SPL REPAIR/ REPLACEMENT OF LT CABLE, EARTHING, PANEL AND ALLIED WORK AT VARIOUS LOCATION UNDER GE (MCTE) MHOW

Disconnecting & dismentling of damaged/ unsv cable any type/ make and Supply & laying cable XLPE Insulated screened PVC bedded, galvanized steel strip or wire armored, electric power cables (heavy duty) 16 Sqmm 3.5 core, 1100 Volts grade with stranded aluminium conductor using lugs bothe end of cable & wrapping pvc tape over XLPE insulation cable and testing including taking down old cable complete all as directed. (Note:- Excavation & earth work, sand cushioning, bricks protection & GI pipe where required shall be measured & paid seperately)

All as per Srl item No. 1.00 above but size 25 Sqmm 3.5 core

All as per Srl item No. 1.00 above but size 35 Sqmm 3.5 core

All as per Srl item No. 1.00 above but size 50 Sqmm 3.5 core

All as per Srl item No. 1.00 above but size 70 Sqmm 3.5 core

All as per Srl item No. 1.00 above but size 95 Sqmm 3.5 core

All as per Srl item No. 1.00 above but size 120 Sqmm 3.5 core

All as per Srl item No. 1.00 above but size 150 Sqmm 3.5 core

All as per Srl item No. 1.00 above but size 185 Sqmm 3.5 core

All as per Srl item No. 1.00 above but size 240 Sqmm 3.5 core

Excavation in trenches in soft/ loose soil not exceeding 1.5 M wide and not exceeding 1.5 Mtr deep and getting out including filling bottom surface to required level or slope for laying of pipes/ cables complete all as specified and directed.

Returning filling including spreading, leveling, watering and well ramming in layers not exceeding 25 cm in soft soil complete all as specified and directed.

Removing excavated surplus soil not exceeding 50 Mtr and depositing where directed at a level not exceeding 1.5 Mtr above the starting point complete all as specified and directed.

M&L for sand cushioning with dry local sand for cable protecting under ground cable (8 cm before laying the cable and 15 cm after laying the cable) in trenches including punning the sand upto 18 cm thick and consolidated complete all as specified and directed. Note : Punned thickness 18 cm shall be measured only.

Supply and laying sub class 'B' bricks laid dry and flat across the length of cable for protection of cable including taking out old/ broken bricks complete all as specified and directed.

S &F for 50mm dia GI pipe 'light grade' ISI marked including fittings such as bends, tees, sockets etc fixed on wall/ pole or laid in trenches under road crossing/ hard standing including taking out old/ unserveciable existing pipe complete all as specified and directed. Note:- Excavation and earth work shall be measured & paid separately.

S &F for 80mm dia GI pipe 'light grade' ISI marked including fittings such as bends, tees, sockets etc fixed on wall/ pole or laid in trenches under road crossing/ hard standing including taking out old/ unserveciable existing pipe complete all as specified and directed. Note:- Excavation and earth work shall be measured & paid separately.

Supply, installation and testing of factory made, CPRI Approved cubical outdoor type feeder pillar box 415 volt, 4 wire, AC 50 Hz, made out of 3.15mm thick CRCA sheet, weather and vermin proof powder coating finish bothside (interior & exterior) for outdoor mounting with having degree of protection as per IP-56 complete factory lock two earth terminal suitable cable gland for all incoming and outgoing and removable neutral link,Both Side openable double door Indicating light LED type RYB - 01 Set, Ammeter-01, Voltmeter-01, connecting strip/ solid conductor brought out to cable chamber brass/ copper nut, bolts/ washer etc including grouting of feeder pillar box 60 cm above ground level including suitable size angle iron stand made up of 65 x 65 x 6mm welded on all the four corner embedded in PCC 1:2:4, type B-1 (using 20mm graded crushed stone aggregate) upto 30 cm including excavation and earth work complete including taking down old unsv panel with following asseccories:- (a) Aluminium busbar high conductivity 800 Amp rated 4 phase including neutral bus bar complete - 01 No. Incoming:- (b) MCCB 4 -pole 400 Amp, 415 Volt, breaking capacity 36 KA, 50 HZ with thermal magnetic release - 01 No. Outgoing:- (c) MCCB 4 - pole 100 Amps breaking capacity 25 KA, 50 HZ - 02 Nos. (d) MCCB 4 - pole 63 Amps breaking capacity 25 KA, 50 HZ - 04 Nos. (e) MCCB 4 - pole 200 Amps breaking capacity 36 KA, 50 HZ - 02 Nos.

