upgadation of Departmental Buildings by way of repiars/Renovation of functional Buildings under MH-4702 capital outlay infrastructure structure I AND FC Sub-Division office Building Kishtwar.

Amount

Painting on G.S sheets with synthetic enamel paint of approved band and manufacture of required colour to give an even shade on New work (two or more coats) including a coat of approved steel primer but excluding a coat of mordant solution.

Applying a coat of mordant solution on G.S. sheets:With a solution of 38gms of copper acetate in liter of soft water

Brick work with common burnt clay (non-modular) bricks of class designation 7.5 in foundation and plinth including curing in : Cement mortar 1:6 ( 1 cement : 6 coarse sand)

Half brick masonry with common burnt clay (non-modular) bricks of class designation 7.5 in foundations and plinth including curing in : Cement mortar 1:4 ( 1 cement : 4 coarse sand)

Extra for brick work with common burnt clay bricks/cement concrete bricks in superstructure above plinth level upto floor five level

Cement concrete flooring 1:2:4 (1cement: 2 coarse sand: 4 graded stone aggregate) finished with a floating coat of neat cement including cement slurry and curing complete, but excluding the cost of nosing of steps etc. complete.50 mm thick with 20mm nominal size stone aggregate.

15mm Cement plaster on the rough side of single or half brick wall of mix: 1 : 6 ( 1 cement : 6 fine sand)

Providing and fixing PTMT tower bolts with 12 mm one piece rod inside and necessary screws etc. Complete 152x42x18mm weighing not less than 60gms

Supplying and fixing rolling shutters of approved make, made of required size M.S. laths, interlocked together through their entire length and jointed together at the end by end locks, mounted on specially designed pipe shaf with brackets, side guides and arrangements for inside and outside locking with push and pull operation complete, including the cost of providing and fixing necessary 27.5 cm long wire springs manufactured from high tensil steel wire of adequate strength confirming to IS:4454 part-1 and M.S. top cover of required thickness for rolling shutters. 80x1.25 mm M.S. laths with 1.25 mm thick top cover

Providing and laying rectified Glazed Ceramic floor tiles of size 300x300 mm or more (thickness to be specified by the manufacturer), of 1st quality conforming to IS : 15622, of approved make, laid on 20 mm thick cement mortar 1:4 (1Cement : 4 Coarse sand), including grouting the joints with white cement and matching pigments etc., complete.In colour such as White, Ivory, Grey, Fume Red Brown

Suppling installation testing and commissioning of exhaust fan complete with connection as required

Suppling installation testing and commissioning of 50 Ltr Gryser complete asrequired approved brand .of approved brand.

Suppliying and fixing of following size dia PVC conduit including cost of junction boxes, bends, elbows, sockets, tees etc. laying in slab cutting, chases and making good or surface mounted including all fixing hardware as required.(a) 25 mm Dia

Wiring for the following ligth points and exhaust fan points with 1.5 Sqmm PVC insulated copper wires of approved make in concealed or surface mounted PVC concuit including providing and fixing of 06 Amp single pole switch of app Quality modular grid plate and G.I box and Earthingof fictures and the outlet box with 1.5 sqmm PVC insulated copper wire (make havells, anchor,GM, or equivalent approved by the site engineer) (a) One light controlled by 06 Amp Switch

Wiring for 240 volts single phase and neutral 16 amps switch socket outlet with 04 sqmm PVC insulated copper wire in concealed or surfaced mounted PVC conduit including providing and fixing of 16 Amp 03 pin switched socket of approved make with modular grid plate and earthing the third pin of socket outlet with 1.5 sqmm PVC insulated copper wire complete as required (make havells, anchor, GM, or equivale approved bythe site engineer)

Supply and fixing of following size mcb's completewith connection as required (make Schneider, anchor, legrand, ABB, or equivalent approved by the site engineer) (a) 6-32 amp SP

Supply installation testing and commisoining of pre wired 12 watt led light surface mounted/recessed complete with connection as required (make havells, anchor,GM, halonex or equivalent approved by the site engineer

Shifting of Dumped (stacked) Ductile 250 mm, 200 mm, 150 mm Ductile from sub-Divisional office compound to near by Store yard to be paid as per actual job of 40 Labour

Carriage of bricks from notified Site for an .avg Distance 150 Km by Mtrp.

Carriage of sand from road side to site of work for an avg. distance 25 kms by M.T

Carriage of bajri from road side to site of work for an avg. distance 06 Km by M.T

Carriage of Cement from Road Side to site of work for an .avg Distance 02km by M.T

Mohd Yaseen Malik