Providing north side entry to lift passage and storm water drain ramp for two wheeler parking near TRC hall painting of front side grill and gate and Misc civil maintenance works at Telephone Bhavan campus Kolhapur

Amount

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level :

a) 1:4:8 (1 Cement : 4 coarse sand : 8 graded stone aggregate 40 mm nominal size).

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level :

a)1:2:4 (1 cement : 2 coarse sand (zone III): 4 graded stone aggregate 20 mm nominal size)

Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - All work up to plinth level :

a) 1:1.5:3 (1 cement : 1.5 coarse sand (zone-III) derived from natural sources : 3 graded stone aggregate 20 mm nominal size derived from natural sources)

Centering and shuttering including strutting, propping etc. and removal of form work for :

a) Columns, piers, abutments, pillars, posts and struts

b) Stairs, (excluding landings) except spiral-staircases

Steel reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding all complete upto plinth level.

a) Thermo-Mechanically Treated bars of grade Fe-500D or more.

Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete.

a) Hot finished welded type tubes

Providing and laying Ceramic glazed floor tiles of size 300x300 mm (thickness to be specified by the manufacturer) of 1st quality conforming to IS : 15622 of approved make in colours such as White, Ivory, Grey, Fume Red Brown, laid on 20 mm thick cement mortar 1:4 (1 Cement : 4 Coarse sand), Jointing with grey cement slurry @ 3.3 kg/sqm including pointing the joints with white cement and matching pigment etc., complete

Providing and fixing 600x450 mm beveled edge mirror of superior glass (of approved quality) complete with 6 mm thick hard board ground fixed to wooden cleats with C.P. brass screws and washers complete.

Providing and fixing white vitreous china flat back or wall corner type lipped front urinal basin of 430x260x350 mm or 340x410x265 mm sizes respectively.

Providing and fixing on wall face unplasticised Rigid PVC rain water pipes conforming to IS : 13592 Type A, including jointing with seal ring conforming to IS : 5382, leaving 10 mm gap for thermal expansion

a) Single socketed pipes.

i) 75 mm diameter

Providing and fixing on wall face unplasticised - PVC moulded fittings/ accessories for unplasticised Rigid PVC rain water pipes conforming to IS : 13592 Type A including jointing with seal ring conforming to IS :5382 leaving 10 mm gap for thermal expansion.

a) Bend 87.5°

i) 75 mm bend

b) Single tee with door

ii) 75x75x75 mm

Providing and fixing G.I. pipes complete with G.I. fittings including trenching and refilling etc.

External work

a) 15 mm dia nominal bore

b) 25 mm dia nominal bore

Providing and fixing G.I. Union in G.I. pipe including cutting and threading the pipe and making long screws etc. complete (New work) :

a) 15 mm nominal bore

b) 25 mm nominal bore

Providing and fixing IS : 12817 marked stainless steel butt hinges (heavy weight) with stainless steel screws etc. complete

a) 125x64x2.50 mm

Providing and fixing bright finished brass butt hinges with necessary screws etc. complete :

a) 100x85x5.5 mm (heavy type)

Providing and fixing aluminium die cast body tubular type universal hydraulic door closer (having brand logo with ISI, IS : 3564, embossed on the body, door weight upto 35 kg and door width upto 700 mm), with necessary accessories and screws etc. complete.

Providing and applying white cement based putty of average thickness 1 mm, of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete.

Wall painting with premium acrylic emulsion paint of interior grade,having VOC (Volatile Organic Compound ) content less than 50 grams/ litre of approved brand and manufacture, including applying additional coats wherever required to achieve even shade and colour.

a) Two coats

Finishing walls with Premium Acrylic Smooth exterior paint with Silicone additives of required shade:

a) New work (Two or more coats applied @ 1.43 ltr/10 sqm over and including priming coat of exterior primer applied @ 2.20 kg/10 sqm)

Finishing walls with water proofing cement paint of required shade :

a) Old work (one or more coats @ 2.20 kg/10 sqm) complete.

Providing and fixing bright finished brass 100 mm mortice latch and lock with 6 levers and a pair of lever handles of approved quality with necessary screws etc. complete.

Providing and fixing stainless steel soft closing heavy type telescopic drawer channels of approved make 500 mm long with screws etc. complete as per directions of Engineer- in-charge.

