Construction of new 33 kv line from 220 kv S/S Dataganjto 33/11 KV S/S Dataganj Tehsil in district Budaun.

Amount

Note - Any material/Labour required to complete the work (which is not covered in above) will be provided by the firm.

Carriage of following line material for 33KV line from any Electy. Store Center of Electricity store division of Bareilly zone. including measuring, weighing, loading, unloading at both ends and proper stacking at safe site.

ST pole 11 Mtr.

PCC pole 9.0 M long

33 KV V type cross arm

Cross arm holding clamp

33 KV pin insulator

33 KV pin with nut

Disc insulator B&S type 70 KN

Disc fitting Dog/Raconn 70 KN

Earthing rod of 20x2500mm

G.I wire 8 Swg

Single Core Cable 1x400 sq mm

33 KV Line type Isolator 800A.

33 KV Lightening Arrestor

33 KV VCB 800A, 750 MVA

33 KV Control pannel I/C for single T/F

33 KV CT 200/100/1-1-1 A

M.S angle lron 65x65x6mm for bracing

T- Off Channel 125x65x1300mm

Top channel 125x65x6mm 3200mm long

MS Channel 125x65mm

MS Angle 75x75x8 mm

M.S.angle 65X65X6 mm

MS Angles 50x50x6mm

Complete Stay set

33 KV 3x300mm XLPE cable

ACSR Dog conductor

33 KV 3x300mm cable jointing kit O/D

Fabrication, erection and grouting of the following structures as per RESSPO/ Approved Drawing and its, plinth 30cm above ground leval as directed by the Engineer Incharge (All steel sections will be provided by Deptt).

33 KV Line Isolator Structure

33 KV Lightening Arrestor Structure

33 KV VCB Structure

33 KV CT Structure

Post insulator Structure

Installation of followig equipments on their respective structures including mechanical & electrical fixing after proper adjustment on their structure.

33 KV Line side isolator

33 KV Lightening Arrestor

33 KV VCB complete

33 KV CT (03 Nos)

33 KV Post insulator (will be provided by firm)

Complete laying and termination of copper control cables (fire resistance) from 33 KV VCB, 33 KV CT in the out door switch yard to the Transformer relay control panel inside the control room including cost of all materials and labour required for proper completion of works as per RESSPO drawings, including cost of testing of VCB, CT, relay pannel & proper relay settings as per requirement etc.

Laying of dog conductor alongwith cost of all required calmps and connectors etc. as per RESSPO Approved drawing of L.A., C.T., V.C.B., Bus Isolator etc.

Supply of GI strip of size 50x6mm for earthing of all newly erected structures and equipments in switchyard including cutting, fixing & proper welding with equipments. All LA will be seprately earth also as per RESPO norms. (All the required materials will be provided by firm and will be inspected by AE (Works) before installation.)

Making of M.S. Angle Ladder type frame of Angle (75x75x8mm) & GI Strip (50x6mm) near power transformer for power cable with concreting of the same in the ground and proper clamping (50x6mm) of the same with transformer cable.

Erection & testing of 1 No. single T/F Control panel in substation control room including grouting of anchor bolts of panel and making of pocket for control cable to insert in panel from trench and complete filling of control room's tranches by river sand.

Painting of the fabicated structures with one coat of red oxide primer and two coats of synthetic enamel alumm. Paint/green paint of ISI Mark alongwith earthing strip above ground level.

Erection of the following supports including cutting, making holes, fixing of all types of accessories digging of pits complete in all respect, as per RESSPO drawing. All types of clamps, stone pad, nut, bolt washers would be provided by the contractor.

Single support of S.T pole 11 mtr long.

Single support of PCC pole 9 mtr long.

Double pole structure on S.T. Pole 11mtr long complete with bracing.

Double pole structure on PCC Pole 9mtr long complete with bracing.

End type double pole structure on S.T. Pole 11mtr long complete with bracing.

Cable Exposer double pole structure on S.T. Pole 11mtr long complete with bracing.

Tri pole structure on S.T. Pole 11mtr long complete with bracing.

Four pole structure on S.T. Pole 11mtr long complete with bracing.

Concreting of supports at the time of erection of pole in 1:4:8 concrete ratio from bottom of pole to ground level and plinthing of supports upto 300mm above ground level by using cement, sand & coarse aggregate in ratio 1:4:8 as per RESSPO drawing with watering/curing properly upto proper setting of plinthing. All matrial would be provided by the contractor.

Erection of stay set with stay wire, stay clamp & stay insulator including with grouting of stay set by concrete of ratio 1:4:8 as per RESSPO norms before back fitting of the pits including binding, climbing, clamping, tightening and nozzeling of stay wire in all respect as per RESSPO norms. All clamps, nuts, bolts, stay insulator, cement. brick, ballast, sand etc would be provided by the contractor.

Laying and sagging of 3 phase ACSR Raccon conductor from double pole at 33/11 KV substation to double pole at tapping point of 11 KV feeder line including jumpering, hoisting, fixing of all type of insulators, binding, jointing and its clamping etc in all respect.

Earthing of each S.T Poles of the line is to be done by inserting the MS earth rod (1800x20mm) into soil by hammering and properly fastning with GI wire to each support by nut & bolt. Earthing rod must be 0.15Mtr.above from the plinth of the support. All type nut & bolt would be given by the contractor.

Earthing of each PCC Poles of the line is to be done by inserting the MS earth rod (1800x20mm) into soil by hammering and properly fastning with GI wire to each support and its accessories by nut & bolt. Earthing rod must be 0.15Mtr.above from the plinth of the support. All type nut & bolt would be given by the contractor.

Guarding of HT/LT/Telephone Line/ Road/River Crossing etc. by providing G.S Earth wire 7/16 SWG/GI wire No. 8/10 and making net with difference of 1.00 Mtr. Completely including fixing of channel/angle etc. with proper locking at each support as per RESSPO norms. All type nut &bolts, would be given by the contractor.

Fixing of danger board and G.I barbed wire on each pole including proper clamping. All material would be provided by firm.

Write serial number on each pole in English with black paint in yellow paint background. All material would be provided be firm.

Painting of following support of existing 33 KV line with one coat of red oxide primer and two coats of aluminium white paint of ISI mark and top danger portion of each support must be painted by providing two coat of Post Office Red Paint (1.5mtr upper portion of support.) Paint and material would be given by contractor to complete of work.

Single pole structure of 11 mtr. ST Pole.

Double pole structure of 11 mtr. ST Pole.

Tri pole structure of 11 mtr. ST Pole.

Four pole structure of 11 mtr. ST Pole.

Laying of double circuit 33 KV 3X300 Sq. mm XLPE cable in normal soil by digging of trench 1500 mm deep, 750 mm wide including supply of required material as fine sand, 1st class bricks, stone slab. Inter axial spacing between the two cable should be in between 0.25 m to 0.40m. The two cables should be seprated by a partition of single bricks (All the material required for laying will be supplied by the contractor except 33 KV XLPE cable)

Cable laying by drill method in single circuit

Hoisting of 33 KV cable on double pole in GI pipe including its jumpering complete along with cost of A class GI pipe of size 6" dia 3 M long, clamps, nuts and bolts.

Fixing of 33 KV 3x300sqmm O/D.

Fixing of 33 KV Cable Marker. (all material would be provided be firm.)

Clearing of the line route by cutting of tree branches during erection of line and also upto the time of energisation completely as per direction of site incharge.

NATIONAL CONTRACTOR & GENERAL ORDER SUPPLIER