MISC BR REP INCL PLASTERING PLUMBING TILING ROOFING FLOORING CEILING SANITARY FITTINGS BLOCK MASONRY WALL AND OTHER MISC WORKS OF MD OTM ACCNS OF TB I CIW HRDC COMPLEX AND BEG CENTRE UNDER AGE BR II IN GE C KIRKEE

Amount

Dismantling of wall and ceiling boards (fibre,pulp insulation, AC plain sheets etc), any thickness including cover fillets complete.

S&F interlocking aluminium alloy anodised snap grid consists of main Tee runners of size 38mm x25mm x1.5mm spaced 1200mm centre to centre and cross Tee of size 25mmx25mmx 1.5mm, 1200mm long spaced between the main Tee at 600mm centre to centre to form a grid of 1200mmx600mm and provide a secondary cross tee 25mm x1.4mm ( of length 600mm) to be interlocked of the centre of 1200mmx600mm panel to form a grid of 605mmx605mm and wall angle 25mmx25mmx 2mm. Aluminium alloy extruded section shall be aluminium anodised (minimum 15 micron ) and shall conform to IS 733, IS 1285 and IS 737. including Hangers of GI wire 6mm dia (upto1200mm length)adjusting level fixed to roof by means of ceiling cleats made out of flat iron 40x3mm size and 60 mm long expansion hold fastners 12.5 mm dia,40 mm long complete all as specified and as directed.

Providing and fixing Gypsum Board 8 to 9 mm thick in ceiling fixed with screw as per manufacturers instructions complete all as specified and as directed.

Taking down cement plaster from brick or block masonry walls including raking out joints, hacking for key, scrubbing down with water etc.complete all as specified and as directed.

M&L rendering 15 mm thick in cement mortar (1:6) on fair faces of block masonry surfaces or fair faces of brick work complete all as specified and directed.

M&L rendering 15 mm thick in CM (1:4) on faces of block masonry surfaces or surface other than fair faces of brick work including mixing waterproofing compound @ 3% by weight of cement complete all as specified and directed.

M&L for two coats of distempering walls with distemper dry, white or tinted over a coat of chalk whiting primer, on newly plastered surfaces, preparatory to distempering including preparing of new plastered surfaces of walls.

M&L for preparation of new plastered surfaces of wall and applying two coat cement paint over a coat of chalk whiting primer complete all as specified and directed by Engr - in - Charge.

Dismantling water tanks AC/PVC of any type and any position from site of capacity exc 1000 litres n.exc 2000 ltrs complete all as specified and directed.

Dismantling water tanks AC/PVC of any type and any position from site of capacity exc 500 litres n.exc 1000 ltrs complete all as specified and directed.

Dismantling water tanks AC/PVC of any type and any position from site of capacity exc 250 litres n.exc 500 ltrs complete all as specified and directed.

S& F for Rotational moulded polyethylene water storage tank 2000ltr (cylindrical vertical with closed top) hoisted and fixed in position all as specified and directed.

S& F for Rotational moulded polyethylene water storage tank 1000ltr (cylindrical vertical with closed top) hoisted and fixed in position all as specified and directed.

S&F for Rotational moulded polyethylene water storage tank 500ltr (cylindrical vertical with closed top) hoisted and fixed in position all as specified and directed.

Supply and fixed in repair Ball PVC valves, high pressure, with polythene float and flynut complete, screwed for iron pipe or brass ferrule and fixed in 20 mm dia of the pipe.

Demolition of cement concrete (unreinforced) of any description and in any position not other wise specifically provided for all as specified.

Dismantling of floor hearth or wall tilling incl cement mortar bedding and removing rubbish off the premises complete all as specified and as directed.

Demolition of stone slabs/flooring of any description laid bedded and pointed any mortar complete all as directed.

M&L for PCC (1:2:4) type B-0, 25 mm thick using 12.5 mm graded coarse aggregates as in sub base for receiving floor tiles.

M&L for vitrified ceramic tiles 10 mm thick light shade, (square/rectangular) polished, area of each tiles not exceeding 0.36 Sqm in floors etc. set and jointed in neat cement slurry and pointed in white or coloured cement to match over 15 mm thick screed bed in CM (1:6) complete all as specified.

M & L for Non skid ceramic coloured tiles 7 to 8mm thick (square or rectangular) area of each tile exceeding 0.11 sqm but not exceeding 0.18 sqm, in floors etc. set in neat cement slurry and pointed in coloured cement to match coloured tiles including 15mm thick screed bed in CM (1:6) complete all as specified and as directed.

M & L for Non skid ceramic coloured tiles 7 to 8mm thick (square or rectangular) area of each tile exceeding 0.06 but not exceeding 0.11 sqm in floors etc. set in neat cement slurry and pointed in coloured cement to match coloured tiles including 15mm thick screed bed in CM (1:6) complete all as specified and as directed.

M&L for Glazed ceramic coloured tiles in vertical surface 450 X300 X7 mm thick set and jointed in neat cement slurry and pointed in white or colour cement to match including 10 mm thick cement plaster (1:4) as backing coat complete.

M & L for glazed ceramic coloured tiles (300x200mm) x 7 mm thick in Dado/Skirting set and jointed in neat cement slurry and pointed in white or coloured cement to match coloured tiles including 10 mm thick backing coat plaster in CM (1:4) complete all as specified and as directed.

M&L for machine cut kota stone slab flooring 20-25 mm thick over cement screed base laid and jointed with grey cement slurry mixed with pigment to match the shade of the slab including rubbing and polishing complete laid over including 15 mm thick screed bed in CM (1:6) complete all as specified.

