REPAIR REPLACEMENT OF BOUNDARY WALL FENCING GATE AND AREA DRAINAGE AND MISC REPAIR ETC FOR 509 ABW MIL WING SP LINE GWALIOR ROAD KB LINE GE OFFICE ARO ETC UNDER AGE BRII OF GE EAST AGRA

Amount

S&F in repais galvanised ,2 srand steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacing and staining rail staining bolts incl, securing or tying at crossing with and provision of galvanised mild steeled wire staples or steel pins etc as directed (each line wire to be measured) including taking down existing barbed wire complete all as specified and directed.

M&L for restraining resecuring including making good staples etc. old galvanised steel barbed wire with galvanised mild steeled wire staples or steel pins etc complete all as specified and directed.

Supply only GI chain link fencing including line wires to any type of standards, rails, straining bolts, etc. complete all as specified and directed. Note :- Line wire and flat iron will be measured and paid separately

Fixing in repairs GI chain link fencing including line wires to any type of standards, rails, straining bolts, etc. including provission of flat iron for securing with post including taking down existing chain link fencing complete all as specified and directed. Note :- Line wire and flat iron will be measured and paid separately

S &F of Mild steel round bars Fe 290 (Gde - E-165)10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clipscomplete all as specified and directed.

Demolition of cement concrete in ground floor and paving n exc 15cm thickness (below or above the ground level) built in cement mortar complete all as specified and directed.

M&L for 75 mm thick Cement concrete type C1, 1:3:6 (using 20 mm graded stone aggregate) in hard standing and plinth protection etc complete all as specified and directed.

M&L for demolition of reinforced cement concrete of any description and in any position complete all as specified and directed by Engineer in Charge

M&L for re-inforced cement concrete Type B-1 , 1:2:4 (20mm graded aggregate) (nominal mix) for slab supported on wall, beam and coumn in floors, roofs, landings, balconies, canopies,deck slabs and in shelves etc complete all as specified and directed by engineer-in-charge.

M&L formwork to soffits of suspended slabs suchas roof slabs, floor slabs, landing and similar work n exc 200mm thick (Horizantal or sloping ) for flat foir finished surfaces complete all as specified and directed.

M & L formwork to edges of concrete roofs exc 10cm n esc 20cm wide for fair finished surface complete all as specified and directed.

S&F TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and directed.

Dismantling of wrought iron of mild steel work of any description not otherwise poivided complete all as specified and directed.

Dismantling posts or struts (wood, steel or R.C.C.) any section, including taking out embedded portion from concrete/ brick work masonry etc and making good disturbed ground complete all as specified and directed.

S & F angle iron as in post and struts in fencing including embedding in concrete, cutting tops to shape as directed, drilling holes, notching for wire etc flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., simillar work confirming to Fe-290 Gde E-165 complete all as specified.

M&L for two coat of sythetic enamel paint over one coat of red oxide primer on new steel surfaces of any description ,over 10cm in width or girth not otherwise described including preperation of surface complete all as specified and directed.

M&L for one coat of sythetic enamel paint on previously treated/ un treated old steel surfaces of any description ,over 10cm in width or girth not otherwise described including preperation of surface complete all as specified and directed.

Demolition of brick work or stone/ boulder Masonry, built in cement mortar including all quoins, pillars etc including removal of spoil etc complete from drain. (No extra payment shall be claimed on this account) complete all as specified and directed.

Taking down cement plaster on brick or stone walls, etc., including raking out joints, hacking for key, scrubbing down with water, etc.complete all as specified and directed.

M&L for brick work with subclass B bricks old size straight or curved on plan exc 6 m mean radius built in cement mortar 1:6 complete all as specified and directed.

All as per item no 20 above but except brick (using old brick) complete all as specified and directed.

M&L, rendering 15 mm thick in CM 1:4 on fair faces of brick work or concrete surface and finishing surface fair and even complete all as specified and directed.

M&L, rendering 15 mm thick in CM 1:4 on surface other than fair face of brickwork or on one side of lathing and finishing surface fair and even complete all as specified and directed.

M&L for preparing newly plastered surfaces of wall and applying two coats of cement base paint over a coat of white cement as a priming coat complete all as specified and directed.

