COMPREHENSIVE MAINTENANCE OF SEWAGE LINE INCLUDING CLEANING OF MANHOLES AND SEPTIC TANKS ETC AND REPAIRS TO SEWAGE LINE IN ZONE B AREA UNDER GE M NAS ARAKKONAM

Amount

Comprehensive maintenance of sewage line, Manholes, of various diameter and depth and floor/Nahani gully traps water closet of various size in buildings located in for Married Accn Zone "B" area with the following :- (a) Cleaning and removal of blockage/clogging in sewer lines including rodding by manual / machineries. (b) -ditto- all as per item 1(a) above but in manholes. (c) -ditto- all as per item 1(a) above but in floor/Nahani/Gully traps. (d) Removal of blockage/clogging in all water closets. (e) Removal of sludge obtained from Item Ser No 1(a) to 1(d) above shall be taken as credit complete all as specified and as directed by Engineer-in-Charge. Notes : (i) The unit rate quoted by the tenderer is inclusive of requirement of number of persons for attending day to day maintenance of sewer lines and manholes etc. The requirement shall be assessed by the tenderer and accordingly the unit rates shall be arrived at. No extra cost whatsoever shall be admissible on this account. (iii) The contractor shall provide the sufficient labourers for the above works and they should report daily in the morning at 08.30 AM to AGE B/R - II of GE (M) NAS Arakkonam

All as per item No. 1 above but for OTM ACCN at Zone "B" area

Pumping out sludge including water from the soak pit/septic tank/Manholes depth more than 2 M at main sewage line (i.e) not covered under Item No.1. here-in-before etc. mechanically by using tipper with tanker and non clog sewage pump set arrangement including foot valve, necessary draining out pipe etc and removing all foreign materials, sludge, water including cleaning the soak pit/septic tank/manholes etc complete all as specified and directed by Engineer-in-Charge. Note : (a) The sludge removed shall be taken outside MD land for disposal as and when removed from the soak pit/septic tank/manholes. The cost of disposal shall be inclusive of the unit rate quoted by the tenderers under this item. No extra cost on this account is admissible. The credit offered by the department for the sludge removed shall be deducted from the payment made to the contractor for the entire quantity. (b) Pumping shall be carried out in the presence of MES authorises / representative.

Taking off existing manholes covers and cleaning of manholes of depth not exceeding 1 metre by de-watering and taking off the rubbish / sludge etc., removing the same up to 50 m distance and put into newly excavated pits of suitable size and covering with excavated earth and placing the removed covers back in position complete all as specified and directed.

All as per item No 4 as above but depth exceeding 1 metre and not exceeding 3 metre all as specified and directed by Engineer in charge.

All as per item No 4 as above but depth exceeding 3 metre and not exceeding 4.50 metre all as specified and directed by Engineer in charge.

Material and labour Cutting holes into or through brick walls built in cement mortar, and fixing PVC Heavy duty rungs with PCC 1:2:4 type B-1as holding vocrete block and making good disturbed surface to match the existing surface complete all as specified and directed by Engineer in charge.

Dismantling wrought iron or mild steel work of any description not otherwise provided for all as specified and as directed by the Engineer-in-Charge.

Supply and fixing for mild steel framed work such as grills, Angles, guard bars etc with ends of bars shouldered and/or riveted or forged into spikes framed guard bars and similar work conforming to Fe-290. Gde E-165 complete all as specified and as directed

Supply and fix for plates (plain or chequered) channels, square cut or notched (ordinary or counter sunk) forming holes includinjg MS butt hinges and handle, confirming Fe-290 (Gde E-165) complete all as specified and as directed

Excavation in trenches not exc. 1.50 m wide and not exc. 1.50 m in depth for foundation etc. or for manholes, cesspits, shafts etc not exceeding 10 Sqm on plan and getting out in soft/loose soil complete all as specified and directed

All as item No 10 above but depth exceeding 1.50 metre but not exceeding 3.00 metre and getting out in soft/loose soil complete all as specified and as directed

All as item No 10 above but depth exceeding 3 metre but not exceeding 4.50 metre and getting out in soft/loose soil complete all as specified and as directed

Returning, filling in, including spreading, leveling, watering and well ramming in layers not exceeding 25 cm thick in each layer as in soft / loose soil complete all as specified and directed

Removing surplus excavated material to distance not exc. 50 m and depositing where directed at a level not exceeding 1.50 m above the starting point complete all as specified and directed by Engineer in charge.

