Repairing and Rewinding of 3 phase submersible motor pump set and centrifugal / Mono block / Submerged mono block pump set under PHED Sub Div. Baran

Repair Rewinding of Submersible motor includes full servicing and rewinding (wherever required) as per manufacturer's specification and to the satisfaction of Engineer Incharge. It includes the replacement of minor parts such as bushes (oil seal bush) Nut Bolts, washers, cable seal, gland ring, vent plug, water drain plug, etc. complete job

Above 7-5 HP to 10 HP V-6

Above 10 HP to 12.5 HP

Above 12.5 HP to 15 HP

Above 17.5 HP to 20 HP

Particulars of spare parts of submersible Motor

Providing & Replacement of G.M./S.S. Bushes for all types of motors (per set of 4Nos.) including cost of sleeves

Providing & Replacement of thrust bearing for all types of motor. It includes cost of all components connected with thrust bearing.

Replacement of thrust plate for all types of motors

Motor opening cable jointing & refitting charges when rewinding is not required.

Providing & fixing Gun metal Diffuser/ guide vans per piece

Cooling Fan

GM/SS bush

10 HP to 20 HP

Mechanical reconditioning of Bearing sheet

10 HP to 20 HP

Mechanical reconditioning ofImpeller sheet and Key way slot

10 HP to 20 HP

Oil seal

10 HP to 20 HP

JOB WORK FOR REPAIR OF PUMP MOTOR

Supply & Fixing of tyre coupling sets according to relevant IS code in Centrifugal couple pump sets of approved make Unit. This job also included re-alignment of centrifugal couple pump set after fixing of tyre coupling set as per directed by Engineer-in charge.

Type 15 Nos. set

Type 16 Nos. set

Supply and fixing Ball bearing of Various size for centrifugal/monoblock pump set of ISI Mark as per specification and approved make by EIC.

6305 or equivalent size

6306 or equivalent size

6311 or equivalent size

6312 or equivalent size

Suuplying of super enamal copper wire suitable for rewindind of induction motor (only procured for motor rewinding)

Please Enable Macros to View BoQ information