SPECIAL REPAIR TO DRAIN BEHIND PC 09 AT SW DIV AND CERTAIN MINOR WORKS AT INF SCHOOL UNDER GE MIS MHOW

Amount

Excavation in trenches n.exceeding 1.50m wide and not exceeding 1.50m depth for foundation or for shafts, walls, cess-pits, manholes, pier holes etc not exceeding 10 sqm on plan and getting out in soft/loose soil complete all as specified

Removing excavated soil to a distance not exceeding 50 m and depositing where directed at a level not exceeding 1.5m above the starting point complete all as specified

Returning, filling in soil including spreading, levelling watering and well ramming in layers not exceeding 25cm thick complete all as specified

Demolition of brickwork or stone/ boulder masonry built in cement mortar of any description including all quoins, arches, pillars, etc, but excluding ashlar facings, dressed stonework and precast concrete articles complete all as specified

Demolition of cement concrete of any description in ground floor and paving not exceeding 15 cm thickness (below or above ground level) complete all as specified

M&L for plain cement concrete 1:4:8 type D2 using 40mm graded stone aggregate as in foundations, filling and mass concrete complete all as specified

M&L for RCC M-25 grade design mix concrete using 20mm graded stone aggregate as in walls of dain ,retaining wall etc complete all as specified. Note: Reinforcment shall be measured and paid separately under relevant item.

M&L for RCC M-25 grade design mix concrete using 20mm graded stone aggregate as in foundations including base slab for RCC drain ,rafts, footings, foundation beams; plinth beams; bases for columns, etc.; basement slabs, under-reamed piles and mass concrete complete all as specified .Note: Reinforcment shall be measured and paid separately under relevant item.

M&L for precast reinforced cement concrete 1:2:4 type B1 using 20mm graded stone aggregate as in cover slabs of drain ,manhole cover and similar work laid and jointed in cement mortar 1:4 including necessary forms,mould etc complete all as specified Note: Reinforcment shall be measured and paid separately under relevant item.

M&L for formwork to faces of drain walls, retaining walls, abutments, parapets and staircase railings and similar work including attached pillasters, buttresses etc vertical or to batter ,fair finished surface of concrete complete all as specified

M & L for mild steel TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clipscomplete all as specified and directed.

S&F PVC (SWR) pipe 110mm bore single socketed in any length with rubber ring joints as in weep holes complete all as specified

M&L for mild steel TMT bars 6mm to 8mm , cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clipscomplete all as specified and directed.

M&L for hardcore with broken stone or boulders of gauge not exceeding 63mm, deposited, spread and levelled in layers not exceeding 15 cm thick, watered and rammed to a true surface complete all as specified

M&L for brickwork with fly ash bricks, straight or curved on plan exceeding 6m mean radius built in cement mortar 1:6 complete all as specified

M&L for rendering 15mm thick on brick work or concrete f surfaces in cement mortar 1:4 finished even and smooth without using extra cement complete all as specified

S&F mild steel work as in tubular trusses including special shaped washer etc. complete using ERW or induction butt welded tubes conforming to I.S 1161-1979 grade St. 240 as in frame work for sun shade, roof projection and vertical section etc. complete all as specified and directed.

M&L for preparation of new steel surface of any description over 10 cm in width or girth and applying two coats of synthetic enamel paint over a coat of red oxide zinc chrome primer complete all as specified

S&F pre-painted galvalume aluminium zinc coating GI based corrugated steel sheet 0.50mm thick of any approved colour having tensile strenght of 550Mpa as in roof covering / claddng to wall fixed with self tapping screws complete all as specfifed and directed.

S&F for pre-painted galvalume aluminium zinc coating GI based plain steel sheet 0.50mm thick of any approved colour having tensile strenght of 550Mpa as in roof covering/claddng to wall fixed with self tapping screws as specfifed and directed.

Dismantling of old stone slab and tiles of any description and thickness ,laid bedded and pointed in any mortar as in floor, apron etc complete all as specified and directed.

M& for Machine cut kota stone slab flooring 20-25mm thick overand including 15mm thick cement screed ed in cement mortar 1:6 and jointed with grey cement slurry mixed with pigment to match the shade of the slab inclunding rubbing and polishing complete all as specified

Excavation in trenches n.exceeding 1.50m wide and not exceeding 1.50m depth for foundation or for shafts, walls, cess-pits, manholes, pier holes etc not exceeding 10 sqm on plan and getting out in hard / dense soil complete all as specified

M&L for plain cement concrete 1:3:6 type C2 using 40mm graded stone aggregate as in foundations, filling and mass concrete complete all as specified

Surface excavation not exceeding 30cm deep and averaging 15cm deep and getting out in soft/ loose soil complete all as specified

M&L for plain cement concrete 1:4:8 type D2 using 40mm graded stone aggregate ,100mm thick ,as in sub abse of floor complete all as specified

M&L for stone dust under floors or in foundation including watering and considaration spreading and levelling in layers not exceeding 25 cm thick complete all as specified

M&L for rubber moulded machine pressed precast cement concrete interlocking paver block (Glossy finish) any shape and size confirming to IS 15658-2006 of 60mm thickness M35 Grade ,of approved colour and pattern including joints filled with sand complete all as specified

M&L for plain cement concrete 1:2:4 type B1 using 20mm graded stone aggregate as in kerb stones, edging of paver block complete all as specified

Chitragupta Construction

M/S Sunshine Construction

M/S Parikshit Sharma

APconstruction

M/S UnitedConstruction

NIDHI CONSTRUCTION

sunway associates

MODI CORPORATION