CONSTRUCTION OF GROUND RUN POINT AT AF STN SRINAGAR

Amount

Schedule A Part-I (BUILDING WORK )Note: this Schedule is not pre priced by MES and the pre priced rate indicated as Rs 0.00 under Col 5 signifies this fact only.

Construction of weather Shelter of size 30m x 30m including its design, Fabrication, Supply and its erection Pre-Engineer Building (PEB) structure with all RCC foundation and necessary Civil works, roofing, painting, bird proofing net all as shown in architectural dwg and related TDs. Structural design shall be carried out as per design criteria and design shall be vetted by from any of seven old IIT. NOTE:- 1. Weather shelter design shall be carried out from any of PEB manufacturer as per makes specified in PS. 2. Design parameters shall be as per relavant IS codes. 3. Architectural drwaing shall be referred as base for structural design. 4. Design inputs parameters shall be vetted from E-2 (Des) of this office before vetting by IIT. 5. Weather shelter site Natural Ground is sloping as per level plan drwaings. Cost of Building quoted by contractor shall be deemed to include cost of extra earthworks and foundation due to sloping ground. 6. Flooring of weather shelter is exclusive from cost of Building quoted here and same shall be measured and paid separatelty in respective schedule. Flooring of weather shelter shall consist of 350mm PQC, 150mmDLC, 150mm WMM, 150mm GSB and HDPE sheet all as specified in respective shcedule and directed by Garrision Engineer. Earthwork upto bottom & GSB is deemed to be part of lump sum quoted by contractor.

Construction of voltage stablizer room all as per relavent drawings.

Total amount of Schedule 'A' PART-I (BUILDING WORK)

Total amount of Sch 'A' PART-II ( SITE CLEARANCE )

Sch 'A' PART-III ( Section-II) BLANK

Total amount of Sch 'A' PART-IV (Section-I) (INTERNAL ELECTRIC SUPPLY WORK)

SCHEDULE `A' PART-IV(SEC-II) (INTERNAL ELECTRIC SUPPLY WORKS) Note : This schedule is not pre priced by MES and the pre priced rate indicated as "Rs. 0.00" under Col.5 signifies this fact only.

S & F MCCB Four pole 63 Amps lcu =16 KA at 415 volts with thermal magnetic release 01 No (1/G) .It should be with adjustable over load setting lr = (0.8 to 1.0) x ln,lcs = 100 % lcu and fixed magnetic setting Class II front face with positive break indication with double break contacts, Standard extended rotary handle, Spreaders, Phase barrier etc.

S&F Aviation obstruction light with day and night photo cell sensor, 230 volts ac supply Red LED type with IP 65 as per 1S/IEC 60529:2001 in poly carbonate 360 degree Illumination water proof of 10 watt complete all as specified and directed.

S&F energy efficient LED integrated batten type luminaires suitable for wall or ceiling mounting with built in LED Chip & integral LED driver 20 watt, Aluminium channel housing & Polycarbonate diffuser of length 1200 mm (approx.), Color temperature 6500 K or as directed, Luminaire efficacy not less 100 lm/W with all accessories, fixing arrangement internally pre-wired, making all connection using 1.5 sqmm copper conductor multistrand PVC insulated 3 core flexible cable from ceiling rose to fitting drawn through PVC flexible conduit complete fixed in position & connecting complete all as specified and directed by Engineer-in -charge

S&F energy efficient LED integrated batten type luminaires suitable for wall or ceiling mounting with built in LED Chip & integral LED driver 25 watt, Aluminium channel housing & Polycarbonate diffuser of length 1200 mm (approx.), Color temperature 6500 K or as directed, Luminaire efficacy not less 100 lm/W with all accessories, fixing arrangement internally pre-wired, making all connection using 1.5 sqmm copper conductor multistrand PVC insulated 3 core flexible cable from ceiling rose to fitting drawn through PVC flexible conduit complete fixed in position & connecting complete all as specified and directed by Engineer-in -charge

Total amount of Sch 'A' PART-IV (SEC-II) (INTERNAL ELECTRIC SUPPLY)

Total amount of Sch 'A' PART-V (PQC FLOORING)

Total amount of Sch 'A' PART-VI (Section-I) (LIGHTENING PROTECTION WORKS)

SCHEDULE `A' PART-VI (SEC-II) (LIGHTENING PROTECTION WORK) Note : This schedule is not pre priced by MES and the pre priced rate indicated as "Rs. 0.00" under Col.5 signifies this fact only.

