V.K. KARMA GRAM PARHI MAURYA BASTI PAKKI ROAD SE P.V. HOTEY BRAMHANAND KE GHAR TAK SAMPARK MARGE KA NIRMAN

Construction of Embankment with Material Obtained from Borrow pits with a lift upto 1.50m, transporting to site, spreading, grading to required slope and compacting to meet requirement of Tables 300.1 and 300.2 with a lead upto 1000 m as per Techinacal Specification Clause 301.5

Construction of granular sub-base by providing well graded Material, Spreeding in Uniform layers with motor grader on prepared surface, mixing by mix in place method with rotavator at OMC, and compacting with smooth wheel roller to achieve the desired density, complete as per Technical Specification Clause 401.

Providing and laying WBM grade with 45-63 mm apporved quality SB in 7.50 cm thicknessconsolidating by road roller using stone dust/mooram for blinding materials/screening materialmacking medhi ,including roller including all materrial,labour,T&P

Providing and laying WBM grade with22.4-53 mm apporved quality SB in 7.50 cm thicknessconsolidating by road roller using stone dust/mooram for blinding materials/screening materialmacking medhi ,including roller including all materrial,labour,T&P

providing and laying prime coat bitumen emulsion (SS-1) on prepaired surface of grangular base including cleanning of road surface and primer at the rate of .085 km /sqm using mechanical means as per technical specification clause 502 (including cost of bitumen)

providing and layinig tack coat with bitumen emulsion using emulsion distributer at the rate of 0.25on the prepared grangular surface treated with primer &cleaned clause 503 (including cost of bitumen)

providing and layinig and rolling of open graded premix carpet of 20 mm thickness composed of 13.20 mm to 5.6 mm aggregates either using penetration grade bitumen or to required line ,grade bitumen &level to serve as wearig course on previously prepared base including mixing in a sutaible plant,laying and rolling with a three wheel 80 -100 kn static roller capacity ,finished to required level and grdes as per technical specification clause 508 (including cost of bitumen)

providing and laying seal coat the voids in a bitumenous surface to specification levels grade &cross fall using type B as per technical specifiction clause 510 (including cost of bitumen)

Cement Concrete Pavement : Construction of un-reinforced, dowel jointed at expansion and construction joint only, plain cement concrete pavement, thickness as per design, over a prepaired sub base with 43 grade cement or any other type as per clause 1501.2.2.M-30 grade coarse sand and fine aggregates confirming to IS:383 maximum size of coarse aggregate not exceding 25 mm mixed in a concrete mixer of not less than 0.2 cum. capacity and aproprete weigh batcher using approved mix design laid in a approved fixed site form work (steel chanel) laing and fixing of 125 micron thick polythene film wedges steel plates including levelling the form work as per drawing, spreading the concrete with sholves rackes, compacted using needle screed and plate vibrators and finished in continous operation including provision of conraction and expansion,construction joints, applying debonding strips, primer, sealent dowel bars, near approches to bridge / cukvert and construction joints admixtures as approved curing of concrete slab for 14 days. using curing compound ( where specified ) and water finishing to lines and grade as per drawing and technical specification clause 1501

Construction of Subgrade and Earthen Shoulders with approved material obtained from borrow pits with all lifts and leads, transporting to site, spreading, grading to required slope and compacted to meet requirement of Table 300.0 with lead upto 1000 m as per Technical Specification Clause 303.1