Kanniyakumari District Suchindrum Ayothidhasar Pandithar Parappuvilai Cremation shed Compound Wall

Amount

24W LED 4000K 2 x 2 Square Type Recessed Fitting with LED (PWD schedule of rate 2024-2025)

Supply and fixing of 4 way Horizontal Triple pole and neutral MCB sheet steel enclosure distribution board with double door (metal with 1 No. 32A 4P MCB switch is incoming and 12 Nos. 6A to 32A SP MCB as outgoing on wall with earth connection only. Higher end (SD-530)

Plastering in cement mortar 1:4 (one cement Four sand) using 12mm thick including cost and conveyance of all materials and labour charges etc, complete as per standard specification.

Painting two coats with ready mixed Plastic Emulsion Paint S.I.358 Plastic emulison paint of'approved quality and colour over a priming coat, including thorough scraping, clean removal of dirt, etc complete and including necessary plaster of paris, putty, wherever required including cost and conveyance of all materials etc.and all lobour charges etc.complete as per Standard specification and as directed by the departmental officers. TNBP No:66-A (Sl.No.358)

Plain cement concrete Using 1:4:8 mix ( One cement , four Sand and Eight aggregates) using 40 mm ISS HBG metal including cost and conveyance of all materials to work site and all labour charges for mixing, laying,consolidating and curing etc complete as per the standard specifications. TNDSS NO: 28 V, VI (S2) V,VI (S5A) VII

Plain Cement concrete 1:2:4 (one cement, two sand and four aggregates) using 20mm ISS HBG metal including cost of all materials and labour charges for mixing, laying, compacting and curing etc, complete as per standard specifications. TNDSS NO: 30 V,VI (S3) VII-3

Earthwork excavation in all soils and sub soils except hard rock requiring blasting with initial lead and lift including re-filling the sides of foundation in layer of 15 cm thick watering , ramming ,depositing the surplus earth in the premises as directed by departmental officers etc., complete as per SS 20 B TNDSS NO: 23&24VI (S2), VII 9,10

Brick work in cement mortar 1:5 mix using (One cement and five sand) using best quality of III class Country bricks of size (8 3/4"x4 1/4"x 2 3/4") for foundation including curing cost and conveyance of all materials to site and all labour charges etc., complete as per standard specification TNDSS specification No.31 & 31C

Supply and fixing of TNEB meter board suitable for 32A single phase service connection with 32A fuse unit (500V) 32A neutral link and earth link (1" x 1/8" copper flat) on TW plank of size 375mm x 300mm x 19mm with supporting TW reepers of 1" thick an either side with painting with suitable bolt and nuts for fixing the TW plank on wall with earth connection and interconnection with 7/20 PVC insulated copper wire from EB meter to fuse unit with 1 No 40Amp 30MA Double Pole RCD / RCCB (Lower End) with suitable necessary connection (SD-126)

Supplying and erecting steel centering for sides and soffits including supports and strutting upto 3.29 m height for plain surface as RCC slabs, rectangular tee (or) elbeams, lintel, bed block stair case waist slab, landing slab, etc., complete as per standard specification - 10m2 as per TNDSS & Morth specification No:30 & 36 (Plain surface)

Supplying and erecting steel centering for sides and soffits including supports and strutting upto 3.29 m height for plain surface as RCC slabs, rectangular tee (or) elbeams, lintel, bed block stair case waist slab, landing slab, etc., complete as per standard specification - 10m2 as per TNDSS & Morth specification No:30 & 36 (RCC work)

Reinforced cement concrete 1:11/2:3 (one cement one and half sand and three aggregate) using 20mm size I.S.S. metal including cost conveyance of materials to site and all labour charges etc., mixing laying consolidating curring etc., but excluding cost of steel etc., complete as per standard specification as per TNDSS NO: 30 V,VI (S3) VII-3

Supplying, fabricating and placing in position of mild steel or TMT rods, including cost of steel and binding wire and all labour charges for cutting, bending, tying and placing in position etc, complete as per SS. TNDSS NO: 97 V,VI (S6) VII (S6) VII-3

Hollow Block Brick Work in cement mortar 1:5mix including cost of all materials and labour charges etc complete as per SS.