M&L for PCC 1:2:4 type B1 (20mm graded Agg) 40mm thick as in surface channel and drains manhole etc all as specified and directed

M&L for PCC 1:2:4 Type B1 ( using 20 mm graded stone aggregate), in lintels upto 1.5m clear span, cills, steps; seismic and other similar bands, plinth courses, string courses, lacing courses, parapets and railings upto 60 cm in eight, copings, kneelers, apex stones bed plates, kerbs chajjas , water troughs, bed blocks and the like including weathering, slightly rounded or chamfered angles and throating, as directed incl necessary formwork etc complete all as specified and drected

M&L for cement concrete type C-2 1:3:6 (using 40 mm graded stone aggregate) in foundations, filling and mass concrete complete all as specified and directed.

M&L for 75 mm thick Cement concrete type D-2 1:4:8 (using 40 mm graded stone aggregate) in sub base of flooring/ hard standing finishing surface even and rough complete all as specified and directed.

M&L for machine pressed coloured rubber moulded chequered tiles 30 cm x 30 cm x 20 to 25 mm thick set, jointed & pointed in neat cement slurry in floors over 15mm thick screed bed in CM 1:6 complete all as specified and directed.

Excavation in trenches not exc. 1.5m wide and not exc. 1.5m depth for foundation and getting out in soft/loose soil etc. complete all as specified and directed.

Returning filling in soft/loose soil incl. spreading levelling watering and well ramming in layers n. exc 25 cm complete all as specified and directed.

Removing surplus soil to a distance n. exc 50 m and depositing where directed at a level n. exc 1.5 m above starting point complete all as specified and directed.

M&L for raking out joints/ pointing to brick work in walls or to bricks on edge in floors, surface channels, roofs, etc. complete all as specified and directed.

M&L for flush pointing in cement mortar 1:4 to brick walls in drain/ boundary wall etc complete all as specified and directed.

Taking down chowkats or frame with shutter (without taking off shutters from the frame) exc 1.5 Sqm and not exc 4.00 Sqm each complete all as specified and directed.

S&F MS work as in chowkhats of doors framing for cladding, glazing,hold fast etc and the like fixed with angle cleats connecting plates, etc conforming to (Fe-290) Gde E-165 complete all as specified and directed ( MS sheet shall be measures and paid sepratly under respective item) complete all as specified and directed.

M&L for 1.00mm thick mild steel black sheet as in steel gate and similar works cut to size, holes punched including round headed screw welded etc complete as specified and as directed.

Demolition of PCC Kerb stone any size and shape any description and in any position complete all as specified and directed..

M&L for 15 mm thick screed bed or bedding layer in CM (1:6) for laying kerb stone complete all as specified and directed..

M&L for PCC 1:2:4 type B1 molded precast kerb stone of size as directed including jointed, pointed in cement mortar 1:4 embeding in the ground to a depth as indicated, taping earth around kerb stone and also removing surplus soil etc complete all as specified and directed.

M&L preparation of newly concrete surfaces of any description over 10cm girth or width not otherwise described and applying two coats of synthetic enamel paint (any tint) over a coat of priming paints complete all as specified and directed. .

M&L preparation of old concrete surfaces of any description over 10cm girth or width not otherwise described and applying one coats of acrylic emulsion paint complete all as specified and directed. .

Taking down of old precast interlocking paver block any size and shape any description and in any position complete all as specified and directed..

M&L for 25 mm thick sand cushion layer for laying interlocking pavers complete all as specified and directed.

M&L for 80 mm thick precast PCC interlocking coloured paver rubber moulded block factory made of grade M 40 single layer monolithic high density manufactured by electro vibro hydraulically operated block making maching conforming to IS -15658- 2006 laid and jointed over sand cushion layer complete all as specified and directed. Note : Sand cusion shall be measured & paid separately

M/s D AND R CONSTRUCTION AND SUPPIERS

MNR ASSOCIATES

SHRI RADHAYSHYAM JHA

3Krishna Enterprises

M/s Rahul Kumar Agrawal

N.K. ENTERPRISES

M/S S.S Traders