Civil Work

Amount

Earth work excavation for foundation in all soils and sub - soils and to full depth as may be directed expect in rock requiring blasting inclusive of shorting strutting, balling out water wherever necessary and depositing the excavated earth with a lead of 10m within the compound in places shown by the departmental officers and clearing and leveling the site, etc., complete complying with standard specification. (single rate)

Supplying and filling in foundation and basement with crushed stone sand (commercially called M-sand) in layers of not more than 15 cm thick well rammed, watered, consolidated etc., complete complying with standard specification and as directed by the departmental officers.

Supplying and filling in foundation and basement with Stone Dust of not more than 15cm thick well rammed, watered, consolidated etc., complete complying with standard specification and as directed by the departmental officers.

Laying the Plain Cement Concrete M-5 Grade using 40 mm gauge hard broken granite stone jelly for foundation and basement including dewatering if found necessary and laid in layer of not more than 15cm thick and consolidated etc.,complete complying with std. specification and as directed by the deptl.officers.

Supplying and erecting steel centering including necessary supports for plane surfaces for Reinforced Cement Concrete works such as column footings, column pedestals, plinth beams, grade beams, staircase steps, etc. which require only nominal strutting using mild steel sheets of size 90cm x 60cm and 10 BG stiffened with welded mild steel angles of size 25mm x 25mm x 3 mm for boarding, laid over silver oak joists of size 10cm x 6.5cm spaced at about 75cm centre to centre or at suitable intervals etc. complete in all floors complying with standard specifcation. (Payment for centering shall be given after the concrete is laid)

Supplying, fabricating and position of steel reinforcement using mild steel or ribbed TOR steel rods for all RCC works as per design given by the deptl.officers including cost of steel and binding wire in all floors complying with standard specifications.

Providing and laying in position, Standardised Concrete Mix M-30 Grade in accordance with IS:456 2000,using 20mm and down graded hard broken granite stone jelly for all RCC items of works with minimum cement content of 400 kglms and maximum water cement ratio of 0.45, including admixture (plasticiser / super plasticiser) in recommended proportions as per IS:9103 to accelerate, retard setting of concrete, improve workability without impairing strength and durability with about (5.0 cu.m.) 7730 kg. of 20mm machine crushed stone jelly and with about (3.3 cu.m.) 5156 kg. of 10-12mm machine crushed stone jelly and with about (4.79 cu.m') 7670 kg. of sand, but excluding cost of reinforcement grill and fabricating charges, centering and shuttering and also including laying, vibrating with mechanical vibrators, finishing, curing, etc. and providing fixtures like fan clamps in the RCC floor/ roof slabs wherever necessary without claiming extra, etc., complete complying with standard specification and as directed by the departmental officers. The coarse and fine aggregates to be used should comply with the requirements of IS Standards. (No separate payment will be made by the Department for the excess usage of materials).

For foundation and basement

For ground floor upto 4.50 m height (+)

Brick work in Cement Mortar 1:6 (One cement and six sand) using Fly Ash Bricks of 230 x 110x75mm size conforming to IS:12894-1989 Class designation not less 50 kg./ sq.cm. average compressive strength in cement mortar 1:5 for load bearing structures for foundation and basement and for superstructure including curing,etc.,complete complying with standard specifiction.

For foundation and basement

For Ground floor upto 4.50 m height (+)

Plastering the walls with Cement Mortar 1:5 12mm thick using the P-sand including curing and finishing neatly complying with standard specification and as directed by the departmental officers etc. complete.

Paving the floor with best approved quality double charged vitrified tiles of size 600 x 600 x 8 mm thick over a base layer of cement mortar 1:3 (One cement & three m-sand) 20mm thick and laid straight alignment and fixing in position etc., complete complying with standard specification and as directed by the departmental officers. The colour & quality of tiles should be got approved by the executive engineer before use on work.

Renewing and fixing new one of M.S grill using square or round bars, flat, etc., for outer frame and internal members for providing doors, window, ventilators, gates etc., as per design appd. and directed by the deptl. officers including dismantling the masonry and finishing to the original condition labour for fabrication fixing with new wassart clamps and finishing with new one of primer of approved colour and quality etc., complete.

Renewing and fixing new one of weld mesh screen of size 75 mm x 25 mm 10 gauge fixing over the frame work in position using welding machine with help of welding rod and labour charges for preparing the weld mesh screen and fixing in position in the window position including painting with two coats of SEP of approved quality and brand over a priming coat with necessary leads, lifting charges from ground floor to eight floor etc., complete.

