Construction of Boring and Iron Pipe Partition for Stairs in New Building UDA Campus. 0503

Item Code [2022 12.46.1 Enamel paint]:Item Type [building] :: Painting with synthetic enamel paint of approved brand and manufacture to give an even shade : Two or more coats on new work

Item Code [2022 2.16]:Item Type [building] :: Sub Item Code [2022 2.16 + 2.16.4 a]: P & F Gun-metal Non-return Valve or Check Valve (IS : 778 Make) of approved make, superior quality: 32mm nominal bore. Horizontal

Item Code [2022 9.8 gate & grating]:Item Type [building] :: Providing and fixing steel gate, grating , and grills made of angles, tees, square bars, flats,or black pipe with holdfast and fittings complete as per design and drawing including cutting welding and fabrication with priming coat of red oxide

Item Code [2022 9.8.1 ]:Item Type [building] :: Extra if square,rectangular hollow tubelar sections are used or grill made by flats only

Item Code [2022 S 4.2.3]:Item Type [building] :: Construction of Tube-well upto 100 Meter depth and above in all type of rocks by DTH system and over burden, to accommodate casing pipe of following sizes in all types of soils and over burden including lowering of casing pipes, but excluding cost of casing pipes as per IS : 2800 (Part I & II) 1979 specifications. The work would be completed after obtaining sand free water. The tube well should have a throughout bore as per nominal dia of casing pipe: 150 mm dia Nominal bore

Item Code [2022 S 4.5.3]:Item Type [building] :: Supply of ERW M.S. black casing pipe ISI marked (IS:4270/1992) of grade Fe410 of following sizes at site of work. 150 mm Nominal bore of pipe

Item Code [21.1-2022]:Item Type [Electrical] :: Sub Item Code [21.1-2022 + 21.1.1]: Labour charges for installation of submersible motor pump set including lowering/ delowering of pipes, cables, accessories etc. in tube-well/ open well complete including T&P, transportation of tripod, chain pulley block & any other material required for this purpose complete in all respect. Lowering only

Item Code [21.13-2022]:Item Type [Electrical] :: Sub Item Code [21.13-2022 + 21.13.2.2]: SITC of Contactor OEM Fabricated DOL/Star-Delta Starter panel with switchgear selection as per Type-2 Cordinatiom Chart and made out from 1.6 mm thick powder coated CRCA sheet, enclosure comprising of over load protection relay, short circuit & single phasing protection, Illuminated ON / OFF push buttons, ammeter, voltmeter, indicating lamps etc. suitable for following rating motors complete in all respect. All as per pre approved by Engineer in charge. For additional technical parameters of products/ work , refer Annexure A attached with this BSR . For Three phase Submersible / Mono block pump 3.0 HP to 5.0 HP ( DOL starter )

Item Code [21.3-2022]:Item Type [Electrical] :: Sub Item Code [21.3-2022 + 21.3.2]: Providing & Laying of Polypropylene rope Confirming to IS:5175 for submersible pump of following sizes. complete in all respect. All as per pre approved by Engineer in charge. For additional technical parameters of products/ work , refer Annexure A attached with this BSR . 16mm (suitable above 50mm & up to 75mm OD pipe)

Item Code [21.4-2022]:Item Type [Electrical] :: Sub Item Code [21.4-2022 + 21.4.1.2]: Providing & Fixing of HDPE pipe Confirming to IS:4984:2021 for water supply suitable for submersible & jet pump with required fittings ie socket, elbows, tee etc. complete in all respect. All as per pre approved by Engineer in charge. For additional technical parameters of products/ work , refer Annexure A attached with this BSR. for vertical installation 50 mm OD 6 kg / cm2