Providing and fixing bright finished brass handles with screws etc. complete:

Providing and fixing C.P. brass long body bib cock of approved quality conforming to IS standards and weighing not less than 690 gms.

a) 15 mm nominal bore

Providing and fixing C.P. brass stop cock (concealed) of standard design and of approved make conforming to IS:8931.

a) 15 mm nominal bore

Providing and fixing unplasticised P.V.C. connection pipe with PTMT Nuts, collar and bush of approved quality and colour.

a) 15 mm nominal bore with 45 cm length

Renewing glass panes, with putty and nails wherever necessary including racking out the old putty:

a) Float glass panes of thickness 4 mm.

Demolishing cement concrete manually/ by mechanical means including disposal of material within 50 metres lead as per direction of Engineer - in - charge.

a) Nominal concrete 1:3:6 or richer mix (i/c equivalent design mix)

Demolishing brick work manually/ by mechanical means including stacking of serviceable material and disposal of unserviceable material within 50 metres lead as per direction of Engineer-in-charge.

a) In cement mortar

Providing and fixing P.V.C. waste pipe for sink or wash basin including P.V.C. waste fittings complete.

a) Flexible pipe

i) 32 mm dia

Repairs to plaster of thickness 12 mm to 20 mm in patches of area 2.5 sq.meters and under, including cutting the patch in proper shape, raking out joints and preparing and plastering the surface of the walls complete, including disposal of rubbish to the dumping ground, all complete as per direction of Engineer-in-Charge.

a) With cement mortar 1:4 (1cement: 4 coarse sand)

Dismantling old plaster or skirting raking out joints and cleaning the surface for plaster including disposal of rubbish to the dumping ground within 50 metres lead.

Disposal of moorum/building rubbish/ malba/ similar serviceable, dismantled or waste material by mechanical transport including loading, transporting, unloading to approved municipal dumping ground for lead upto 10 km for all lifts, complete as per directions of Engineer-in-charge.

Excavating trenches of required width for pipes, cables, etc including excavation for sockets, and dressing of sides, ramming of bottoms, depth upto 1.5 m, including getting out the excavated soil, and then returning the soil as required, in layers not exceeding 20 cm in depth, including consolidating each deposited layer by ramming, watering, etc. and disposing of surplus excavated soil as directed, within a lead of 50 m

a) Pipes, cables etc. exceeding 300 mm dia but not exceeding 600 mm

b) Pipes, cables etc. exceeding 80 mm dia. But not exceeding 300 mm dia

Removing white or colour wash by scrapping and sand papering and preparing the surface smooth including necessary repairs to scratches etc. complete

Removing dry or oil bound distemper, water proofing cement paint and the like by scrapping, sand papering and preparing the surface smooth including necessary repairs to scratches etc. complete.

Distempering with oil bound washable distemper of approved brand and manufacture to give an even shade :

a) New work (two or more coats) over and including water thinnable priming coat with cement primer

Painting with synthetic enamel paint of approved brand and manufacture of required colour to give an even shade :

a) One or more coats on old work

b) Two or more coats on new work

Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 3.5 in foundation and plinth in:

a) Cement mortar 1:6 (1 cement : 6 coarse sand)

15 mm cement plaster on the rough side of single or half brick wall of mix :

a) 1:6 (1 cement: 6 coarse sand)

Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead upto 50 m and lift upto 1.5 m, as directed by Engineer-incharge.

a) All kinds of soil

Cleaning of manholes by rodding, scrubbing and flushing to remove the clogged drain of sludge,waste & rubbish material and disposal where permitted by the Municipal corporation dumping places etc as per the direction of Engineer - in - charge thinnable priming coat with cement primer

Cleaning of gully trap to remove the clogged drain of sludge,waste & rubbish material and disposal where permitted by the Municipal corporation dumping places etc as per the direction of Engineer - in - charge

Cleaning of sewer line including removing choke up and removal of sludge & connecting SW pipe from manhole to manhole and connecting gully trap etc.complete including disposal of sludge etc. outside the premises .

a) Sewer line upto 150mm dia.

