Providing GWSS Ayog Sandoa in Tehsil Suni Distt. Shimla HP

Amount

description of item

Excavation in foundation trenches etc.in earth work,lift up to 1.50 mtrs,stacking the excavated soil not more than 3 mtrs clear from the as of excavation and then returning the excavated soil in 15 cm layer when ewquired into plinths sodes of foundations etc. concolidating each deposited layer by ramming and watering and then disposing of all surplus excavated soil as directed within a lead of 20 mtrs.

Providing and laying cement concrete 1:3:6 (1 cement : 3 sand : 6 graded stone aggregate 40mm nominal size) and curing complete excluding cost of form work in:-

Foundation and Plinth.

Providing and laying cement concrete 1:1½:3 ( 1 cement : 1½ sand : 3 graded stone aggregate 20mm nominal size) and curing complete excluding cost of form work & reinforcement for reinforced concrete work in:-

Foundation and Plinth.

Walls (any thickness but not less than 0.1 m thickness) attached pilasters, buttresses, plinth and string courses etc. from top of foundation level up to floor two level.

Providing form work with steel plates 3.15 mm thick welded with angle iron in frames 30x30x5 mm so as to give a fair finish i/c centring ,shuttering, strutting and propping etc. with wooden battens & ballies, ht. of propping & centring below supporting floor to ceiling not exceeding 4 mtrs. & removal of the same for insitu-reinforced concrete work in :

Vertical surfaces such as walls ( any thickness ) partitions and the like including attached pilasters , buttresses, plinth and string courses and the like .

Providing mild steel/tor Steel reinforcement for R.C.C work including bending , binding and placing in position complete up to floor two level.

Applying Birla White wall care Putty over plaster surface after throughly brushing the surface free from mortar drops , dust , loose , materails and other to give matters sand parpered smooth to give final matter finish to the surface complete .

Laying and Jointing in trenches, GMS Tubes (Light Grade), Tube fittings (earth work in trenches to be measured and paid for separately). (Scour Pipe) 50mm dia

Prov. and fixing Brass Full Wheel Valve. 50 mm nominal bore

Providing smooth finishing in cm 1:3

Steel work weidedin built up section, trusses and framed work i/c cutting,hoisting,fittingin position complete in grating ,framed guards & ladders etc. (V.M 40x40x5mm &H.M 25x25x4mm

laying and jointing high density polyethylene pipes for use for buried water mains and services and for water supply above ground, both inside and out side building duly ISI marked (IS : 4984-1995 as amended up to date in the following grades of material, pressure rating and nominal dia. Material Grade -PE-63/80 PN-4 including all leads & lifts at site and as directed by the Engineer- Incharge.

40mm dia (PE-63 PN-4)

50mm dia (PE-80 PN-4 )

Providing and fixing Polypropylene Ball valve without flange end including all leads, lifts and carriage of material at site and as directed by the Engineer Incharge.

40mm dia

50mm dia

Making connection of HDPE distribution branch with HDPE main 20mm to 50mm nominal bore by providing and fixing saddle clamps including nipple, pvc valve complete in all respect

Lokesh Kumar (BID ID -502586)

Kamlesh Kumar (BID ID -501927)