TN 05 TPT MPLADS MANOOR

Amount

1. Construction of Multi-Purpose Centre With Kitchen Shed at Manoor H/o Manoor. Estimate Amount Rs.100.00 Lakhs

Earth work Excavation for Foundation in all soils and Sub Soil to full depth as may be directed except in hard rock requiring blasting but inclusive of shoring strutting and refilling the sides of foundation in sand,silt or other loose soil wet sand and silt not under water, ordinary earth as per SS20B.

Cement concrete 1 : 4 : 8 mix using 40mm HBG metal for foundation including watering wherever necessary and laid in layers of not more than 15cm thick., compacting etc., complete complying with standard specifications and as directed.

Filling in Basement with conveyed Earth in layers of not more than 15cm. Thick well rammed, watered and consolidated complying with standard specifications etc., complete.

Supplying and Filling foundation and basement with filling M sand in layers not more than 15cm . Thick well ramed, watered and compacted Complete complying with stanard specification.

Supplying & Erecting centering for sides & soffiots including necessary supports & strutting for plane surfaces in all floors with all cross bracings using mild steel (Below)

Supplying & Erecting centering for sides & soffiots including necessary supports & strutting upto 3.29m height for plane surfaces in all floors with all cross (Above)

Brick work in cm 1:5 using country bricks ground moulded of size 23x11x7cm for the following including curing etc. complete complying with standard specification.

Supplying and Fabricating and placing in position MS steel or Ribbed Tor Steel for all Reinforced Cement Concrete works as per the design given including cost of steel and binding wire in all floors etc, Complete complying with stanard specification.(MS rod or RTS bar will be supplied departmentally at section stores and cost will be recoverd at issue rate). the binding wire shall supplied by the contactor.

Cement concrete 1:1.5:3 using 20mm ISS HBG metal for all RCC item of works excluding cost of Rein forcement and fabricating charges, centering and shuttering but including curing and providing fixtures like fan clamps in the RCC floor or roof slabs wherever necessary and bearing surfaces of walls , sides and bottom of the slabs, beams etc., shall be finished smooth with cement mortar 1:3, 12mm thick. and with kraft paper without claiming extra as directed by the departmental officers complete complying with standard specifications.

Supply ing and appl ying of two coats of Putty of 3 mm thick over the exposed RCCsurface of ceiling including finishing the joints smoothy with grinding machine and thesurface shall be thoroughly cleaned out of dust and scrubbing. The Surface shall then beallowed to dry for atleast 48 hours. Tt shall then be sand papered (waterproof abrasivesheet) to give a smooth and even s urface. Any uneven ness shall be made good byapplying 1st coat of putty mixed with water on the entire surface including filling up the undulations and applying 2nd coat 1 of putty lter 6 hours of 1st coat of putty and thensand papering (waterproof a bra sive s heet) th e same arte r it is dry and finishing thcsurfa ce sm oot hIy, «tc.,

Plastering with cm 1 : 5, 12 mm thick in all exposed faces including curing etc, complete complying with standard specification and as directed

Paving floor with Anti skid tiles of any colour and any size laid in CM 1:3, 10mm thick. and pointing with white cement 0.4 Kg per sqm mixed with colouring pigment to siut the colour of the tiles including finishing the joints neatly complying with the standard specifications and as directed by the departmental officers. The Glazed tiles should be got approved from the Departmental officers before execution.

Dadooing walls with following best approved quality, white / colour glazed tiles of following sizes set in Cement Mortar 1:2 (One Cement and Two crushed stone M.Sand) 10mm thick and pointing the joints with white cement mixed with colouring pigments at the rate of 0.40 Kg. / sq.m. neatly in all floors, curing, etc., complying with standard specification and as directed by the departmental officers.

Paving floor with Vitrified tiles of any colour and any size laid in CM 1:3, 10mm thick. and pointing with white cement 0.4 Kg per sqm mixed with colouring pigment to siut the colour of the tiles including finishing the joints neatly complying with the standard specifications and as directed by the departmental officers. The tiles should be got approved from the Departmental officers before execution.