Demolition of brick work or stone/boulder masonry, built in cement mortar or cement lime mortar including all quoins, arches, pillars, etc but excluding ashlars facings dressed stone work and pre cast concrete articles complete all as specified and directed by Engineer in charge.

Material and labour for brick work with sub class ‘B’ old size bricks straight or curved on plan exc. 6.00 m mean radius built in cement mortar 1:4 complete all as specified and directed by Engineer in charge.

Material and labour for 15 mm thick rendering on fair faces of brick work or concrete surfaces with cement mortar 1:4 finished even and smooth without using extra cement complete all as specified and directed by Engineer in charge.

Demolition of reinforced cement concrete in ground floors and pavings n exc 15cm thickness including cutting of reinforcement bars to facilitate demolition complete all as specified and directed by Engineer in charge.

Material and labour for providing pre-cast cement concrete as in cover slabs for manholes and similar items with plain faces in cement concrete 1:2:4 type B-1, using 20 mm graded crushed stone aggregate and setting in cement mortar 1:6 including necessary form work complete all as specified and directed .

Material and labour for mild steel TMT bars 10 mm dia and over cut to length, bent to shape required including cranking, bending spirally for hooping for columns and binding with and including mild steel wire (annealed) not less than 0.9 mm dia or securing with clips complete all as specified and directed

Material and labour for mild steel TMT bars 6 to 8 mm dia, cut to length, bent to shape required including cranking, bending spirally for hooping for columns and binding with and including mild steel wire (annealed) not less than 0.9 mm dia or securing with clips complete all as specified and directed by Engineer in charge.

Demolition of cement concrete (unreinforced) of any description in bed concrete not exceeding 15 cm thick below ground level complete all as specified by Engineer in charge.

Material and labour for providing plain cement concrete, type D-2, 1:4:8 (using 40 mm graded crushed stone aggregate) as in sub base of floor, foundation, filling and mass concrete complete all as specified and directed

Material and labour for plain cement concrete 1:2:4 type B1 using 20 mm graded stone aggregate as in surface channels and drains all as specified and directed

Extra for forming fair finished drain or channel 45cm inner girth in cement concrete, using extra cement, including forms, moulds, mitred/stopped ends etc completeall as specified and directed by Engineer in charge.

Material and labour for PCC 1:3:6 type C1 using 20 mm graded stone aggregate as in coping including necessary form work etc. complete all as specified and directed by Engineer in charge.

Demolition and breaking up drain pipes internal dia of pipe in 150mm (salt glazed ware, AC or reinforced concrete ) set in cement mortar complete all as specified and directed by Engineer in charge.

Demolition and breaking up drain pipes internal dia of pipe in 200mm (salt glazed ware, AC or reinforced concrete ) set in cement mortar complete all as specified and directed by Engineer in charge.

Demolition and breaking up drain pipes internal dia of pipe in 300mm (salt glazed ware, AC or reinforced concrete ) set in cement mortar complete all as specified and directed by Engineer in charge.

Material and labour for reinforced concrete pipes 300mm dia class NP-2 for following dia of pipe laid and jointed complete with collars complete all as specified and directed by Engineer in charge.

Material and labour for cement concrete 1:3:6, type C-2 (using 40 mm graded crushed stone aggregate) for 300mm pipe concrete bed to drain pipes of including packing under and haunching against the sides of pipe after they are laid and tested including necessary form work complete all as specified and directed

Material and labour for cutting into existing manhole for connecting new drain, making good to pipe and rendering, cutting out existing benching for and forming branch channel (½ round or ¾ section) in cement concrete 1:2:4 type B-1 smooth finished, and reforming benching as required for 200 mm dia pipe complete all as specified and directed by Engineer in charge.

