CONSTRUCTION OF SECURITY GUARD ROOM

Amount

Earth work in excavation by mechanical means (Hydraulic excavator)/Manual means over areas exceeding depth 30CM and width 1.5M

Supplying and filling in plinth with sand under floors, including watering, ramming, consolidating and dressing completed

1:3:6 (1 Cement : 3 coarse sand (zone-III) derived from natural sources.

Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering and shuttering and finishing and reinforcement work 1:1.5:3

Centering and shuttering including strutting, propping etc. and removal of form work for foundations, footings, bases of columns etc. for mass concrete

Steel reinforcement for R.C.C. work including straightening, cutting, Thermo-Mechanically Treated of grade Fe-500D or more

Half Brick work 7 cm thick with common burnt clay F.P.S. (non modular) prop. 1:4

Structural steel work in single section, fixed with or without connecting plat, including hoisting, fixing inposition with a coat of primer

Brick flat soling

Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugations as approved by Engineer-in-charge

Providing and fixing precoated galvanised steel sheet roofing accessories 0.50mm total coated thickness, Zinc coating

12 mm cement plaster of mix :1:4

Distempering with 1st quality acrylic distemper (ready mixed) having VOC content not less than 50Gms/ litre, of approved manufacturer specifications , Two coats on new work

Applying one coat of water thinnable cement primer of approved brand and manufacturer on wall surface

Finishing walls with two coats Acrylic Smooth exterior paint of required shade : over and including priming coat of exterior primer @ 2020kg/10sqm.

Providing and fixing glazing in aluminium door, window, ventilator shutters and partitions etc. with EPDM rubber/ neoprene gasket etc. complete as per the architectural drawings and the direction of Engineer-in charge . With float glass thickness 5mm

Providing and fixing anodised aluminium grill (anodised transparent or dyed to required shade according to IS: 1868 with minimum anodic coatings of grade AC-15 fixed to existing window frame with CP brass/ stainless steel screws @200mmc/c cutting the grill to proper opening sizes .

Prelaminated particle board with one side decorative and other side balancing laminations, flat pressed 3 layers & graded medium density grade-I, type-II conforming to IS: 12823 25mm thick

Providing and fixing aluminium work for doors, windows, ventilators and partitions with extruded built up standard tubular sections/appropriate Z sections and other sections of approved makeconforming to IS: 733 and IS: 1285, fixing with dash fasteners ofrequired dia and size, including necessary filling up the gaps atjunctions, i.e. at top, bottom and sides with required EPDM rubber/ neoprene gasket etc. Aluminium sections shall be smooth, rust free,straight, mitred and jointed mechanically wherever required including cleat angle, Aluminium snap beading for glazing / paneling, C.P. brass / stainless steel screws, all complete as per architectural drawings and the directions of Engineer-in-charge. Powder coated Aluminium thickness of powder coating is 50 micron

Anodized aluminium sliding door bolt 250MMx16MM

Anodized aluminium Tower bolt 150MMx10MM barrel type

62 mm thick cement concrete flooring with concrete hardener topping,

SRI RUPAM SONOWAL

ANUPAM ROY