Construction of Multipurpose Hall cum building At Sagolband, Imphal West, Manipur

Amount

Sub Head: Demolishing & dismantling

Demolition below G.L. upto 1 m.depth including stacking of serviceable materials and disposal of unserviceable materials within 50 m lead and including cutting the necessary reinforcement and separating out from R.C.C. work.

Demolition above G.L.upto floor two level including disposal of unserviceable materials with 50 m lead …...Unreinforced cement concrete more than 15 cm thickness.

Demolition of brick work above G.L. upto floor two level including stacking of serviceable materials and disposal of unserviceable materials within 50 m lead….. In cement mortar.

Dismantling sheet roofing including ridges, hips, valleys, gutters etc. stacking the serviceable materials and disposal of unserviceable materials within 50 m lead…......... G.I. sheet roofing

Dismantling wood work wrought framed and fixed in frames, other frames and trusses of span up to 10 m and height between ridge and floor level upto 5 m including stacking the materials within 50m lead…...Sectional area average 40 sq.cm or over.

Sub- Heads- Earthworks

(B) Earthwork in excavation in foundation trenches or drains including dressing of sides and ramming of bottoms lift up to 1.5m. including getting out the excavated soil as directed within a lead of 50 m a) Hard/Dense soil.

Filling available excavated earth (excluding rock) in trenches, plinth sides of ,foundation etc. in layer not exceeding 20cm. in depth consolidation each deposited layer by ramming and watering lead unto 50m. lift unto 1.5m.

Filling in plinth with sandy soil under floors i/c watering, ramming, consolidating and dressing complete.

Sub-Head:- Concrete & RCC Work

Providing and laying cement concrete in foundation and plinth excluding the cost of centering and shuttering 1:4:8 (1 cement :4 coarse sand :8 graded stone aggrt 40 mm nominal size).

R.C.C work in foundation footings, bases of columns etc (a) 1:1.5:3 ( 1 cement : 1.5 coarse sand : 3 graded stone aggregate 20 mm nominal size).

R.C.C. work in column pillars ,abutment, post and struts upto floor two level i/c finishing and plastering the exposed surface with cement mortar 1:3(1cement:3f/sand) of thickness not exceeding 6mm to give a smooth and even surface but excluding the cost of centering and reinforcement in 1:1.5:3( 1 cement :1.5 course sand: 3graded stone aggrt. 20mm nominal size)

RCC work in suspended floors, roofs landing, shelves & their supports, balconies, lintels, beams, plinth i/c finishing and plastering the exposed surface with cement mortar 1:3 ( 1 cement : 3 coarse sand ) of thickness not exceeding 6mm to give a smooth and even surface but excluding the cost of centering, shuttering and reinforcement.a) 1:1.5:3 (1 cement: 1.5 course sand: 3 graded stone aggt. 20mm nominal size).

R.C.C work in staircases (excluding landing) except spiral staircases i/c finishing and plastering the exposed surface with cement mortar 1:3 (1 cement :3 fine sand ) of thickness not exceeding 6 mm to give a smooth nosing upto floor two level but excluding the cost of centering, shuttering and reinforcementt with 1:2:4 ( 1 cement : 2 coarse sand : 4 graded stone aggregate 20 mm nominal size).

Sub-Head:- Reinforcement

Reinforcement for RCC work in bending, binding and placing in position complete in Tor steel bars.

Sub-Head:- Form-Work

Providing form works i/c centering and shuttering so as to give a rough finish, shuttering & propping etc height of propping & centering below supporting floor to ceiling not exceeding 4m & removal of the same for in-situ reinforced concrete plain concrete work in:-

(a) Foundation, footings, bases of columns etc. and mass concrete…………..

b) Column pillar posts& struts ( square, rectangular or polygonal in plain)

c) Sides and soffits of beam, beam haunchings, cantilevers, girders, bressumers and lintel not exceeding 1m in depth.

e) Flat surface such as suspended floor, roofs, landing and the like. (i) floor etc upto 200mm thickness.

(m)stair-case…...………….

Sub-Head: Brick Work

2nd class (local 1st class) brick work in foundn and plinth in cement mortar 1:3(1cement :3c/sand)

Half brick masonry 2nd class (local 1st class) in cement mortar 1:3 ( 1 cement :3c/sand) in superstructure.

Sub-Head: Wood Work

Providing wood work in frames of doors, windows, clerestory windows and other frames wrought, framed and fixed in position -uningthou wood

P/F 35 mm thick panelled and glazed or panelled or glazed shutters for cupboard i/c black-enamelled or bright finished M.S. butt hinges with necessary screws. Uninghou

Providing and fixing M.S. Tower bolts (barrel type) with screws etc. complete (a) 250 x 10 mm…………….

P/F M.S. sliding bolts with nuts and screws etc. complete with 300 x 16mm.

P/F M.S. handles with necessary screws etc. complete.

Providing and fixing M.S.hooks and eyes.

Sub Head: Flooring& Finishes

12 mm cement plaster 1:3 (1 cement: 3fine sand)

15 mm cement plaster1:3(1 cement : 3 F/sand)

Providing and applying plaster of paris putty of 2 mm thickness over plastered surface to prepare the surface even and smooth complete.

Applying one coat of cement pimer of approved quality on wall surface.

Finishing wall with water proofing cement paint of approved quality on new work(three or more coats) to give an even shade.

Applying ready mixed priming coat pink primer of approved quality on wood work

Painting two or more coats(excluding priming coat) with superrior ready mixed paint for wood work of approved quality in all shades on new work to give an even shade.

Distempering ( two or more coats) with oil bound washable distemper of appd. quality on new work including priming coat to give an even shade.

Painting (one or more coats) with black japan to give an even shade.