Earthing complete with galvanised steel earth plate electrode 60 cm x 60 cm x 6 mm thick buried directly in ground, (Earth pit not less than 2.25 mtr deep below ground level) with top edge of plate not less than 1.5 mtr below normal ground level, connected to and including 32 x 6 mm GI earth strip by means of bolts, nuts, check nuts and washers of galvanized standard iron or steel all as specified or indicated in electrical plate no 3 of MES Part-1, including testing on completion including the material.

a) Excavation and earth work for drilling hole for electrode in any type of soil. (b) PCC pit in cement concrete 1:2:4 type B-1. (c) Precast RCC cover with suitable handle 40 mm thick in PCC 1:2:4 type B-1, reinforced with welded steel wire fabric weighing not less than 1.87 Kg/Sqm. (d) Funnel with watering pipe of Gl 20 mm nominal bore medium grade and copper lugs etc all as specified. (e) 40 mm nominal bore light grade Gl protection pipe 5 mtr long for protection of earthing lead from mechanical injury or tempering. (f) Requisite quantity of common salt and charcoal. (g) Testing of earthing

Notes: (i) On testing after completion of earthing, if the desired earth resistance is not less than 5 ohm obtained, the earthing will be re-done by the contractor at his own risk and cost to the entire satisfaction of the Engineer-in-Charge.The unit rate includes Gl pipe up to 7.5m for protection of earth lead. (ii) The unit rate includes main earthing lead/strip from earth electrode to test point up to 7.5 meter. (iii) In case measured value of earth resistance is recorded more than 5.0 ohms then the Earthing shall be re- done by the contractor without any extra cost to the department. (iv) If there is a requirement of grid earthings to achieve the desired earth resistance, as directed by Eng-in-charge, then inter connecting of different earthings shall be done at no extra cost.

Total amount of SCHEDULE `A' PART-VI (SEC-II) (LIGHTENING PROTECTION WORK)

Total amount of Sch 'A' PART-VII (Section-I) (ROAD/ PATH/ CULVERT)

Total amount of Sch 'A' PART-VIII (Section-I) (EXTERNAL ELECTRIC SUPPLY)

SCHEDULE `A' PART-VIII (SEC-II) (EXTERNAL ELECTRIC SUPPLY) Note : This schedule is not pre priced by MES and the pre priced rate indicated as "Rs. 0.00" under Col.5 signifies this fact only.

Material and labour for cable route indicators, engraved with type, size and voltage of cable painted, embedded in PCC block (1:2:4) type B-1 of size 150 × 100mm fixed in ground at 0.5 mtr height above ground level with the 40×40×5 mm MS angle indicating the route of cable all as specified and directed.

M&L for cutting of PCC/hard standing/WBM road not exceeding 20 Cm in width not exceeding 30 cm in depth for passing LT cable and making good of distrubed surface to match the existing sufaces by using old and new material i.e bitumen/PCC (1 :3:6) type C-1 (using 20mm graded crushed stone aggregate) complete all as per specified and directed.

S & F LED security light with aluminum pressure die cast housing , high purity PC Fresnel diffuser with silicon gaskets for IP-65 protection, 25 Watt & luminaire lumen > 2500lm and system efficiency > 1OOlm/W, In built electronic driver prewired upto terminal block with driver efficiency > 85% power factor > 0.95, suitable for external pole upto 35mm, LED Make:- Nichia/ Cree/Osram, CRI>70, ambient temperature range 0-450C, THD<10%, colour temperature 5700K, surge protection In CM-3.5KV, 50000 burning hours as per L70· criteria, multistage constant current-constant voltage operated driver with range 150-270V AC and safety extra low voltage safe level< 60V DC as per IEC Standard including Gl pipe medium grade lSI mark of size 32rnm dia length not less than 1.5 mtrs bending to shape for fixing light and nuts, bolts, clamps as required to fix to wall all as specified and directed.

Total amount of SCHEDULE `A' PART-VIII (SEC-II) (EXTERNAL ELECTRIC SUPPLY)

Total amount of Sch 'A' PART-IX (AREA DRAINAGE)

M M SHAWL Engineers and contractors pvt ltd (BID ID -3190227)

Dee Ess Construction Co (BID ID -3199392)

M/S ZAHOOR AHMAD KHAN (BID ID -3193238)