Repairs to Ceiling, Roof and Sunshade in Bill Group inside SAF, Kanpur

Amount

Demolition of RCC chajjas and similar suspended work in such a manner that building may not disturbed.

Dismantling boarding, any description, fixed in any position with screws (false ceiling) properly for reusing

Taking down old cement plaster on brick or concrete ceiling surface, etc. including raking out joints, hacking for key, scrubbing down with water, etc.completed including removing of waste material whereas directed by EIC

M&L for cleaning with epoxy cloth and exposed corroded re-bars by chiseling out enough cavity to access entire dia of corroded bars and applying anti corrosive chemical to the reinforcement. (Chemical manufacturer :- Sika/Pidilite/Fosroc). QAC must be provided by manufacturer.

M&L for epoxy based primer/bonding material for bonding old concrete surface to new mortar (Chemical manufacturer:-Sika/Pidilite/Fosroc) QAC must be provided by manufacturer.

M&L for 10mm thick cement mortar (1:4) using high flexural and high tensile strength polymer chemical as dubbing coat rough finished all as specified and directed (Chemical manufacturer:-Sika/Pidilite/Fosroc) QAC must be provided by manufacturer.

M&L for rendering 05mm thick plaster in cement mortar 1:3 on concrete surfaces in ceiling as specified or directed. (Cement - ACC/KC super/lafarge/ultratech). QAC must be provided by manufacturer.

M&L for Formwork for flat and fair finished surface to soffits of suspended slabs such as roof slabs, floor slabs, landings and similar work; not exceeding 200mm thick (Horizontal or sloping) without damaging existing floor by using rubber mats etc.or otherwise as directed by EIC

M&L for cement concrete type B1,1:2:4 (20mm graded aggregates) for Slabs supported on walls, beams and columns in floors, roofs, landings, balconies, canopies, deck slabs and in shelves and the like. (Cement - ACC/KC super/lafarge/ultratech). QAC must be provided by manufacturer.

S&F Mild steel TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips. TMT bars- Tata/Sail/Jindal). QAC must be provided by manufacturer.

M&L for preparing of new undecorated surfaces of ceiling and applying two coats of white wash mixed with blue and gum all as directed on new surface

M&L for painting walls with two coats of interior plastic emulsion paint over old painted surfaces of any description over 10cm girth or width, not otherwise described including complete removal of old treatmentby rubbing/scraping/washing (make: Nerolac / Berger / Asian paints)

M&L for painting walls with two coats of exterior plastic emulsion paint over old painted surfaces of any description over 10cm girth or width, not otherwise described including complete removal of old treatment by rubbing/scraping/washing (make: Nerolac / Berger / Asian paints)

M&L for applying two coats of synthetic enamel paint wooden surfaces including prepration on old painted Surfaces of any description, not otherwise described, over 10cm width or girth. (make: Nerolac / Berger / Asian paints)

M&L for Fixing only of 12mm thick Perforated particle board/tiles except tiles/boards for insulation purposes,60x60 cm in size, fixed with nails to timber frame work or with staples on snap grid as approved

Fixing only of Anodised aluminium snap grid frame work for false ceiling all as specified with grid size 605*605mm

S&F of Anodised aluminium snap grid frame work for false ceiling all as specified with grid size 605*605mm

S&F of Hangers 6 mm dia. G.I. adjusting level fixed to roof slabs by means of ceilling cleats made out ofG.I.flat 40 x 3 mm size 60mm long and expansion hold fasteners 12.5mm dia. 40mm long complete all as specified

Cutting grooves in brick wall, 75mm wide and 65mm deep and shaping horizontal face of groove with cement mortar 1:3

Bitumastic gola, with 80/25 bitumen and coarse sand mixture. 1:3 by weight, 8cmx8cm at the junction of roofing to vertical surfaces

M&L for preparing surface and brushing neat cement slurry with 3.00 KG of cement per sq.metre

M&L,for 15 mm thick Plaster in cement mortar 1:4 mixed with water proofing compound @ 2% by weight of cement over roof slab,cement plaster laid in slope all as directed by E-I-C. material approved by E-I-C before use in the work

Supply only integral water proofing compound approved by E-I-C before use in the work.

M&L for providing and applying fiber reinforced elastomeric liquid waterproofing membrane with resilient acrylic polymers having sun reflective index (SRI) of 105 manufactured by asian paints ltd or equivalent as approved by EIC on top of concrete roof in three coats @ 10.76 litre per 10 sqm. one coat of self priming of elastomeric waterproofing liquid (Dilution with water in the ratio of 3:1) and two coat of undiluted elastomeric waterproofing liquid ( dry film thickness of complete allocation/system not less than 500 microns). Note: Treatment shall be done through authorised representative applicator of manufacturer. QAC/warranty certificate must be provided by manufacturer.

SUMIT ARORA

M/s Raghvendra Traders