SPECIAL REPAIR FOR HIGH MAST LIGHT AND OTHER CONNECTED ITEMS AT AFS SONEGAON, NAGPUR

Amount

Taking down, Fabricate, supply, install, test & commissioning of LT panel board as per manufacturer's specification as MCB TPN 63A as incomer, single dial time switch, 25 Amps TP contactor, for automatically switching ON & OFF luminaires & power tool control with 2 Nos 09 Amps contactors & raised lower push button, incomings 35 sqmm & outgoing 25 & 2.5 sqmm terminals, dust & vermin proof with front opening 440V 3Ph 4 wire with internal copper wiring including cable gland, lugs, two coats of red oxide primer & mounted on angle iron frame of 50 x 50 x 6 mm & height of angle iron frame above ground level is 0.3mtrs & below ground level is 0.5mtrs with PCC work as per manufacturer's specification & painting of panel with synthetic enamel paint over a coat of red oxide primer including erection of panel complete all as specified and directed. Note:- Design of LT panel board shall be as suggested by the manufacturer's of High Mast light and as approved by AGE(I).

Supply and fix in repair LED flood light 210 watt for high mast light 230 V AC outdoor type with thermal management in multiple optics and equipped with IP66 protection, with impact and corrosion resistant complete with driver and lamp. complete all as specified and directed.

Supply and fix in repair LED flood light 400 watt for high mast light 230 V AC outdoor type with thermal management in multiple optics and equipped with IP66 protection, with impact and corrosion resistant complete with driver and lamp. complete all as specified and directed.

S & F in repair Single Aviation light LED Bulb complete all as specified and directed.

Earthing complete with galvanized steel earth plate electrode 60 cm x 60cmx6.3 mm thick, buried directly in ground vertically (earth pit not less than 2.25 m deep below ground level) with top edge of the earth plate not less than 1.5m below ground level , connected to GI strips of size 25 x 4 mm as earthling lead by means bolts and nuts check nuts and washers of galvanized iron and connected to main switch board including watering arrangement with PCC chamber , MS funnel, wire mesh. CI cover with frame etc including necessary excavation in any type of strata , returning, filling removal of soil outside MD land ,filling of charcoal and salt complete all as shown in electrical plate No. 5 of MES Sch Part I , connected to Earthing test point including taking down all as specified and directed and testing on completion.

Material and labour for repair of mechanism of high mast and rewinding of three phase tower motor 440 volt AC including dismantling from high mast and transportation to workshop for rewinding with existing size of super enameled copper wire, replacing of gear , bearing bush, with burnt control cable replaced from motor to high mast LED light 2.5 sq mm 24 core copper cable complete etc for running of rope at satisfactory level and reinstallation complete all as specified and directed.

Material and labour for repair of mechanism of high mast and rewinding of three phase tower motor 440 volt AC including dismantling from high mast and transportation to workshop for rewinding with existing size of super enameled copper wire, replacing of gear , bearing bush, with burnt control cable replaced from motor to high mast LED light 2.5 sq mm 19 core copper cable complete etc for running of rope at satisfactory level and reinstallation complete all as specified and directed.

chronicle enterprises