Supply, Installation, Testing, Commissioning 7.5 HP submersible pumping unit and allied Electro-Mechanical Works at Water supply scheme Tawheedabad under M and E Non Plan.

Amount

Supply, Installation, Testing & Commissioning of Submersible Pumping Unit as per IS 8034 with following specification are as under: PUMP: Discharge : 5000 GPH Head : 40 Mtr Efficiency = Not less than 50% Speed = 2900 Rpm Type of pump = Mixed flow. Type of fluid to be handled = Clear Water Type of pump = Bowl Type MATERIAL OF CONSTRUCTION: Impeller = C.I /SS Pump Shaft = Stainless Steel SS 410. Pump Casing = Cast Iron/SS IMPELLER: Impeller is of the closed type and properly balanced. Enclosed Impellers equipped with seal rings on their hubs. COUPLING: A suitable coupling arrangement provided with pump set. NON RETURN VALVE: Non Return Valve of the suitable size provided above the pump discharge case. MOTOR:- Capacity of Motor = 7.5 HP Method of starting = Star – Delta/DOL (as specified) Speed = 3000 (Sync). Frequency = 50 ± 3 % Hz Working Voltage = 380-415 ± 10% V, 03 phase Efficiency = As per standard. Class of insulation = F/Suitable for above parameters Submersible motor should be water filled water lubricated squirrel cage type having capacity for above pumping parameters and working on 3 phase; AC supply ranging from 380 to 415 volts, 50Hz. The motor should be sealed by radial rings to avoid mixing of well water with motor filled water. a) The job includes providing and fitting of interlocking arrangement against any failure of coupling. It must be fabricated out of MS strips of suitable size and length. b) The job includes providing and fitting of appropriate size MS nipple 2 feet long threaded on one end and welded to same size MS flange of thickness (as per Table-17) at other end for column pipe as per site requirement. The threaded portion should be as per size of pumping out let for proper fixing. The job includes providing and fitting of R. I. cloth joints/rubber washers with nuts, bolts and washers for all joints of column pipe. The job also includes lowering of pumping unit into the Sump including proper testing and commissioning of pumping unit on full load at site. Note: Providing of test certificate & Characteristic Curve of pumping equipment is compulsory and pumping unit is to be approved from the concerned Sub Divisional office before procuring.

Providing and fitting of 10 Sqmm, 3-Core flat submersible copper cable conforming to IS: 694 (Part 1st) – 1964 & IS: 694 (Part 2nd) - 1964 for Submersible Pumping Unit and other electrical Equipments . The cable connections terminal shall be fitted with copper thimbles of required size.

M/S WASEEM TRADERS

M/S AAMIR TRADERS