Renewing and Refabricating the structural steel work to the required profiles as per the attached GA drawings including fabricating the rafters / top chords to the required dimensions to meet the actual site requirements and joining with riveted/ bolted or welded connections in built up sections in trusses, framed work, Rigid Portal frames, columns, beams , girders, bracing etc with hot rolled steel sections and MS plates conforming to IS standards all complete as per approved structural drawings and as per the directions of the Engineer-in- charge. Rate is inclusive of complete Tranportation,fabrication, erection, painting with one coat primer & two coats of enamel paint with all lead & lift using 100 MT lifting crane etc complete.

Providing and Fixing of polyurethane foam as External Wall Thermal insulation panels or Sandwich insulated panels with external 0.50mm total coated thickness pre painted galvalume sheet with micro ribbed profile, whereas internal 0.50mm total coated thickness pre painted galvanized iron sheet with micro ribbed profile and the insulation material will be chlorofluoro carbon and hydro chlorofluoro carbon free, high performance rigid polyurethane foam (PUF) conforming to IS 12436 having density not less than 40±2Kg/M3, Thermal conductivity (K-Value) 0.024 W/m.K measured at 10 degree C mean temperature along with necessary flashings such as L flashing, C flashing etc& accessories such as screws ,fastners ,sealants etc for fixing the panel etc., complete complying with standard specification.

50mm thick PUF external wall panel

Providing and Fixing of polyurethane foam for Sloped roofas thermal insulation panels or Sandwich insulated panels with external 0.50mm total coated thickness pre painted Galvalume sheet with trapezoidal roofing profile having crest height of 38mm at every 333mm span , whereas internal 0.50mm total coated thickness pre painted galvanized iron sheet with micro ribbed profile and the insulation material will be chlorofluoro carbon and hydro chlorofluoro carbon free , high performance rigid polyurethane foam (PUF) conforming to IS 12436 having density not less than 40±2Kg/M3, Thermal conductivity (K Value) 0.024 W/m.K measured at 10 degree C mean temperature along with necessary flashings such as L flashing, C flashing etc& accessories such as screws, fastners ,sealants etc for fixing the panel etc., complete complying with standard specification.

50mm (+38mm) thick PUF roof panel

Supplying and fixing of acrylic sheet of 3 mm or 4 mm thick of good approved quality and should be fixed over the existing framed window with a help of necessary screws, nails, beading, etc. The rate is including of cost of acrylic sheet and hire charges for cutting machine for cutting the sheet to required size and labour charges for fixing the sheet in position and finishing neatly etc., complete complying with standard specification and as directed by the departmental officers.

Providing 8 seater type SS Dining table with seating arrangements including all as per required design etc., complete complying with standard specification and as directed by the departmental officers.

Manufacturing, Supplying and Fixing of Stainless Steel Hand rails for staircase using 50mm dia 304L Grade Stainless Steel pipe of 1.60mm thick at required locations to a height of 900mm from finished floor level welded to 38mm dia Stainless Steel pipe post of 1.00mm thick as vertical at 900mm centre with 2 Nos. of 25mm dia intermediate horizontal stainless steel pipe of 1.60mm thick in between. The vertical pipe has to be welded to the 100 X 100 X 6mm MS base plate encased in the base concrete. The rate is inclusive of the charges for cutting, bending, welding, grinding, polishing, conveyance, electrical charges, etc. complete

Re-painting the old walls with two coats with first class quality Plastic Emulsion Paint of approved colour over a priming coat including through scrapping, clean removal of dirt. The rate includes cost of brushes, sand paper, plaster of paris, putty wherever required and neat finishing etc., complete complying with standard specification and as directed by the departmental officer. (The colour and quality should be got approved by the Executive Engineer before use)

Painting the new iron works two coats with synthetic enamel paint of approved quality and colour including through scrapping using brushes and neat finishing etc., complete complying with std. specification and as directed by the departmental officers. (to be approved by Exe. Engr before use)

Collecting the scattered debris from the campus and conveying away the same to outside by lorry to a lead of 3 km (entirely within city limit) including loading un-loading charges and dumping in low places and levelling neatly etc.,complete.

GST at 18%

RPP INFRA PROJECTS LIMITED (BID ID -1212268)