Modernization of Divisional office Executive Engineers Room under Annual Stage maintenance and repairs

Providing and fixing one layer of 5mm Matt / Gloss Pelican Systems PVC Ceiling Board with different size and pattern as approved by the Engineer- in-charge and as per manufacturer's specification at all height including providing and fixing of frame work made of special sections pressed from M.S. sheets and galvanized with zinc coating of 120 gms/sqm (both side inclusive) as per IS : 277 and consisting of angle cleats of size 25 mm wide x 1.6 mm thick with flanges , at 1200 mm centre to centre, one flange fixed to the ceiling with dash fastener 12.5 mm dia x 50mm long with 6mm dia bolts, other flange of cleat fixed to the angle hangers of 25x10x0.50 mm of required length with nuts & bolts of required size and other end of angle hanger fixed with intermediate G.I. channels running at the spacing of 1200 mm centre to centre.

Providing and fixing in position wardrobe/cabinet (10 to 12 inches deep) made of 19mm ply to ply finished with 1mm decorative finished laminate as per design details including inner shelves, inner mica, shutter, glass panes, supporting ply backing supporting hardware and accessories, framing, secrew, nails, with required/specified adhesive, edge tape and necessary fixing arrangments as required etc complete as per detailed drawing, pattren, shade, specification as directied by EIC.

Providing and fixing of 35mm thick full panneled and carved shutters for doors (KD) including ISI marked M.S pressed butt hinges bright finished, Mortice and latch lock and other fixtures of Required size with necessary screws. Incl. finishing with high gloss Duco polish of required shade.

P/F of 20mm thick wall mounted TV unit, built with ply to ply board, finished with 1mm finished decorative laminate as per design details including shelves , mounted with nails/screws & necessary fixing arrangements as required.

Providing and fixing of imported carpet of approved make and shade, wall-to-wall, of minimum 8–10 mm pile height (or as approved by the Engineer-in-Charge) including surface preparation, stretching, cutting, fitting, pasting / tacking, edge finishing, skirting cut-outs, and all leads, lifts and carriage complete, for Executive Engineer’s retiring room, as per directions of Engineer-in-Charge.

Refitting of existing Air Conditioner unit, including careful removal of indoor and outdoor units, repositioning at new approved location within the same room, refixing on wall , reconnecting refrigerant piping, drain pipe and electrical connections,vacuming , testing and commissioning, complete in all respects, as per directions of Engineer-in-Charge.