Weathering course concrete using best quality broken brick jelly of size 20mm in pure slacked lime over the RCC roof slab in th proportion of brick jelly to lime being32:12.5 by the volume and laid over a single layer and consolidated to the required dsesign & finished thick. beating the concrete with wooden beaters of approved pattern, keeping the surface contantly wetted with sprinking lime & jaggery water as per standard specifications etc., complete as directed by the departmental officers.

Finishing the top of roof with one course of machine pressed tiles of size 20 x 20 x 2cm of approved quality laid in CM 1:3, 12mm thick. With water proofing compound confirming to IS by 2% by weight of cement used & the joint pointed neatly to full depth of tiles with the same water proofing compound mixed with cement mortar, Red oxide etc., complete complying with standard specifications.

Supply and fixing of steel doors , windows and ventilators with the following Description as per standard specification

Doors GF (D)

Doors GF (D1)

Windows GF (W)

Windows GF (W1)

Glazed Ventilator GF (V)

Painting two coats with Distembering painting including cost of paint and labour charges etc., complete complying with standard specifications and as directed by the departmental officers.( The paint should be got approved by the Departmental officer before use on works).

Painting two coats with plastic emulsion paint of approved colour and quality including cost of paint and labour charges etc., complete complying with standard specifications and as directed by the departmental officers. ( The paint should be got approved by the Departmental officer before use on works).

Painting two coats over iron works such as doors, windows, ventilators, window bars, balustrades etc., with best approved best quality of synthetic enamel paint of approved colour over the existing priming coat etc., complete complying with standard specifications and as directed by the departmental officers. ( The paint should be got approved by the Departmental officer before use on works).

Providing granolithic floor finish of the following thickness with plain cement concrete 1:2:4 (One Cement, Two crushed stone M.Sand and Four aggregate) using 10 to 12mm gauge hard broken stone jelly including laying, finishing and the top rubbed smooth with power trawl, thread lining, curing etc. complete complying with standard specification and as directed by the departmental officers. (The rate is inclusive of necessary planking for panelling wherever necessary and as directed by the departmental officers)

Elecrtical Arrangements

Wiring with 2 x 1.5 sq.m (22/0.3) PVC insulated unsheathed SC Cu. Conductor of 1100V grade in suitable PVC rigid pipe on wall and ceiling with PVC accessories with TW switch box in flush with wall covered with hylum sheet of 3mm thick with painting of suitable colour for open PVC light point/fan point(for electronic regulator) - S.D.No: 20

Wiring with 2 x 1.5 sq.m (22/0.3) PVC insulated unsheathed SC Cu. Conductor of 1100V grade in suitable PVC rigid pipe on wall and ceiling with PVC accessories and with 150 x 100 x 113 TW switch box for 5A 3pin non inter locking CS plug with painting of suitable colour with continuos earth wire connection of 14 SWG TC wire for open PVC plug - S.D.No: 36

Supply and fixing of 1200mm (48") AC ceiling fan with stepped electronic 300 W regulator with 1 meter down rod on the existing clamp. - S.D.no: 107

Supply and run of 2 of 1.50 sq.mm (22/0.3) PVC insulated SC unsheathed Cu.Conductor of 1100 V on 7/20 GI bearer wire for service connection mains. - S.D.No: 64

Supply and fixing of single box type 4'40 W flu fitting complete with copper choke and condensor with TW round blocks on wall or ceiling with flu tube with PVC unsheathed copper leads from terminals to the fitting - S.D.No: 88

Supply and Fixing of CFL bulb 11w including cost and conveyance of all materials and labour charges etc complete. SD 80

Supply and fixing of WT bulk head fitting with guard suitable for incandescent lamp with 100W bulb SD 85

Supply and fixing of TNEB meter Board suitable for 32A Single phase service connection with 32A fuse unit(500V) 32A neutral link and earth link (1"x1/8" Copper flat) on TW plank of size 375mmx300mmx19mm with supporting TW reepers of 1" thick an either side with painting with suitable bolt and nuts for fixing the TW plank on wall with earth connection and inter connection with 7/20 PVC insulated copper wire from EB meter to fuse unit - SD No: 125

Towards Hand rail SS Arrangement include all cost and conveyance etc all charges complate

Toilet Sub Estimate

Earth work Excavation for Foundation in all soils and Sub Soil to full depth as may be directed except in hard rock requiring blasting but inclusive of shoring strutting and refilling the sides of foundation in sand,silt or other loose soil wet sand and silt not under water, ordinary earth as per SS20B.