Supply, installation and testing of factory made, CPRI Approved cubical outdoor type feeder pillar box 415 volt, 4 wire, AC 50 Hz, made out of 3.15mm thick CRCA sheet, weather and vermin proof powder coating finish bothside (interior & exterior) for outdoor mounting with having degree of protection as per IP-56 complete factory lock two earth terminal suitable cable gland for all incoming and outgoing and removable neutral link,Both Side openable double door Indicating light LED type RYB - 01 Set, Ammeter-01, Voltmeter-01, connecting strip/ solid conductor brought out to cable chamber brass/ copper nut, bolts/ washer etc including grouting of feeder pillar box 60 cm above ground level including suitable size angle iron stand made up of 65 x 65 x 6mm welded on all the four corner embedded in PCC 1:2:4, type B-1 (using 20mm graded crushed stone aggregate) upto 30 cm including excavation and earth work complete including taking down old unsv panel with following asseccories:- (a) Aluminium busbar high conductivity 400 Amp rated 4 phase including neutral bus bar complete - 01 No. Incoming:- (b) MCCB 4 -pole 200 Amp, 415 Volt, breaking capacity 36 KA, 50 HZ with thermal magnetic release - 01 No. Outgoing:- (c) MCCB 4 - pole 100 Amps breaking capacity 25 KA, 50 HZ - 01 Nos. (d) MCCB 4 - pole 63 Amps breaking capacity 16 KA, 50 HZ - 07 Nos.

Supply, installation and testing of factory made, CPRI Approved cubical outdoor type feeder pillar box 415 volt, 4 wire, AC 50 Hz, made out of 3.15mm thick CRCA sheet, weather and vermin proof powder coating finish bothside (interior & exterior) for outdoor mounting with having degree of protection as per IP-56 complete factory lock two earth terminal suitable cable gland for all incoming and outgoing and removable neutral link,Both Side openable double door Indicating light LED type RYB - 01 Set, Ammeter-01, Voltmeter-01, connecting strip/ solid conductor brought out to cable chamber brass/ copper nut, bolts/ washer etc including grouting of feeder pillar box 60 cm above ground level including suitable size angle iron stand made up of 65 x 65 x 6mm welded on all the four corner embedded in PCC 1:2:4, type B-1 (using 20mm graded crushed stone aggregate) upto 30 cm including excavation and earth work complete including taking down old unsv panel with following asseccories:- (a) Aluminium busbar high conductivity 350 Amp rated 4 phase including neutral bus bar complete - 01 No. Incoming:- (b) MCCB 4 -pole 160 Amp, 415 Volt, breaking capacity 36 KA, 50 HZ with thermal magnetic release - 01 No. Outgoing:- (c) MCCB 4 - pole 63 Amps breaking capacity 16 KA, 50 HZ - 05 Nos.

M&L for earthing with galvanized steel earth plate electrode 600 x 600 x 6.0mm thick buried directly in ground (earth pit not less than 2.25 metres deep below ground level) with top edge of the plate not less than 1.5 metre below normal ground level connected to galvanized iron 32 x 6mm strip as earthing lead protected by GI pipe light grade 40mm bore for protection of GI earth strip and 20mm dia GI pipe medium grade for watering with alternate layers of charcoal/ coke and salt including all accessories like nut, bolts, reducer, nipple, wire meshed/ screened funnel and making brick masonry finished chamber of internal size 300mm x 300mm x 300mm with concrete base, covered with a cast Iron hinged cover resting over the cast iron frame painted with black bitumastic paint which shall be embedded in the block masonry including excavation works, refilling, connected to main switch/ MCB DB for feeding the electric supply complete including dismantling of old u/s earthing complete all as specified and as shown in electrical plate No. 3 of SSR Part-I and testing of earth resistance as required. Note:- 7.5 RM strip wire upto 7.5 RM including unit rate.

Please Enable Macros to View BoQ information