Internal Electrification work IPHL Karauli Distt. Karauli

Amount

Air Conditioners & Cold Room work: SITC of Sandwich PUF Panel for cold room wall & ceiling, insulation should be cyclopentane PUF having density 40Kg/M3 60mm thickness, fire resistance, mattelic cam /flasing lock joint with prepainted G.I sheet 0.4 mm thick inside and outside. Corner panels are to be provided for neat and clean room complete in all respect.

SITC of Floor of PUF Panel density 40 Kg/M3 with insulation of 60mm Cyclopentane PUF with 12 mm marine ply & 1.2 mm Aluminium Chequer Sheet anti skid flooring.

SITC of flush type door assembly having opening of 34"x78" with door frame, door leaf magnetic gasket, door closure, sweaper gasket, handle with lock assembly & door hinges with view port 300x300 mm & PVC strip curtain including rescue button, so that in case door is locked, door may be open from inside. (excluding cost of PUF Panel)

SITC of invertor based cooling unit consisting of condensing & evaporator unit in S.S. body with R404a refrigerent of capacity 10000 BTU/Hr. with energy efficient hermatic/scroll compressor, Temperature range should be +2 degree Cent to +8 degree Cent. Operation on 220/415 volt 50Hz AC supply, complete with refrigeration control panel accessories, first charge of refrigerant gas with stand/ wall bracket for placement of outdoor unit. Temperature controller hard refrigerant copper piping of suitable 3/8 & 5/8 sizes beteween indoor & outdoor with 19mm thick nitrile insulation, control cable etc. Standard practice U-PVC condensate drain piping size 32mm with 9mm insulation with voltage stabilizer of suitable capacity, pull down time should be 24hrs, compressor run time should be not more than 18 hr. within 24 hrs. complete in all respect.

SITC of Automatic Electrical Control Panel for switch over each unit in 4 Hr. interval complete in all respect.

Access Control, CCTV & UPS work : SITC of PWM IGBTs Based technology 100% capacity rectifier charger 20 KVA Online UPS with battery backup for min. 60 Minutes complete with 65 AH 32 Nos SMF battries with corrosion free battery cabinet/stand , loop wiring with suitable capacity copper wire complete with following specification input voltage- 400V, 3 Phase, 4 wire, 50 Hz, battery charger m. power-13A, nominal output voltage-400/415V, AC, 3Phase, 50 Hz online mode efficiency upto 96.2% noise at 1 Mtr. C-60db relative humidity (%RH)-5-959 Non condensing) UPS Make:- Vertiv (Emerson), GE, APC (Battery Make:- Exide/Quanta)

STIC of Finger Print Access Control System having Operation System Linux, Size 4.3 inch, Resolution 800x480, Operation Method Capacitive Touch Screen, Pixel 2MP, Network Interface, RS-485, Exit Button, Door Contact input, USB 2.0, Card Capacity, 1500 or better, Fingerprint Capacity 1500 or better, Event Capacity 150000, Card Type Mifare 1 card, Card reading distance 0 to 3 cm, Power Supply 12VDC/2A, including metalic push button complete in all respect. Make:- Hikvision, Panasonic EESL

SITC of Electro magnetic single leaf lock having power supply and Maximum thrust 280 Kg (617 Lbs) liner thrust, Input Voltage 12VDC/24 VDC, Working Current 12V/500mA, 24V/250 mA, LED indicator Red: Door is unlocked and Green: Door is locked, Suitable for wooden, Glass, Metal door complete with mounting bracket as required. Make:- Hikvision, Panasonic, ERD

Supply of Mifare RF card Non Contacting IC Card having working distance: no more than 100mm (Depends on the antenna dimension), Working Frequency: 13.56 MHz, High Date Transmission speed: 106 k bit/s, Anti-Conflict, 1k byte (16 zones, 4 sections per zone, 16 bytes per section), Long time data storage: 10 years, Only one serial No. for one card complete with all respect.