Routarapur to Kundapatana Road_Road_ PMC,seal coat and C.C. Overlaying_0.000 to 1.500 and 1.500 to 3.575

Providing and applying Primer Coat with bitumen emulsion on prepared surface pf granular base including clearing of road surface & spraying primer at the rate of 0.60kg/sqm using mechanical means including all cost, carriage, royality, taxes of materials etc. Using Machinery

Providing and applying Tack Coat with bitumen emulsion using emulsion pressure distributor at the rate of 0.20kg/sqm including all cost, carriage, royality, taxes of materials etc. complete as per direcrtion of Engineer-in-Charge (Using Machinery)

Providing and laying 20 mm thick Premix Carpet using 0.18 cum of 13.2 mm and 0.09 cum of 11.2 mm size chips with 14.60 kg. penetration grade of bitumen per 10 sqm including hand packing to proper camber and rolling with PRR including hire and running charges of PRR, tar boiler and other T&P articles including all cost, carriage, royality of chips and bitumen etc.complete as per direcrtion of Engineer-in-Charge

Providing and laying 6 mm thick precoated Seal Coat Type - B using 0.06 cum of 6.7 mm size chips and down graded as per sieve analysis and 6.8 kg. of bitumen per 10 sqm including hire and running charges of PRR, bitumen mixture, tar boiler etc including all cost, carriage, royality of chips and bitumen etc.complete as per direcrtion of Engineer-in-Charge

Construction of embankment with approved material obtained from borrow pit with all lift & leads, transporting to site by mechanical means within a lead of 5 Kms, spreading, grading to a required slope & compacting to meet requirement of table 300-2 & clause 305 of MoSRT&H specification for Road work etc. complete as per direction of Engineer-in-Charge.

Providing C.C (1:2.5:5) using 12 mm size H.G chips of approved quality from approved quarry including hoisting, lowering and laying concrete to the required level ramming watering and curing etc. complete with all cost, conveyance, royalty with all labour and T&P etc. complete as per direction of EIC. a) In Foundation

(In Sub-Structure)

Construction of un-reinforced plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M-30 (Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the form work as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction, expansion and construction joints, applying sealant, admixtures as approved, curing of concrete slabs for 14-days, curing compound (where specified) and water finishing to lines and grade as per drawing and Technical Specification as per direction of the Engineer-in-Charge.

Earth work in excavation of foundation and plinth in ordinary of soil with in initial lift of 1.5 mt. including dressing and levelling etc. complete as per direction of Engineer-in-Charge.

Supplying & filling good clean river sand of approved quality including watering to complete saturation & ramming complete with all leads & lifts including cost, conveyance, royalty & taxes of all materials & cost of all labour & T&P required for the work etc. complete as per specification & direction of Engineer in charge.