Loading
Loading…
Loading…
Tender Value
₹2.3 Cr
EMD Value
₹4.7 L
Closing Date
30 Apr 2026, 3:00 pmClosed
No
No
Single Packet System
Normal Tender
No
Not Applicable
Lowest to Highest
60 days
Expenditure
Capital (Works)
SOUTH
14 conditions · 2 needing a document upload
The tenderer must have minimum average annual contractual turnover of V/N OR 'V' Whichever is less; where. V= Advertised value of the tender in crores of Rupees N= Number of years prescribed for completion of work for which bids have been invited. The average annual contractual turnover shall be calculated as an average of "total contractual payments" in the previous three financial years, as per the audited balance sheet. However, in case balance sheet of the previous year is yet to be prepared/ audited, the audited balance sheet of the fourth previous year shall be considered for calculating average annual contractual turnover. The tenderers shall submit requisite information as per ANNEXURE-XXXIII, along with copies of Audited Balance Sheets duly certified by the Chartered Accountant/ Certificate from Chartered Accountant duly supported by Audited Balance Sheet.
a)The tenderer must have successfully completed or substantially completed any one of the following categories of work(s) during last 07 (seven) years, ending last day of month previous to the one in which tender is invited: (i)Three similar works each costing not less than the amount equal to 30% of advertised value of the tender, or (ii)Two similar works each costing not less than the amount equal to 40% of advertised value of the tender, or (iii)One similar work costing not less than the amount equal to 60% of advertised value of the tender.
Defination of Similar Work :- Trenching cable laying location and /OR signal foundation/ erection/ termination/wiring in connection with any signalling work
8 conditions · 1 needing a document upload
Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.
Tender document, Scope of work & GCC 2022 are attached with the tender.
Signalling work in connection with CTR/TTR works in South section of Mumbai Division.
CR-BB-SNT-SOUTH-2026-39
CR-BB-SNT-SOUTH-2026-39
Open
Works - General
12 Months
Mumbai, Maharashtra
₹0
₹4.7 L
30 Apr 2026
8 Apr 2026
16 Apr 2026
12 items across 1 schedule · ₹1,37,26,736.44 total
| # | Description | Unit | Qty | Rate | Amount |
|---|---|---|---|---|---|
| 1 | High speed steel twist drill bit dia 7mm/13 mm suitable forbattery operated drill machine make Eibenstok. Drill bitmake: MAKITA/BOSCH/FEINor Other reputedbrandI(Inspection Agency-Consignee) | Numbers 1000.00 | — | — | — |
| 2 | Digital current clamp meter to measure current leaks parasitic draws down to 1 mA and electric load from 1 mA to 100 Amp AC/DC, and voltages from 0 to 600 V AC/DC, small jaw size to measure current in signaling circuits, 4 digit display. make FLUKE/ GTC/KOICO or superior with better specification mentioned with all accessories like test lead, batteries and carrying case, sample may got approved from consignee before supply.(Inspection Agency- Consignee) | Numbers 18.00 | — | 24,381.82 | 4,38,872.76 |
| 3 | Casting of cement concrete to protect S&T equipments and laid cables, above pipes, store etc by concrete mixture of cement, sand, stone in the ratio of 1:2:4 using 25 mm graded stone aggregate as per instruction of site in charge of railways. Concrete is to be casted with the help of suitable size shuttering form as per site requirement. Concrete is to be cured for sufficient time as per standard practices on railways(Inspection Agency-Consignee) | cum 14.00 | — | 4,266.5 | 59,731 |
