SITC of Outdoor LT Panel near shopping complex and providing and laying of 3.5 core X95 sq.mm UG cable from LT Panel to Health Centre in UoH campus

1) The estimated amount is inclusive of GST. 2) The Bidder should quote basic rates exclusive of GST and quote GST percentage separately. GST should be revised from time to time.

Supply, installation, testing and commissioning of 3 Phase and neutral 415V, Outdoor type Fully Compartmentalized LT Panel, made of 2/1.6mm thick CRCA Sheet, with double door arrangement, making powder coating after processing of 7 Tank process, painting with acrylic powder coating the panel shall consist of suitable rating aluminum busbar of suitable rating capacity supported with DMC / SMC barrers and colour coaded with heat shrinkable sleeves, lock and key, hinges, rubber gasket, danger board, suitable angle iron stand for mounting the feeder panel board with cement concrete, including Supply and fixing MCCB'S & MCB'S as out goings, neutral bus bar link, shrouding’s, gland plates etc., complete for finished item of work. The panel shall have short circuit with standing capacity of minimum 36KA breaking capacity and switch gearconsisting as mentioned below.Incomer: (i)250A FP 36KA TM based MCCB with Adj. OL,SC. of type DN1----1 No. Busbar: 250Amps TPN Aluminium busbar ---1set. (ii) Multifunction Meter-------1 No (iii) Phase Indication Lamps LED 22.5Dia of type Esbee----------3 No's. (vi) 250/5A CL 1.0,15VA Tape Wound CT's of type TW ----------3 No's. Make: Kappa. (vii) 6A SP 10KA "C" Curve MCB of type Exora ------------------------3 No's Out Going: Following MCCBs with TM based MCCB with Adj. OL, SC of type DN0 i) 200A FP 25KA MCCB ---------1 No's ii) 160A FP 25KA ---------1 No iii) 100A FP 25KA---------4 No's iv) 63A FP 25KA ---------2 No's

Laying of one number PVC insulated and PVC sheathed / XLPE power cable of 1.1 KV grade of following size direct in ground (75 cm below ground level) including excavation, sand cushioning, protective covering and refilling the trench etc. as required.Above 35 sq. mm and upto 95 sq. mm

Laying and fixing of one number PVC insulated and PVC sheathed / XLPE power cable of 1.1 KV grade of following size on wall surface as required. Above 35 sq. mm and upto 95 sq. mm (clamped with 25x3mm MS flat clamp)

Supplying and fixing cable route marker with 10 cm X 10 cm X 5 mm thick G.I. plate with inscription there on, bolted /welded to 35 mm X 35 mm X 6 mm angle iron, 60 cm long and fixing the same in ground as required.

Supplying and making end termination with brass compression gland and aluminium lugs for following size of PVC insulated and PVC sheathed / XLPE aluminium conductor cable of 1.1 KV grade as required. 3½ X 95 sq. mm (45mm)

3½ X 120 sq. mm (45mm)

3½ X 150 sq. mm (50mm)

4 X 16 sq. mm (28mm)

4 X 25 sq. mm (28mm)

Supply of 3.5 core x 95 sqmm XLPE insulated Aluminium Armoured cable of 1.1 KV grade etc. as required. 12 mm cement plaster of mix :

1:6 (1 cement: 6 fine sand)

Cutting road and making good the same including supply of extra quantities of materials i.e. aggregate, moorum screening, red bajri and labour required.bituminous portion

Water bound macadam

Cement concrete 1:2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate 40 mm nominal size) in pavements, laid to required slope and camber in panels as required including consolidation finishing and tamping complete.

Please Enable Macros to View BoQ information