Supply and fixing of mild steel grill works for gate, front Name board etc including redoxide priming coat and cost of materials and all labour charges etc. complete.

Earth work excavation and depositing on the bank with initial lead and lift of 10 metres and initial lift of 2 metres in hard stiff stiff clay stiff block cotton hard red earth murram, gravel stoney earth and earth mixed with small size boulders and hard gravelly soils (SS 20 B) etc., complete as per standard specification

Construction of Granular Sub-base by providing close graded material,mixing in a machanical mix plant at OMC,carriage of mixed material to work site,spreading in uniform layers with motor grader on prepared surface and compacting with vibratory power roller to acheive the desired density,Complete as per clause 401.

Providing and laying, spreading and compacting graded stone aggregates to Wet Mix Macadam 150 mm thick specification including premixing the materials with water at OMC in mechnanical mix plant carriage of mixed material by tipper to site laying in uniform layers with pavers in Sub Base/ Base course on well prepared surface and compacting with vibratory roller to acheive the desired density including cost of material, labour charges, rentals for machinery, fuel and all other incidental charges etc., complete as per clause 406 of MORTH Rev-5

Supplying and laying Cement concrete Rubber Moulded Hydraulic Pressed Paver Block M40 grade of 80mm thick high strength type confirming IS 15658-2007 of required size of minimum compressive strength of 40 N/mm2 in uniform shape of approved make to be laid in flurrying bone pattern with stone dust cushion 100mm thick laying out of pavement cut the pieces to fix the edge vibrating the pavers, sweeping, transporting loading and unloading of paver block as per the standard specification.

Special Ceiling Plastering with cm 1:3 mix (One Cement and Three Sand), 10mm thick including concrete surface cleaning, finishing, curing and all labour charges etc complete as per standard specification.

Granolithic Floor finishing with Cement Concrete 1:2:4 (One part of cement, two parts of sand and four parts of ISS HBG metal) mix using 10mm to 12mm ISS size HBG metal to 25mm thick including cost and conveyance of all materials etc.and all lobour charges etc.complete as per Standard specification and as directed by the departmental officers. TNBP No:39-F (20mm thick)

Paving the floor with Plain/Design Ceramic tiles ( Colour and shade as directed ) of Vitrified Tiles of size 600 x 600 x 8mm in all floors over a base layer of cm 1:3 mix 20mm thick laid in situ and pointed with same coloured cement ( white cement mixed with colouring pigment ) neatly and fixed in position so as to make it perfectly smooth and shining,to the alignment etc.complete complying with standared specifications and as directed by the departmental officers. The sample colour and shade of the ceramic tiles should be got approved from the departmental officers before use in the works

Painting two coats over new iron work with ready mixed paint of apprved quality and colour including cost of all materials and labour charges etc complete as per SS

Supply, collection and filling of Gravel from approved quarry including all cost and conveyance to site, stacking them on road side to departmental gauge for the take premeasurement. Each layer not more than 15cm thick and consolidation properly etc complete. TNDSS No : 301 & 305

Wiring with 2x1.5 sqmm PVC unsheathed Sc. Cu. conductor of 1100V grade in suitable PVC rigid pipe concealed in wall and ceiling with PVC accessories with TW switch box and 5A F.T. switch in fush with wall with 3mm thick hylum sheet cover for making good of the coneal3ed portion with suitable colour for PVC concealed light point (For electronic regulator). (SD 24)

Wiring with 2 x 1.5sqmm (22/0.3) PVC insulated SC unsheathed Cu. conductor of 1100 V grade in suitable PVC rigid pipe concealed in wall and ceiling with PVC accessories, in flush with wall, wtih 150mm x 100mm x 113mm TW switch box with 3 mm thick Hylem sheet cover for 5A 3 pin non inter locking CS Plug with continuous earth wire connection of 14 SWG TC wire and making good of the concealed portion with suitable colour for concealed PVC plug point. (SD 38)

Supply and fixing of single box type 4'40w flu fitting complete with copper choke and condensor with TW round blocks on wall or ceiling with flu tube with PVC unsheathed copper leads from terminals to the fitting.(SD.88)

Supply and fixing of WT bulk head fitting with guard suitable with 7W / 9W LED bulb (SD-84)

Y.BEBIN (BID ID -1123810)