Cleaning of storm water drain of section upto size 0.45 m X 0.60 m by removing dust/debris/dry leaves and disposing the same within 50 m lead as directed by engineer in charge

Repairing the wooden flush door by removing the same from position carefully and carrying out the necessary repairs by replacing the unserviceable hinges if any & making it in operational condition and refixing the same at original position and as direction of Engineer in charge ( Note- cost of hinges will be paid in relevant item).

a) Door shutter area above 3 Sqm

Repairing the wooden flush door without removing it from its position by keeping it in its position and carrying out the necessary repairs, fastening the hinges with old or new screws if required making it in operational condition etc all complete and as direction of Engineer in charge (Note- Rate inclueds cost of new screws if required )

a) Door shutter area below 3 Sqm

Providing and fixing 33 to 35 mm thick cudappah stone over manhole , gully trap etc. including fixing with cement mortar etc. complete and as per the direction of the Engineer in Charge.

Providing and fixing unplasticised - PVC pipe clips of approved design to unplasticised - PVC rain water pipes with necessary nails etc. complete

Providing and fixing U drain PVC pipes (4KN/sqm) confirming IS 15328 in required slope and jointed together with jointing couplers as per manufacturers specification and other end socketed including jointing with couplings wherever necessary with PVC cement solvent testing of joints etc complete, and as directed by Engineer-in-charge. (Cost of jointing Couplers to be paid for separately)Finolex, Supreme or equivalent make.

Providing and fixing brass Patti valve / quarter turn of approved quality.

a) 15 mm nominal bore

Removing & refixing existing G.I. water pipe with fittings for removing choke up in pipe line, including cost of scaffolding/zulla etc. complete as directed by Engineer-in-charge.

a) Upto 40mm dia.

Providing and fixing APVC pipes, including all APVC plain & brass threaded fittings, including fixing the pipe with clamps at 1.00 m spacing. This includes jointing of pipes & fittings with one step APVC solvent cement and testing of joints complete as per direction of Engineer in Charge.

Internal work - Exposed on wall

a) 15 mm nominal outer dia. pipes.

Extra for head carrage of moorum /building rubbish/ similar un-serviceable, dismentled or waste material beyond 50 mtr. etc. complete as per directions of Engineer-in-charge.

Providing and fixing APVC Union in APVC pipe line, including cutting and fixing with cement solvent etc complete (New work)

a) 15 mm nominal outer dia. pipes.

Providing and fixing 2nd class teak wood lipping/ moulded beading or taj beading of size 25X12 mm fixed with wooden adhesive of approved quality and screws/nails as per direction of Engineer-in-charge.

Providing and fixing water proof plywood 19 mm thick of approved make including cutting, fitting with necessary screws and wood adhesive for bonding. etc. complete as per direction of the Engineer-in-Charge

Removing aluminium partition including dismembering of all members like aluminium sections,glazing clips, particle board, glass, u beadings, grills, etc. and stacking of serviceable material and disposal of unserviceable material within 50 metres lead as directed by Engineer in charge.(The serviceable material shall be handed over to BSNL authorities)

Erecting/re-fixing aluminum partition with available material at required location and floor and size as per the site requirement including washing/cleaning of old aluminium material (pipes, doors, glazing clips etc.), cutting and joining to required size and shape and fixing at locations using new screws, cleats, neoprene gasket, rubber beading etc. complete and as per the directions of Engineer in charge.

Removing of shrubs/bushes from walls/sanitary pipes of buildings at any height including removing roots etc. and applying chemical of anti-birth plant and filling the hole by cement mortar 1:4 etc. complete as per the direction of Engineer-in-charge.

Removing of shrubs/bushes from walls/sanitary pipes of buildings at any height including dismantling and repairing as is where wall/parapet for removing roots etc. and applying chemical of anti-birth plant and filling the hole by cement mortar 1:4 etc. complete as per the direction of Engineer-in-charge.

a) Big shrubs/bushes (height more than 1m)

Lettering as "BSNL" with blue oil paint of approved brand and manufacture

Fixing available 18 mm thick granite for facias and similar locations of required size and shape laid over 20 mm thick base cement mortar 1:4 (1 cement : 4 coarse sand), joints treated with white cement, mixed with matching pigment, epoxy touch ups, including cleaning and removing cement morter, rubbing, curing, moulding and polishing to edges to give high gloss finish etc. complete at all levels as per direction of Engineer-in-Charge.

a) With granite stone of area less than 0.50 sqm.

Providing and fixing Entrance door lock of Godrej or equivalent make with mortise latch and lock with double throw levers etc. complete as directed by Engineer -in-charge.

Transportation of aluminium partition material from old civil office , Sanchar colony to Tele. Bhavan, Kolhapur including loading , transportation, unloading, carrage at work place etc, allied activityes all complete as per direction of Engineer-in-charge.