Burj Branch at RD 0-24700)

Amount

ordinary jungle clearance of both banks of running distributaries, minors and drains with discharge upto 1.5 cum/s

Earth work in excavation in foundations trenches etc. in all kinds of soil where Pick-Jumper work is not involved and not exceeding 2.0 metres depth including dressing of bottom and sides of trenches, stacking the excavated soil clear from the edge of excavation and subsequent filling around masonry in 15 cm, layers with compaction including disposal of all surplus soil as directed within lead of 30 metres

Dismantling brick work tile, masonry or tile lining

Excavation of soil ( any type ) using hydraulic excavator CK 90 excavation with hydraulic excavator of 0.9 cum capacity including cutting trimming bottom and side slopes in accordance with requirement of grades and cross sections, includingall lift and combined lead upto 60 mtr.

Extra for laying earth as per specification for compaction in 20 Cm. layers and dressing including the cost of rolling and watering as per P.W.D specifications.

Earth work for lip cutting for lining of irrigation channels inclusive of all allowance leads and dressing( as per earth work statement) (a) 0-1.5mt. depth

Providing and laying Cement concrete (M-15) sleepers in bed and side slopes below the joints of concrete lining mixed in automatic computerized batching and mixing plant and transported to the site in transit mixers including supply carriage, loading & unloading of material complete in all respect as per design/drawing and PWD specifications

Cement concrete lining 75mm. thick or less laid manually for irrigation channels, using cement concrete M-15 with cement content 325 kg/cum mixed in an automatic computerized Batching & Mixing Plant and transported to the site in transit mixers with an average lead of 1 Km(FOR TRAPEZOIDAL SECTION AND CUP SECTION OF ALL RADII)

Providing and laying Cement concrete (M-15) for coping mixed in automatic computerized batching and mixing plant and transported to the site in transit mixers including supply ,carriage, loading & unloading of material complete in all respect as per design/drawing and PWD specifications

Providing and laying LDPE 150 micron over sleeper on construction joints and expansion joints complete in all respect as per design/drawing and PWD specifications

Dag Belling single kassi stroke minimum 7.5 cm. depth complete in all respect as per design/drawing and PWD specifications

Dressing of earth work ((i)) New work or remodeling work.

Shuttering for faces of concrete foundations and foundation beam & plinth beam (vertical or battering)

Extra bitumen painting at 0.69 Kg. per sqm

Putting 1:3 (Cement:water) cement slurry with cement @ 2.25 kg per sqm on prepared bed and side slopes before laying concrete on bed and side slopes

Filling construction joints with special impervious hot pour 12.5mm wide.

Filling expansion joints with special impervious hot pour 12.5mm wide.

Dressing side slopes and preparation of sub grade for lining.

Excavation of Soil using Hyraulic Excavator and hydraulic Tractor Trolly I/C cutting and loading in Trolly and transporting to the embankment locations with all lifts and leads Disposal/carraige from (a)0 upto 450m

(b) 450m upto 1Km (pacca)

(c) 450m upto 1Km (katcha)

(d) 1 km to 10 km ( pacca)

(e) 1 km to 10 km ( katcha)

Cement concrete 1:3:6 with stone ballast or shingle mixing by mechanical means using concrete mixer volumetric type

Reinforced cement concrete M-20 mechanically batch mixed using batch type concrete mixer as per IS:1791 and vibrated by needle vibrator but excluding steel reinforcement centring and shuttering in foundation and plinth.

Cold twisted detormed (Ribbed/ Tor steel) Bars (Fe 500 grade as per IS 1786-2008) , for R.C.C works, where not including in the complete rate of RCC including bending and binding placing in position complete

Earth work involved in dismantling Open flume, A.P.M. or O.S.M. type Outlets (including excavation, refilling , consolidation and dressing ) With H upto 0.5 m

Dismantling outlets including removal of dismantled material involving lead upto 100 metres. Dismantling O.F., A.P.M. Or O.S.M. type outlets involving dismantling cement masonry and removing of precast R.C. Slab With H upto 0.5 m

Adjusting A.P.M. to the correct Y and fixing in position:- In case of new outlet where no dismantling and reconstructing of gullet wall is involved

Extra labour for dressing bricks On O.F. and A.P.M. type outlets With H upto 0.5 m

Cement concrete 1:4:8 with brick balast 40mm gauge mixing by mechanical means using concrete mixer volumetric type

Reinforced cement concrete M-20 mechanically batch mixed using batch type concrete mixer as per IS:1791 and vibrated by needle vibrator but excluding steel reinforcement centring and shuttering in foundation and plinth.

First class burnt brick work laid in cement sand mortar 1:3 in foundation and plinth

Cold twisted detormed (Ribbed/ Tor steel) Bars (Fe 500 grade as per IS 1786-2008) , for R.C.C works, where not including in the complete rate of RCC including bending and binding placing in position complete

MS GARGA ASSOCIATES