M&L for kota stone slab 20-25 mm thick in riser of steps, skirting, dado and pillar laid over cement screed and jointed with grey cement slurry mixed with pigment to match the shade of the slab including rubbing and polishing complete laid over including 10 mm thick backing coat plaster in CM (1:4) complete all as specified.

Rounding to edges of stone slabs one edge, such as in steps, cooking platform and other similar situations.

Supply only integral water proofing compound.

M & L 75mm thick PCC type C2 1:3:6( using 40mm graded aggregate) as in plinth protection complete all as specified and directed.

S&F Cast Iron floor trap, with grating of outlet 75 mm dia including jointing to waste pipe fixed in cement concrete type B-1 (1:2:4) in repairs and including water leak proof treatment complete all as specified.

S&F in repairs for Vitreous China wash down water closet pan (EWC) (Pedestal pattern), white (excluding fixing bolts, flushing cistern and flush pipe) including connection to down or out going pipe and to flushing pipe and syphonage pipe etc. of approved quality complete.

S& F in repairs water closet (Squatt Pattern) complete incl provn of lime concrete bedding Orissa pattern size 580 x 440mm white integral foot rests (excluding flush pipe or flushing cisterns) including connection to trap and flushing pipe anti syphonage pipe etc complete and making good to floor.

S&F in repairs PVC High/Low level flushing cistern 10 litres capacity including all fittings i.e. float valve, syphon, flushpipe,brackets all as specified and directed by Engr-in-Charge.

M&L for Viterous China urinals, bowl type (back to corner wall type), complete including providing and fixing plus, beding urinal agianst wall in cement mortar 1:2 securing urinal to plus with and including 60mm long brass screws, pointing aroiund urinal back in cement; fixing automatic flushing cistern with brackets, flush pipe, grating and Union for discharge pipe. (Exclusive of fixing supply pipe to flushing cistern, trap and waste pipe).

Hacking out old broken glass (any thickness, size, quality or description) from wooden frames or stone, concrete or brick surrounds, glazed with putty or fixed with beads including punching or dril;ling out old glazing pins/spring clips etc complete all as specified and directed.

S&F 3 mm thick sheet glass, ordinary quality and glazing with oil putty in square n. exc 0.5 sq.m in each pane complete all as specified.

S&F 3 mm thick sheet glass, ordinary quality and glazing with oil putty in square n. exc 0.5 sq.m in each pane but frosted type.

S&F water closet seat cover black, closed pattern with flat bottom, and cover and mild steel chromium plated or aluminised hinging device.

S& F PVC connections 15mm dia with brass nut on both ends and washers 450mm long all as specified and directed by EIC.

S&F in repairs bib taps cast copper alloy with butterfly handle screwed down screwed for iron pipe or for brass ferrule 15 mm dia all as specified.

S&F in repair for stop valve, cast copper alloy screwed down, high pressure, with butterfly handle , screwed both ends for iron pipe or for unions, 15 mm bore complete.

S&F in repairs vitreous china wash hand basin white flat back size 550x 400 excluding taps waste chain and plug and porcelain stopper but incl necessary brackets CP brass wastes coupling and other fittings all as specified.

S&F in repairs pillar taps, cast copper alloy, with capstan heads, chromium plated, screwed down high pressure, with or without lettered 'Hot' or 'Cold' with long screwed shanks and fly-nuts, screwed for iron pipe and fixed with 15 mm bore pipe.

S&F in repairs 15 mm bore medium grade galvanised with all fittings and fixed complete to walls and ceiling or laid in floor etc complete all as specified including taking up or down steel tubing and connections including cleaning for re-fixing or removing from site complete all as specified and as directed.

S&F in repairs 20 mm bore medium grade galvanised with all fittings and fixed complete to walls and ceiling or laid in floor etc complete all as specified including taking up or down steel tubing and connections including cleaning for re-fixing or removing from site complete all as specified and as directed.

Dismantling battens for tiles singles etc of any size spaced exc 15cm complete all as specified and directed.

Dismantling of CGI/ Galvalume/ PGI sheets in roof coverings complete all as directed.

Dismantling single layer mangalore pattern or similar tiles in roofing complete all as specified and directed.

Dismantling timber scantlings 40sqcm & over in section from unframed work in any position complete all as specified and directed.

Dismantling Battens of spacing n exc 15cm for tiles, shingles etc, of any size including tilting fillets all as specified and as directed.

M&L for second class hard wood scantlings, clean sawn fixed in any position, roof etc complete all as specified and directed.

M&L for 2nd class hard wood size n exc 15sqcm sectional area at 30cm centres complete all as specified and directed.

M&L for roof tiles mangalore pattern interlocking at side joints, laid dry complete all as specified and directed.

M&L for ridge or hip tiles to suit mangalore pattern of roofing tiles bedded and jointed in cement mortar (1:6) complete all as specified and directed.

S&F Pre- painted galvalume aluminium zinc coating GI based corrugated steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding to wall, fixed with self tapping screws as specified (AS-3566 class-III) ( colour of sheet as approved by Engr in charge).

S&F for Pre-painted galvalume aluminium zinc coating GI based Plain steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as in roof ridges, fixed with self tapping screws as specified.

MANIYA CONSTRUCTION CO.

Veekay Enterprises

V.R.PRAJAPATI AND CO.

S.R.M.K Enterprises

L.K.R.TIWARI CONSTRUCTION

greenstone construction