All as per item No. 33 above but for 300mm internal dia pipes

Supply and fix PVC under drain pipe 200mm dia single socketed, in any length with rubber ring joints, laid in trenches or in floor pressure rate 6 Kg/cm 2 (class 3 pipe) complete all as specified and directed by Engineer in charge.

All as per item No. 35 above but for 300mm internal dia pipes

Material and labour for "M" sand filling in trenches as a cushioning/bedding and haunching to PVC pipe including watering complete all as specified all as specified and directed by Engineer in charge.

Taking down soil / waste and rainwater pipes (any size or pattern) including all fittings and cleaning complete all as specified and directed by Engineer in charge.

Supply and fix 75 mm bore PVC (SWR) pipes single socketed, in any length with rubber ring joints fixed to walls complete all as specified and directed by Engineer in charge.

Supply and fix 110 mm dia bore PVC (SWR) pipes single socketed, in any length with rubber ring joints fixed to walls complete all as specified and directed by Engineer in charge.

Supply and fix 75 mm bore PVC (SWR) bends with access door complete all as specified and directed by Engineer in charge.

Supply and fix 75 mm dia bore PVC (SWR) branch piece,single (single Y) equal or unequal with access door complete all as specified and directed by Engineer in charge.

Supply and fix 75 mm dia bore PVC (SWR) branch piece,double (double Y) equal or unequal with access door complete all as specified and directed by Engineer in charge.

Supply and fix 75 mm dia bore PVC (SWR) junction single,(single T) equal or un equal with access door complete all as specified and directed by Engineer in charge.

Supply and fix 75 mm dia bore PVC (SWR) vent cowl complete all as specified and directed by Engineer in charge.

Supply and fix 110 mm dia bore PVC (SWR) bends any radius with access door complete all as specified and directed by Engineer in charge.

Supply and fix 110 mm dia bore PVC (SWR) branch piece, single (single Y) equal or un equal with access door complete all as specified and directed by Engineer in charge.

Supply and fix 110 mm dia bore PVC (SWR) branch piece, double (double Y) equal or un equal with access door.

Supply and fix 110 mm dia bore PVC (SWR) junction single, (single T) equal or un equal with access door.

Supply and fix 110 mm dia bore PVC (SWR) vent cowl

Supply and fix in repairs clamp out of 50mm by 5mm flat iron and 16 mm dia round iron stay, including bolts and nuts and securing ends of stay to wall or roof for 110 mm bore cast iron/ PVC pipe including dismantling complete all as specified and as directed by Engr-in-charge.

All as per item No. 51 above but for 75mm dia pipes

Supply and fix in repairs PTMT grating doom 100mm dia (Min weight 25gms) complete all as specified and as directed. Make Prayag/Parryware/Johnson/ Kohler/Marc

Supply and fix in repairs PTMT grating doom 75mm dia (Min weight 25gms) complete all as specified and as directed. Make Prayag/Parryware/Johnson/ Kohler/Marc

Supply and fix in repairs flexible PVC waste pipe suitable for wash hand basin and Kitchen Sink all as specified and as directed

Supply and fix in repairs stainless steel grating doom 100mm dia complete all as specified and as directed. Make Prayag/Parryware/Johnson/ Kohler/Marc

Demolition of stone slabs and tiles of any description or thickness in floors aprons etc laid bedded and pointed in any mortar complete all as specified and as directed.

Supply and fix in repairs plastic water closet seat, black, closed pattern with flat bottom, and cover and mild steel chromium plated or aluminium hinging device complete all as specified and as directed.

M/ L joint free non skid ceramic colour tiles 7 to 8mm thick (square / rectangular) area of each tile exc 0.11 Sqm but N. exc 0.18 Sqm in floors set and jointed in neat cement slurry and pointed in white cement to match the tile including screed bed in CM 1:4 , 15mm thick complete all as specified and as directed.

Material and labour for PVC (SWR ) floor trap 75mm plain with grating including jointing with solvent cement complete all as specified and as directed.

S MARI CONTRACTOR

KRISHNA STRUCTURES

C SRINIVASAN

RK CONSTRUCTION

SIVA ENTERPRISES

Green Ray Technologies