Steel work in built up tubular trusses including cutting, hoisting, fixing in position and applying a coat of approved steel primer red oxide zinc chrome primer conforming to IS:2079) welded and bolted including special shape washer etc. complete. (a) Electric resistant welded tube (Conforming to IS:1611-1979)

Corrugated G.I. Sheet 24 B.G. fixed with galvanized iron J or L hooks 8 mm dia G.I. Limpet and bitumen washer complete excluding the cost of purlins, rafter and trusses.

Ridges or hips 600 mm over all in plain G.I. Sheet 24 B.G. fixed with galvanized iron J or L hooks 8 mm dia G.I. Limpet and bitumen washers complete.

Providing and fixing 20 mm plank as eave board with :b) Uchan/Tolhao wood

Providing under laying for plinth protection of 75mm thick (unconsolidation) of stone aggrt. 40mm nominal size well rammed and consolidation and grouted with fine sand including preparation of ground .

Providing Plinth protection 50mm thick in cement concrete 1:3:6 ( 1 cement : 3c/sand: 6 graded stone aggrt. 20 nominal size ) including finishing the top surface of concrete smooth

Sub Head: Water Supply & Sanitary Installation.

Providing and fixing white vitreous china dual purpose closet suitable for use as squatting pan or European type water closet ( Anglo Indian W.C pan) with seat & lid fixed with C.P. brass hinges and rubber buffers, 10 litre low level flushing cistern with fitting and brackets, 40mm flush bend, 20mm over flow pipe, with specials of standard make and mosquito proof coupling of approved municipal design complete, including painting of fittings and brackets, cutting and making good the walls and floors wherever required:White vitreous china dual purpose WC pan with white solid plastic seat and lid with white vitreous china flushing cistern and C.P. flush bend.

Providing and fixing white vitreous china flat back or wall corner type lipped front urinal basin of 430x260x350 mm and 340x410x265 mm sizes respectively with automatic flushing cistern with standard flush pipe and C.P. brass spreaders with brasss unions and G.I clapms complete, including painting of fittings and brackets, cutting and making good the walls and floors wherever required:Range of two urinal basins with 5 litre white P.V.C. automatic flushing cistern

Providing and fixing wash basin with C.I. brackets, 15 mm dia CP Brass single hole basin mixer of approved quality and make, including painting of fittings and brackets, cutting anf making good the walls wherever required:White Vitreous China Wash basin size 550x400 mm with a 15mm CP Brass single hole basin mixer

Providing and fixing laboratory sink white glazed vitreous china (Indian make) with R.S. or C.I. brackets painted white a pair of 12.5 mm C.P. brass pillar tap 323 mm rubber plugs and C.P. brass chain 32 mm C.P. brass waist of standard pattern 32 mm diameter M.I./C.P. brass traps and unions complete i/c cutting and making good the walls Indian fittings. 450 x 300 x 150 mm

Providing and fixing P.V.C. low level flushing cistern with manually controlled device ( handle lever) conforming to IS : 7231, with all 10 litre capacity- White.

Providing and fixing grating of approved quality for Nahni trap.Stainless Steel 125mm nominal diameter with 25mm waste hote

Providing and fixing 600 x 450 mm bevelled edge mirror of superior glass (of approved quality) quality complete with 6mm thick hard board ground fixed to wooden cleat with C.P. brass screws and washers complete.

Providing and fixing 600x120x5 mm glass shelf (Indian make) with C.P. brass brackets guard nail complete fixed to wooden cleats with C.P. brass screws.

Providing and fixing 600 x 20 mm C.P. brass towel rail complete with C.P. brass brackets fixed to wooden cleats with C.P. brass screws (Hook type )

Providing and fixing C.P. brass toilet paper holder

Providing and fixing liquid soap container of glass with C.P. lid and brackets fixed to wooden cleats with C.P. brass screws.

Providing and fixing telephonic shower rose with one meter flexible tube, Dimple/Round/Fancy.

Providing and fixing 100 mm H.C.I. soil, waste & vent pipes.

P/F M/S holder bat clamp of approved design to 100 mm H.C.I. Pipe socket including cost of cutting holes and making good the walls etc.

P/F 100 x 100 x 100 mm H.C.L. branch of the required degree with access door, insertion rubber washer 3 mm thick bolts and nuts complete.

Providing and fixing GI pipes complete with GI fittings i/c trenching and refilling etc. (external work).40 mm diameter

Providing and fixing G.I. pipes complete with G.I. fittings and clamps i/c cutting and making good the walls etc. (Internal work).32 mm diameter

Providing and fixing Chlorinated Polyvinyl Chloride (CPVC) pipes, having thermal stability for hot & cold water supply, including all CPVC plain & brass threaded fittings, including fixing the pipe with clamps at 1.00 m spacing. This includes jointing of pipes & fittings with one step CPVC solvent cement and the cost of cutting chases and making good the same including testing of joints complete as per direction of Engineer in Charge.25 mm nominal outer dia pipes

Providing and fixing Chlorinated Polyvinyl Chloride (CPVC) pipes, having thermal stability for hot & cold water supply, including all CPVC plain & brass threaded fittings, including fixing the pipe with clamps at 1.00 m spacing. This includes jointing of pipes & fittings with one step CPVC solvent cement, trenching, refilling and testing of joints complete as per direction of Engineer in Charge.External work-40 mm nominal outer dia pipes

Providing and fixing brass stop cock of approved quality.32 mm diameter

P/F water storage tank(syntex) with 400mm diam normal based GI piped (overflow) tube 25mm normal GI inlet 15mm norminal GI oultet tube i/c hoisting ht of 10m above a) 1000 capacity.

M/s L.B.C. Roy Agency