Cement concrete 1 : 4 : 8 mix using 40mm HBG metal for foundation including watering wherever necessary and laid in layers of not more than 15cm thick., compacting etc., complete complying with standard specifications and as directed.

Brick work in c.m 1:5 mix using country bricks including cost & conveyance of all materials to site and all labour charges etc., complete.

Supplying & Erecting centering for sides & soffiots including necessary supports & strutting upto 3.29m height for plane surfaces in all floors with all cross

Cement concrete 1:1.5:3 using 20mm ISS HBG metal for all RCC item of works excluding cost of Rein forcement and fabricating charges, centering and shuttering but including curing and providing fixtures like fan clamps in the RCC floor or roof slabs wherever necessary and bearing surfaces of walls , sides and bottom of the slabs, beams etc., shall be finished smooth with cement mortar 1:3, 12mm thick. and with kraft paper without claiming extra as directed by the departmental officers complete complying with standard specifications.

Supplying and Fabrication of steel for RCC works including all cost of cutting bending and tying of steels and kept ready for concrete in position etc.,

Plastering with cement 1:3-10mm thick including cost and conveyance of al materials to site and all labour charges etc complete

Plastering with cm 1 : 5, 12 mm thick in all exposed faces including curing etc, complete complying with standard specification and as directed

Paving floor with Anti skid tiles of any colour and any size laid in CM 1:3, 10mm thick. and pointing with white cement 0.4 Kg per sqm mixed with colouring pigment to siut the colour of the tiles including finishing the joints neatly complying with the standard specifications and as directed by the departmental officers. The Glazed tiles should be got approved from the Departmental officers before execution.

Dadooing walls with following best approved quality, white / colour glazed tiles of following sizes set in Cement Mortar 1:2 (One Cement and Two crushed stone M.Sand) 10mm thick and pointing the joints with white cement mixed with colouring pigments at the rate of 0.40 Kg. / sq.m. neatly in all floors, curing, etc., complying with standard specification and as directed by the departmental officers.

Painting two coats with Distembering painting including cost of paint and labour charges etc., complete complying with standard specifications and as directed by the departmental officers.( The paint should be got approved by the Departmental officer before use on works).

Painting two coats with plastic emulsion paint of approved colour and quality including cost of paint and labour charges etc., complete complying with standard specifications and as directed by the departmental officers. ( The paint should be got approved by the Departmental officer before use on works).

Cost and supply of IWC

Cost and supply of EWC

Cost and supply of wash basin

Cost and supply of Wood plastic composite door

Door D2 0.75 m x 2.1m

Door D 1.20 m x 2.10 m & 0.90 m x 2.10 m

Sanitary arrangements

110 mm dia pvc pipe

110 mm dia pvc bend

110mm PVC TEE

500 lit HDPE tank

Cost and supply of RCC jolly

Water Supply Arrangement

SUPPLY OF MATERIALS :

63mm PVC Pipe 4KSC

63mm PVC Coupler

63mm PVC Elbow

63mm PVC Gate Valve

Solvent Cement

2000 Liter HDPE Tank

20 mm PVC Pipe

20 mm PVC Coupler

20 mm PVC Elbow

20 mm PVC Bend

Tread and Chellak

20 mm PVC Tap

Earth work excavation other than loose soil area and refilling the trench with excavation soil

Fixing of Sintex Tank and Plumbing Arrangement

GST Amount for providing Service to Government Contract Works for the above Construction Works. { GST Amount is the Total GST Amount for total overall quoted amount above this row in column "BB" for all works in this package}

T N S CONSTRUCTION (BID ID -1510970)