Plinth protection of Camp Office with replacement of main gate, asbestos sheet at GIL Camp Office (Parachute Bhavan)

Amount

Dismentaling of asbestos cement (corrugated, semicorrugated etc.) sheets in roof coverings.

S&F pre-painted aluminium zinc coating GI based corrugated steel sheet 0.50 mm thick of any colour as approved having tensile strength of 550 Mpa as in roof covering/cladding to wall fixed with self tapping screws of L&J type hook bolt complete all as specified and directed. Note- The sheet shall be laid with side tap and end lap in slope as per anufacuturer's instructions and as directed complete

S&F Framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering. Doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing complete as specified and directed by EIC or SIC

Demolition of brickwork or stone/boulder masonry, build in cement mortar including all quons, arches, pillars, etc but exculding

Demolition of cement concrete (un reinforced) in ground floors and paving n exc 15 cm thickness below or above ground level.

Taking down cement plaster on PCC stone surface/Brick surfaces including racking out joints, hacking for key, scrubbing down with water etc all as specified by SIC & EIC

Excavating in trenches, n exc 1.5 m wide and n exc 1.5 m in depth; for foundation, etc. or for shafts, wells, cesspits, manholes, pier holes, etc. n exc 10 sq m on plan and n exc 1.5 m in depth and getting out

Material and labour Soling (or sub base) with broken boulders or quarried stone, inter stices filled, surface formed and rolled and consolidated to required gradient and camber

Material and labour 70 mm thick PCC (1:2:4) type B 0 using 12.5 mm graded crushed stone aggregate as in sub base, surface finished fair and even complete all as specified.

M&L PCC 1:2:4 Type C2 using 40 mm graded stone aggregate as in foundation & sub base

M & L Metallic floor hardener

Supply only water proofing compound.

Material and labour 55 mm thick PCC (1:2:4) type type B 0 using 12.5 mm graded crushed stone aggregate as in sub base, surface finished fair and even complete all as specified.

M&L Brickwork with sub- class ‘B’ bricks straight or curved on plan exc 6 m mean radius built in CM 1:4 all as specified and directed by SIC & EIC

M/L Rubber Mould Chequered cement concrete tiles 20cm x 20cm x 25mm thick, set, jointed and pointed in neat cement slurry in floors

M/L Providing and laying 80mm thick factory made chamfered edge cement concrete paver block of M-30 grade with approved colour, design & pattern as in footpath, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of coarse sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with fine sand and cutting of paver block as per required size and pattern, finishing and sweeping extra sand; complete.

M&L Factory made moulded Pre cast cement concrete as in kerb stone and the like including weathering slightly rounded or chamfered angles and throating and seting CM 1:$ complete all as specified and as directed.

(M&L) RCC in column, pillars, posts and struts

(M&L)Mild steel bars 10mm dia and over, cut to length, bent to shap required, including rings, cranking bending spirally for hooping for columns,hooking ends and binding with and including milding steel wire or as per directive of EIC/SIC.

M&L for rendering 15mm thick on fair faces of brick work or concrete surfaces in cement mortar 1:4 with water proofing compound, finished even and smooth without using extra cement complete all as specified and directed Note: Water proofing comput will paid and measured separately.

lnsulated PVC Wall Lining (Thickness of insulated PVC wall lining 25mm) consisting of PVC Insulated Panels having expanded polystyrene (EPS) stuck to 2mm thick plain colour PVC sheet duly fitted into the wall as per specifications and drawing

M&L 16 to 18 mm thick Granite (of any type) slab of approved shade as in flooring platform with white cement with admixture of pigment to match with shade of Granite stone including cutting, grinding and polishing (mirror polish i.e. full granite polish as per local trade practice) over & including 15 mm thick screed bed (bedding layer) in CM 1:6 complete all as specified and directed by EIC or SIC

2.8 to 3 mm thick Birla white/JK white/Berger wall putty (to achieve smooth surfaces).

M&L for two coats of oil bound distemper on walls new plastered surface including preparation of surfaces complete as specified.

M&L two coat of cement base paint on new surfaces of walls including preparation of surfaces complete all as specified and directed by EIC or SIC

Removing building materials etc to a distance of 1.0 Km or under, -

Dismantling structural steel work including doors, gates but excluding framed truss etc.

