Additional improvement works at Kavundampalayam Crematarium at Ward no 17 , West zone

Dismantling the Existing damaged plain cement concrete in Cement Morter including all labour Charges as per the Direction of the Departmental officers Etc., Complete.

Dadooing Supplying and laying in flooring with fully polished SintheticGrey colour Granite stone of 10mm thick (average) of 2' X 1' in size laidin cement mortar 1:2 (one cement and two Plastering sand) 20mm thick & pointed with same colour of cement etc., complete as per standard specification

Earth work excavation and depositing on bank within initial lead of 10M and initial lift of 2 metre in hard stiff clay stiff black hard red earth shales murums, gravel stoney earth and earth mixed with small size boulders and hard gravelly soil, etc., complete complying with standard specification.

CEMENT CONCRETE 1:4:8 (One cement, four sand and eight aggregate) using 40mm gauge hand broken hard granite stone jelly for FOUNDATION including dewatering if found necessary and laid in layers of not more than 15cm thick, well rammed etc., complete complying with standard specification.

Fillling with well gravel layers of not more than 30cm thick,well rammed, watered and compacted, complying with standard specification etc., complete.

Plastering with C.M. 1:5 Mix (one cement and five sand) 12mm thick finishing including cost and conveyance of all materials to site and all labour charges, watering curing and all other incidental charges etc., complete complying with standard specification.

Cement concrete 1:2:4 (one cement, two sand and four aggregate) using 40mm gauge hand broken granite stone jelly for foundation including dewatering if found necessary and laid in layers of not more than 15 cm thick and compacted, etc., complete complying with standard specification.

Painting two coats for Exterior surface with approved Exterior PlasticEmulsion paint approved quality and colour over a priming coat,including thorough scrapping, clean removal of dirt, etc complete andincluding necessary plaster of paris, putty, wherever required etc,complete as per standard specification.

Providing flooring with rubber mould interlocking paver block M40 providing and laying of 63mm thick high strenghth type conforming IS15658-2006 of rubberised intrlocking paver block in size of minimum compressive strength of 40N/mm2 in uniform size of approved make to be laid in flurring bone pattern with sand cushion below the uniform shape of approved non skitting surface in the top and the rate including the levelling the base preparation of pavers as sub base, sand cushion 150 mm thick laying out of pavement cut the pieces to fix the edge vibring the pavers, sweeping transporting loading unloading of laying paver block as per specification

Design, manufacture, supply, and installation of an LPG-fired automated cremation furnace system suitable for continuous and efficient cremation operations. The furnace shall be constructed with a 4 mm thick heavy-duty insulated steel outer shell reinforced with structural channels for enhanced strength and durability. The internal lining shall consist of high-grade refractory materials including IS-8 grade fire bricks, cold-face insulation bricks, and ceramic fiber insulation to minimize heat loss and ensure long service life. The combustion system shall comprise a primary cremation chamber, secondary combustion chamber, and flue gas outlet arrangement designed for complete combustion and uniform heat distribution.The furnace shall be provided with insulated access-cum-ash removal doors at the rear side with manual operation. The system shall be designed for semi-automatic/automatic operation with reduced manual intervention and safe operating conditions.The front loading door shall be of vertical sliding type (up-and-down movement) with heavy-duty frame construction, ceramic fiber blanket insulation, and suitable door closing arrangement.