Repair to compound wall Drain Pathway in AOR of AGE B/R I under GE (N) Ahmednagar

Amount

Demolition of Reinforced Cement Concrete of any description and in any position not otherwise specifically provided etc complete all as specified and directed by Engineer-in-Charge

M&L for Pre cast reinforced cement concrete 1:2:4 type B1 (Using 20mm graded stone aggregate) set in cement mortar 1:4 for man holes and drain cover slab etc complete all as specified and directed by Engineer-in-Charge

M & L for Reinforced Cement Concrete Type B1, 1:2:4 (using 20 mm graded granite stone aggregate) in Slabs supported on walls, beams and columns in floors, roofs, landings, balconies, canopies, deck slabs and in shelves and the like etc complete all as specified and directed by Engineer-in-Charge

M&L for form work to soffits of suspended slabs such as roof slabs, floor slabs and similar work not exce 200 mm thick etc complete all as specified and directed by Engineer-in-Charge

Mild steel TMT bars 10 mm dia., and over cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with mild steel wire (annealed) not less than 0.9 mm dia., or securing with clips etc complete all as specified and directed by Engineer-in-Charge

Demolition of cement concrete (unreinforced) in ground floors and pavings not exceeding 15 cm thickness.(below or above ground level) etc complete all as specified and directed by Engineer-in-Charge

Demolition of stone slabs and tiles of any description or thickness laid bedded and pointed in any mortar in floors aprons etc complete all as specified and directed by Engineer-in-Charge

M & L for hardcore of gauge not exceeding 63 mm of broken granite stone, deposited, spread and levelled in layers not exceeding 15 cm thick, watered and rammed to a true surface etc complete all as specified and directed by Engineer-in-Charge

Material and labour for 75 mm thick plain cement concrete 1:4:8 type D2, using 40 mm graded stone aggregate as in sub base etc complete all as specified and directed by Engineer-in-Charge

M&L Providing and laying 60mm thick factory made chamfered edge cement concrete paver block of M-35 grade with approved colour, design & pattern as in footparth, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand etc complete all as specified and directed by Engineer-in-Charge

M&L Providing and laying at or near ground level factory made kerb stone of M-25 grade cement concrete in position to the required line, level and curvature, jointed with cement mortar 1:3 (1 cement: 3 coarse sand), including making joints with or without grooves (thickness of joints except at sharp curve shall not to more than 5 mm), including making drainage opening wherever required etc complete all as specified and directed by Engineer-in-Charge

Preparation of new or previously untreated surface kerb stone surfaces of any description, over 10 cm width or girth, not otherwise described and applying one coat of fluorecent paint etc complete all as specified and directed by Engineer-in-Charge

Excavation in trenches n.exc 1.5M wide and n.exc 1.5M in depth for foundation etc or for manholes n.exc 10 Sqm on plan and n.exc 1.5m indepth and getting out in hard/dense soil etc complete all as specified and directed by Engineer-in-Charge

M&L for PCC 1:4:8 type -D2 using 40 mm graded aggregate in fdn filling and mass concrete etc complete all as specified and directed by Engineer-in-Charge

Demolition of brick work or stone/ boulder masonry/PCC block masonary, built in cement mortar or cement lime mortar including all quoins, pillars etc complete all as specified and directed by Engineer-in-Charge

Brick work with fly ash bricks, straight or curved on plan exceeding 6 M mean radius built in cement mortar 1:6 etc complete all as specified and directed by Engineer-in-Charge

M & L for Pre-cast cement concrete block masonry with solid blocks, Type C1 1:3:6 (20mm graded aggregate) exc. 10 cm in width and setting in cement mortar 1:6, etc complete all as specified and directed by Engineer-in-Charge

Taking down cement or cement lime plaster on brick or stone walls, etc., including raking out joints, hacking for key, scrubbing down with water, etc complete all as specified and directed by Engineer-in-Charge

M & L for rendering 15mm thick on fair faces of brick work or concrete surfaces in cement mortar 1:4, finished even and smooth without using extra cement etc complete all as specified and directed by Engineer-in-Charge

M&L for preparing new plastered surfaces and applying Two coats of cement base paint over a coat of alkali resistant primer on surfaces of walls etc complete all as specified and directed by Engineer-in-Charge

M & for Plain Cement Concrete Type B0 1:2:4 (using 12.5 mm graded granite stone aggregate) in lintels upto 1.5m clear span, copings, kneelers, including weathering, slightly rounded or chamfered angles and throating etc complete all as specified and directed by Engineer-in-Charge

S & F Mild steel work in framed work such as grills, gratings,framed guard bars, ladders etc., with ends of bars shouldered and/ or riveted, or forged into spikes, and similar work confirming to Fe 290 Gde E-165 etc complete all as specified and directed by Engineer-in-Charge

M&L for preparing new surfaces of steel of any description over 10cm width or girth and apply two coats of synthetic enamel paint over a coat of red oxide primer etc complete all as specified and directed by Engineer-in-Charge

Returning, filling in, including spreading, levelling, watering and well ramming in layers not exceeding 25 cm thick with soils etc complete all as specified and directed by Engineer-in-Charge

Removing Excavated soils not exc 50 M and depositing where directed at a level not exc1.5 M above the starting point etc complete all as specified and directed by Engineer-in-Charge

S & F RCC Class NP -3, 300 mm bore pipes laid and jointed complete with collars etc complete all as specified and directed by Engineer-in-Charge

M & L for Extra for forming fair finished drain or channel 30 cm inner girth in cement concrete, using extra cement, including forms, moulds, mitred/stopped ends etc complete all as specified and directed by Engineer-in-Charge

Supply and fix in repairs 110 mm dia PVC SWR pipe, single socketed in any length with rubber ring joints fixed in trenches etc complete all as specified and directed by Engineer-in-Charge

M&L for preparing old painted surfaces by washing, rubbing down and stopping of painted surfaces and applying a coat of cement base paint on surfaces of walls etc complete all as specified and directed by Engineer-in-Charge

An amount of Rs 60,000.00 shall be deducted from BOQ on account of schedule of credit

M/S. Z.K.ENTERPRISES, AHMEDNAGAR

OM SAI ASSOCIATES

M/s A G Gund

M/S. YADAV ENTERPRISES

Ms. M.D. Auty

R. T. Saluji

DAKSH ENGINEERS AND BUILDERS

MS. G.A. CONSTRUCTION