S&F Material & Labour for providing and fixing stainless steel (Grade 304) gate made of hollow tubes, channels, plates, angle etc., including welding, grinding, buffing, polishing and aking curvature (where ever required) and fitting the same with necessary stainless steel nuts and bolts complete, including fixing the railing with necessary accessories & stainless steel dash fasteners, stainless steel bolts etc., of required size, on the top of floor or the side of waist slab with suitable arrangement.

Wiring for circuit 2x1.5 sq. mm + 1x1.5 sq. mm wiring alongwith earthwire in PVC iconduit with PVC insulated copper conductor, in surface/recessed as required.

Wiring for circuit 2x2.5 sq. mm + 1x2.5 sq. mm wiring alongwith earthwire in PVC iconduit with PVC insulated copper conductor, in surface/recessed as required.

Manufacturing, supplying and fixing retro reflective Mandatory/ Regulatory sign boards of not more than 0.81 SQM with support length of 3750 mm and made up of 2 mm thick aluminium sheet, face to be fully covered with high intensity encapsulated type heat activated retro reflective sheeting conforming to type - IV of ASTM-D 4956-01 in blue and silver white or other colour combination including subject matter, message (bi-lingual), symbols and borders etc. as per IRC ; 67:2001, pasted on substrate by an adhesive backing which shall be activated by applying heat and pressure conforming to class -2 of ASTM-D-4956-01 and fixing the same with suitable sized aluminium alloy rivets @ 20 cm c/c to back support frame of M.S. angle iron of size 25x25x3 mm along with theft resistant measures, mounted and fixed with 2 Nos. M.S. angles of size 35x35x5 mm to a vertical post made up to M.S. Tee section ISMT 50x50x6 mm welded with base plate of size 100x100x5 mm at the bottom end and including making holes in pipes, angles flats, providing & fixing M.S. message plate of required size, steel work to be painted with two or more coats of synthetic enamel paint of required shade and of approved brand & manufacture over priming coat of zinc hromate yellow primer (vertical MS-Tee support to be painted in black and white colours).Backside of aluminium sheet to be painted with two or more coats of epoxy paint over and including appropriate priming coat including all leads and lifts etc. complete as per drawing , specification and direction of Engineer-in-charge.

S/F, 5 Watt Green Waterproof Spike LED Garden Light for Outdoor Purposes, Colour Green, Material Metal Aluminium, Style Modern, Light fixture form Path, Specific Uses Garden, Power Source Electricity Voltage ‎230 Volts Type ‎LED, Special Feature Waterproof. Shade Material ‎Aluminium,Height 20 to 30 Centimeters, Length ‎6 to 7 Centimeters,Wi40 to 50 Centimeters.Make. D'Mak, Nortek, LiteMart, A’Mart

S/F Solar Garden Lights Outdoor with IP65 Waterproof LED Solar Path Lights for Landscape, Patio, Yard Sensing Auto On/Off , Colour White/Warm light,Dimensions 7.1D x 9.3W x 4H Centimeters, Special Feature Water Resistan,Light Source Type LED,Material Stainless Steel,Type Outdoor, Garden, Make Verilux, hardoll , Homehop, Verilux

S/F 90W Solar LED Street Light with Automatic Day-Night auto on & Off Sensor with inbuilt Battery, Waterproof . Make - Epyz , Lumen City, hardoll , Orbit

S/F 50-60 w Automatic Sensor Lens Street Light (White),Bulb Used: ["LED"],Bulb Included,Material: ["Aluminium"],Mount Type: Fixed,Length Min 12 Inch.Make-Murphy, GlowBase,D'Mak, Nortek, LiteMart, A’Mart

S/F Solar 12 LED Flickering Mashaal Flame Light Self Locking Key Switch for Garden Outdoor Pathway Light Waterproof Lamp, Product Dimensions 7.9W x 64.9H Centimeters, Power Source Solar PoweredMake Verilux, hardoll , Homehop, Verilux

Credit of MS gate as per existing condition.

Credit of asbestos sheet as per existing condition.

KESHAV RAM SHARMA & COMPANY

KRISHNA ENTERPRISES