Providing Aluminum fixed partition with glazing at rear verandah of Maternity ward and providing flooring tiles at GF and First Floor of OPD of GH Mahe.

Amount

Code No. 10.25.2:- Steel work welded in built up sections framed work , including cutting,hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. as required - in gratings, frames, guard bar, ladder, railings, brackets,gates and similar works

Code No. 11.46.1:- Providing and laying vitrified tiles of size 500 x500 mm (thickness to be specified by manufacturer), with water absorption less than 0.08% and conforming to IS :15622 , of approved make , in all colours & shade, in skirting , riser of steps , over 12 mm thick bed of cement mortar 1:3 (1 cement :3 coarse sand), including grouting the joint with white cement & matching pigments etc.complete - size of tile 500x500mm

Code No. 11.61:- Providing and laying 22 mm thick factory made pre-polished cement concrete flooring tiles of required colour and design over 20 mm thick cement mortar 1:4 (1 cement : 4 sand ) and jointed with cement slurry mixed with an admixture of pigment to match the shade of the tile - (Endura \ Ultra \Dazzle \ Technic)

Code No. 12.47.2:- Providing & fixing UV stabilised fibre glass reinforced plastic sheet roofing upto any pitch, including fixing with polymer coated 'J' or 'L' hooks, bolts & nuts 8mm dia G.I.plain / bitumen washers complete but excluding the cost of purlins , rafters ,trusses etc. The sheets shall be manufactured out of 2400 TEX panel rovigs incorporting minimum 0.3% ultra -voilet stabiliser in resin system under approximately 2400 psi and hot cured. They shall be of uniform pigmentation and thickness without air pockets and shall conform to IS 10192 and IS 12866. The sheets shall be opaque or translucent, clear or pigmented , textured or smooth as specified - 2mm thick flat

Code No. 15.56:- Dismantling old plaster or skirting raking out joints and cleaning the surface for plaster including disposal of rubbish to the dumping ground within 50 metres lead

Code No. 21.3.2:-Providing and fixing glazing in aluminium door, window , ventilator shutters and partitions etc. with EPDM rubber / neoprene gasket etc. complete as per the architectural drawings ( cost of aluminium snap beading shall be paid in basic item) -with float glass panes of5.50 mm thickness

Code No. 21.1.1.1:-Providing and fixing aluminium work for doors, windows, ventilators and partitions with extruded built up standard tubular sections / appropriate Z sections and other sections of approved make conforming to IS:733 and IS: 1285, fixing with dash fasteners of required dia and size, including necessary filling up the gaps at junctions , i.e at top, bottom and sides with required EPDM rubber / neoprene gasket etc. Aluminium sections shall be smooth, rust free, straight, mitred and jointed mechanically wherever required including cleat angle, aluminium snap beading for glazing / paneling , C.P.brass / stainless steel screws , all complete as per architectural drawings (Glazing, paneling and dash fasteners to be paid for separately) - for fixed portion - anodised aluminium (anodised transparent or dyed to required shade according to IS:1868, Minimum anodic coating of grade AC 15)

C. SATHYANATHAN