| 4 | Execution of S & T work related to signalling/ enginnering block, in one block, five unskilled manpower have to be provided during block for S&T connection removing & refixing as per Railway site engineer instruction.(Inspection Agency-Consignee) | Job 980.00 | — | 3,971.52 | 38,92,089.6 |
| 5 | Wheel sensor with protection tube of Frauscher make MSDAC type Rsr 180 (with BBIK- M 12 GS05 fixing along with cable length of 5 mtr (GS05)(Inspection Agency-RDSO) | Numbers 12.00 | — | 1,65,364.02 | 19,84,368.24 |
| 6 | Wheel sensor with protection tube of Frauscher make MSDAC type Rsr 180 (with BBIK- M 12 GS05 fixing along with cable length of 10 mtr (GS05)(Inspection Agency-RDSO) | Numbers 3.00 | — | 1,71,264.02 | 5,13,792.06 |
| 7 | Wheel sensor with protection tube of Frauscher make MSDAC type Rsr 180 (with BBIK- M 12 GS05 fixing along with cable length of 15 mtr (GS05)(Inspection Agency-RDSO) | Numbers 2.00 | — | 1,76,276.66 | 3,52,553.32 |
| 8 | Deflector set for Digital axel counter , each set consists of 2 delfector plates each suitable for protecting TX and RX coil(Inspection Agency- Consignee) | Numbers 1000.00 | — | 3,894 | 38,94,000 |
| 9 | Repairing of location foundation with masonarywork. This also includescleaning the locations, sandfilling in the location and plastering inside the location as per requirement(Inspection Agency-Consignee) | Numbers 200.00 | — | 3,166.69 | 6,33,338 |
| 10 | Arrangement of Battery operated RailCore Drill alongwith additional 18 mmTCT Rail Core Drill , Maximum corecutting capacity : 36 mm, Ratedspeed: 250/450 RPM, Battery type:Li-on, Battery voltage: 50 Volt,Battery pack capacity: 4 AH, Numberof Battery supplied: 2 Nos, Number ofCharger supplied: 1 No, Specialdesign pressurized Internal spindlecooling to give maximum life of corecutter and to avoid heating of the rail.Time taken to drill one hole of 32 mmin 60 KG 90 UTS rail section less thanone minute. Time taken to fix themachine on the rail, less than 2minutes and to de-clamp less than 1minute. 34 Number 32 mm diameterhole with full charge batteries (17hole per battery) in 60 Kg 90 UTS railsection. 3 Sets of standard center raildrilling adapters for gauge 90, 52, 49provided along with machine. Weightof machine with battery: 18.5 KG,Make: Eibenstock. Bosch,KPTL((Inspection Agency- Consignee) | Numbers 2.00 | — | 2,09,200.73 | 4,18,401.46 |
| 11 | Supply of DWC/HDPE pipe with onesnap fit coupler 'O' ring confirming toIS 14930 (Part 2: 2001) Non metallic,normal duty, pliable with protectionagainst chemical attack and fireresistant, anti rodent, in 6 meterlength of size 50 mm inner dia.(Inspection Agency- Consignee) | Metre 600.00 | — | 401.45 | 2,40,870 |
| 12 | Self-Fusing Rubber Electrical Insulating and Sealing tape consist of an ethylene propylenerubber (EPR) Backing coated with an aggressive, temperature-stable mastic adhesive. The tape is 50 MMWidth X 10 Feet length X 1.65 MM Thick for Quick Application Build ?Up. It is designed for electricalinsulating and moisture sealing applications. It can be used on copper or Aluminium Conductors rated at90 Degree Celsius, with an emergency overload rating of 130 Degree Celsius. It offers excellentresistance to moisture and ultraviolet exposure and is intended for both indoor and weather exposedoutdoor applications.MAKE : 3M,NITTO DENCO,ACHEM or similar. (SAMPLE TO GET APPROVED BEFOREBULK SUPPLY) (Inspection Agency-Consignee) | Numbers 500.00 | — | 1,652 | 8,26,000 |
| Schedule total | ₹1,37,26,736.44 | ||||
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
HTML
nit.pdf
NIT
GCC 2022
ATTACHMENT
CORRECTIONSLIP1to11GCC2022_compressed.pdf GCC CORRECTION SLIP 1 TO 11
ATTACHMENT
FINALNEWTENDERDOC2026-391.pdf
ATTACHMENT
GCC_April-2022_2022_CE-I_CT_GCC-2022_POLICY.pdf
ATTACHMENT
CORRECTIONSLIP1to11GCC2022_compressed.pdf
ATTACHMENT
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .