Annual maintenance for submersible pump motors repair work

Annual maintenance for submersible pump motors repair work

Rewinding of submersible pumpset with copper winding wires of appropriate guage, as per specifications and / or directions of the departmental officials, including all materials, labour, equipment and...

Rewinding of submersible pumpset with copper winding wires of appropriate guage, as per specifications and / or directions of the departmental officials, including all materials, labour, equipment and...

The bowls of same type and make

The Intermediate piece (IP) with IP leaded bronze brush

The Oil Seal and steel brush

The Impeller (Shell moulded with aluminium and bronze)

The discharge outlet (DO) bearing DO steel brush DO bearing

The Steel bearing brush (DO steel brush)

The allen screw

The Pump shaft made out of stainless steel counterless ground with key way (upto 8 stage) Extra for each stage @ Rs.40/-

The pump coupling (stainless steel)

The Non Return Valve (NRV) assembly complete with rubber 'O' ring

The brass filter

The Labour Charges for overhauling of the pump set

The Upper flange

The Lower flange

Upper/ Lower housing

The Carbon Housing

The Carbon Housing (Thrust bearing block assembly complete with segment bearing pad

The Stud and Nuts

The Gun Metal bearing, centriugally cast Aluminium Bronze bearing vrush

The Motor base with pin

The Transportation of pumping machineries

The lifting of suvmergile pumpset from well

Supplying and fixing and wiring 0 to 600 volts 96*96mm AC voltmeter on existing panel/ wood board PWD Ele SR 2-23-24 V-6 Page-18 Item No-5.22

Supplying and fixing and wiring 0 to 100 amps direct reading AC analog type ammeterpage 1PWD Ele SR 2-23-24 V-6 Page-18 Item No-5.25

Supplying and fixing single phase preventer using necesary wires over an existing panel board suitable for motor up to 20 HP capacities PWD Ele SR 2-23-24 V-6 Page-14 Item No-5.3

Supplying and fixing of 4 Pole power contactor with NO/NC contacts on existing wood/ panel board using necessary bolts nuts washers and wiring etc complete with AC-3 rating and as per IS-13947 PWD Ele...

Labour cherges for Lifting of non functioning submersible pump set with cable and GI pipes (Each length = 6m) for 50 mm CSR for Water Supply & Sewerage Works 2023-24 V-5 Page No-142, Item No-12.24

Cutting and threading G.I pipes for pump fitting, public fountatins with appurtenances., where the length of pipe laid is less than 6 meters CSR for Water Suply & Sewerage works 2023-24 V-5 Page No-15...

Labour charges for providing connection using insulated sheathed steel wire cable a per IS 1554/1988 with latest amendments from KPTCL pole to meter board unit, with all necessary materials , tools an...